Mathematical modeling of crystallization analysis fractionation (Crystaf) of polyethylene

Four polyethylene samples (PE) with different molecular weight distributions (MWD) were analyzed by crystallization analysis fractionation (Crystaf) at several cooling rates to investigate the effect of MWD and cooling rate on their Crystaf profiles. Using these results, we developed a mathematical model for Crystaf that considers crystallization kinetic effects, which are ignored in all previous Crystaf models. The Crystaf model we proposed can fit the experimental Crystaf profiles of the 4 polyethylene resins very well. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 2749–2759, 2006     

Nd掺杂的Bi4Ti3O12变温X射线衍射分析

利用变温X射线衍射技术，在预烧过程中分析了Nd掺杂Bi4Ti3O12后生成Bi3.15Nd0.85Ti3O12（BNT）相的形成过程以及微结构的变化．实验观察到以30℃／min的升温速率，BNT相在700℃时开始形成，其衍射峰强度随温度的继续升高而增强，衍射峰半高宽随烧结时间延长而减小．X射线衍射分析结果表明，在900℃恒温条件下，烧结约2h，可形成单一的BNT相．     

Modification of a three-way catalyst washcoat by aging: A study along the longitudinal axis

This work reports the research carried out by studying aliquots extracted at different axial coordinates from Three Way Catalyst (TWC) monoliths aged under real traffic conditions. Our study focused on the catalytic properties and on several chemical and physical effects caused in the Front and Rear monolith washcoat surfaces by vehicle aging after 60,000 km. Regarding the catalytic properties, all the used aliquots showed poorer activity than their corresponding fresh counterparts. The strongest deactivation was detected for NO and hydrocarbon conversion. CO conversion was less affected and the Rear monolith was as deactivated as the Front one. The characterisation techniques (TXRF, N₂ adsorption-desorption isotherms, XRD and H₂-TPR) detected - (i) the deposition of P, Zn and Pb; (ii) the formation of CePO₄ on account of the Ce from the washcoat; (iii) thermal sintering; (iv) inhibition of the reducibility of Ce oxides - as the main effects brought about by vehicle aging conditions. The deactivation observed at the beginning of the Front monolith was the result of a combination of the former effects. When moving downstream to higher axial coordinates, Pb accumulation and the loss of specific area appeared to be the only probable sources of deactivation.     

Computation of moisture and temperature profiles in soil—The coupled model

The coupled model has been developed in this study for moisture transport and beat exchange in soil. The model is driven by atmospheric conditions measured in a field. The concept that soil has a surface resistance to evaporation is introduced in order to relate the evaporation from surface with the vapour flux in air. With the use of this concept, the simulation results agree quite well with the measured data.     

Observation of inter-grain Josephson effects in Y-Ba-Cu-O samples

Josephson effects have been observed in bulk samples of Y-Ba-Cu-O. The magnitude of the zero-voltage current is found to change systematically with externally applied small magnetic fields of a few mG. It is also found to vary when samples are irradiated with microwaves. These observations suggest the presence of inter-grain Josephson junctions.     

回收碘的研究

主要介绍了磷化工厂含碘烟气中碘元素通过富集，沉淀回收的方法。对碘的回收的影响因素很多，主要讨论温度、pH值、沉淀剂的种类与碘回收的关系，并且通过实验找出最佳的工艺参数并确定经济合理、适用性广的工艺流程。     

Topological order in the phase diagram for high-temperature superconductors with point defects

Applying a Lindemann like criterion obtained previously by Kierfeld et al. [J. Kierfeld, T. Nattermann, T. Hwa, Phys. Rev. B 55 (1997) 626], we estimate the magnetic field and temperature for a high-T_c superconductor, at which a topologically ordered vortex glass phase becomes unstable with respect to a disorder-induced formation of dislocations. The employed criterion is shown to be equivalent to a conventional phenomenological Lindemann criterion including the values for the numerical factors, i.e., for the Lindemann number. The positional correlation length of the topologically ordered vortex glass is calculated.     

智能化44点啤酒发酵温度巡测仪

本文将八十年代最新研制的集成温度传感器ＡＤ５９０、８０９０单片机，可编程逻辑器件ＧＡＬ－１６Ｖ８Ａ等新器件及智能化新技术，集中应用于啤酒发酵过程的温度检测。与传统人工测温相比，具有测温精度高、稳定性好、反应快、可远距离自动检测、定时打印，减轻工人劳动强度、调节啤酒发酵温度的响应速度快等特点。     

A fixed-point equation for the high-temperature phase of discrete lattice spin systems

A fixed-point equation on an infinite-dimensional space is proposed as an alternative to the usual definition of the infinite-volume limit in discrete lattice spin systems in the high-temperature phase. It is argued heuristically that the free energy and correlation functions one obtains by solving this equation agree with the usual definitions of these quantities. A theorem is then proved that says that if a certain finite-volume condition is satisfied, then this fixed-point equation has a solution and the resulting free energy is analytic in the parameters in the Hamiltonian. For particular values of the temperature this finite-volume condition may be checked with the help of a computer. The two-dimensional Ising model is considered as a test case, and it is shown that the finite-volume condition is satisfied for0.77 _critical.     

切削刀具倒棱刃口挤压力的理论计算

根据试验观察．揭出了刀具刃口带负倒棱时的切削模型。在此模型中,刀具刃口 存在一个“金属死区”。以新模型为基础．采用能量法,对高温、高应变率下刀具刃 口的挤压力进行了理论计算。所做工作的特点是：１）在材料变形分析中计入了挤压 层金属绕过刀具刃口时的过剩变形;２）进行有关材料变形与物理特性的计算时,考 虑了温度与应变率的影响。利用新研制的压电式切削测力仪进行验证试验,其结果表 明,理论计算值与实测数据较好一致。