Synthesis and characterization of poly(ethylene oxide‐co‐ethylene carbonate) macromonomers and their use in the preparation of crosslinked polymer electrolytes

Methacrylate‐functionalized poly(ethylene oxide‐co‐ethylene carbonate) macromonomers were prepared in two steps by the anionic ring‐opening polymerization of ethylene carbonate at 180 °C, with potassium methoxide as the initiator, followed by the reaction of the terminal hydroxyl groups of the polymers with methacryloyl chloride. The molecular weight of the polymer went through a maximum after approximately 45 min of polymerization, and the content of ethylene carbonate units in the polymer decreased with the reaction time. A polymer having a number‐average molecular weight of 2650 g mol^?1 and an ethylene carbonate content of 28 mol % was selected and used to prepare a macromonomer, which was subsequently polymerized by UV irradiation in the presence of different concentrations of lithium bis(trifluoromethanesulfonyl)imide salt. The resulting self‐supportive crosslinked polymer electrolyte membranes reached ionic conductivities of 6.3 × 10^?6 S cm^?1 at 20 °C. The coordination of the lithium ions by both the ether and carbonate oxygens in the polymer structure was indicated by Fourier transform infrared spectroscopy. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2195–2205, 2006     

Assessment of filtered gas–solid momentum transfer models via a linear wave propagation speed test

The propagation speeds of linear waves in gas–solid suspensions depend strongly on the solids volume fraction and the wave frequency. The latter is due to gas–solid momentum transfer and allows a simple test on filtered gas–solid momentum transfer models. Such models may predict linear wave propagation speeds different from those obtained with the non-filtered model at wave frequencies higher than the filter frequency, but not at wave frequencies lower than the filter frequency.     

Nd掺杂的Bi4Ti3O12变温X射线衍射分析

利用变温X射线衍射技术，在预烧过程中分析了Nd掺杂Bi4Ti3O12后生成Bi3.15Nd0.85Ti3O12（BNT）相的形成过程以及微结构的变化．实验观察到以30℃／min的升温速率，BNT相在700℃时开始形成，其衍射峰强度随温度的继续升高而增强，衍射峰半高宽随烧结时间延长而减小．X射线衍射分析结果表明，在900℃恒温条件下，烧结约2h，可形成单一的BNT相．     

Pulsed pump: Thermal effects in solid state lasers under super-Gaussian pulses

Solid state laser (SSL) powers can be realistically scaled when pumped by a real, efficient and multimode pulse. In this work, a fourth-order super-Gaussian pulse was assumed as a pump for SSL’s and a complete analytical expression for the thermal phase shift is given. Moreover, the focal length of thermal lens in paraxial ray approximation regime was studied. The results when applied to a Ti: sapphire crystal show an appreciable correction for abberation compared to a top-hat pulse.     

宪法理论基础简论

宪法理论基础是宪法理论和实践的基本理念。近代人民在革命斗争中，认识到国家权力最容易侵犯人的权利，因此人们用宪法严格限制国家权力。但随着社会的发展，社会需要国家干预，人的积极性权利也需要国家创造条件，国家权力迅速膨胀。传统严格限权模式不再适用社会需要，现代社会既需要授予国家权力，又需要控制国家权力。     

模糊神经网络在复合地基沉降量预测中的应用

复合地基后期沉降变形对于建筑物设计及安全具有重要意义,针对通过长期沉降观测以得到复合地基的最终沉降需要耗费较多资源的问题,提出了一种基于模糊神经网络的预测方法.该方法考虑沉降变化过程有较大的随机性和模糊性,直接将样本数据进行模糊化,所得的模糊数代表了样本点集与控制点集中各分量之间的相关度,并依此建立模糊BP神经网络进行学习和估算.实验结果表明了该方法对沉降进行预测是可行与有效的,且在相对误差的有效控制方面优于BP网络方法与灰色方法.     

模型试验基础边界模拟研究

为提高结构模型试验精度,减小通常模型基础偏小的影响,提出了调整模型基础边 界弹模的办法以“延长”模型边界,应用于某水电站拦河坝整体光弹试验后,取得了较 好的结果。     

LiCoO2中锂离子固相扩散系数随循环次数的变化

The solid diffusion coefficient of lithium-ion in LiCoO₂ cathode material has been investigated by the capacity intermittent titration technique (CITT) at different voltages and at different charge/discharge cycles. By SEM, XRD and FTIR techniques, the structure of LiCoO₂ was studied before and after charge-discharge cycles, and the relationship between solid diffusion coefficient and crystal structure was further discussed. CITT results show that the value of Li⁺ solid diffusion coefficient of LiCoO₂ is about 10^-12 cm²·s^-1. During the whole charge-discharge cycles, the Li⁺ solid diffusion coefficient decreased within the voltage of 4.0～4.3 V, which is attributed to the change of the structure of LiCoO₂.