饱和状态下水泥浆体的微观结构冰冻损伤模型

为了研究水转化为冰所带来的体积膨胀对水泥浆体的微观结构的危害,量化微观结构的内部损伤,建立了一个饱水状态下水泥浆体的冰冻破坏模型.首先使用模拟水泥浆体微观结构的数值模型(HYMOSTRUC)生成一个模拟结构,根据这个模拟结构中的孔结构,分析水分在孔隙中发生的相转变;将含有冰、水和水化产物的水泥浆体微观模拟结构转变为三维...     

n型IBC太阳电池选择性发射极工艺研究

为提升n型叉指背接触(IBC)太阳电池的光电转换效率,采用丝网印刷硼浆和高温扩散的方式形成选择性发射极结构,研究了硼扩散和硼浆印刷工艺对电池发射极钝化性能和接触性能的影响。实验结果表明,在硼扩散沉积时间和退火时间一定的条件下,硼扩散通源(BBr₃)流量为100 mL/min,沉积温度为830 ℃,退火温度为920 ℃时,发射极轻掺杂(p⁺)区域的隐开路电压达到710 mV,暗饱和电流密度为12.2 fA/cm²。发射极局部印刷硼浆湿重为220 mg时,经过高温硼扩散退火,重掺杂(p⁺⁺)区域的隐开路电压保持在683 mV左右,该区域方块电阻仅46 Ω/□,金属接触电阻为2.3 mΩ·cm². 采用该工艺方案制备的IBC电池最高光电转换效率达到24.40%,平均光电转换效率达到24.32%,相比现有IBC电池转换效率提升了0.28个百分点。     

水性颜料体系无树脂色浆的制备与应用

中性墨水属于热力学上不稳定的颜料悬浮体系,选择低黏度、高稳定性的色浆是保证墨水体系分散稳定性的重要手段之一.基于此,以颜料炭黑和酞菁蓝为着色剂,配合超分散剂(EK43)与协同增效剂(BM10),制备了两款适用于中性墨水体系的无树脂色浆.首次从色浆粒径与体系分散稳定性角度出发,确定了EK43、BM10用量以及最佳研磨时间...     

Analytical Performance of Clay Paste Electrode and Graphene Paste Electrode-Comparative Study

The analytical performance of the clay paste electrode and graphene paste electrode was compared using square wave voltammetry (SWV) and cyclic voltammetry (CV). The comparison was made on the basis of a paracetamol (PA) determination on both working electrodes. The influence of pH and SWV parameters was investigated. The linear concentration ranges were found to be 6.0 × 10⁻⁷–3.0 × 10⁻⁵ and 2.0 × 10⁻⁶–8.0 × 10⁻⁵ mol L⁻¹ for clay paste electrode (ClPE) and graphene paste electrode (GrPE), respectively. The detection and quantification limits were calculated as 1.4 × 10⁻⁷ and 4.7 ×10⁻⁷ mol L⁻¹ for ClPE and 3.7 × 10⁻⁷ and 1.2 × 10⁻⁶ mol L⁻¹ for GrPE, respectively. Developed methods were successfully applied to pharmaceutical formulations analyses. Scanning electron microscopy and energy-dispersive X-ray spectroscopy were used to characterize ClPE and GrPE surfaces. Clay composition was examined with wavelength dispersive X-ray (WDXRF).     

ssDNA/十八酸修饰碳糊电极的制备及伏安法表征

将石墨粉与十八酸在80 ℃下混合制成表面富含—COOH的基底碳糊电极(SA/CPE), 然后在活化剂N-羟基琥珀酰亚胺(NHS)和1-乙基-3-(3-二甲基氨丙基)碳二亚胺盐酸盐(EDC)存在下将ssDNA固定到电极表面制备ssDNA修饰电极(ssDNA/SA/CPE). 以亚甲基蓝(MB)为指示剂, 用循环伏安法对SA/CPE和ssDNA/SA/CPE进行电化学表征, 发现其在ssDNA/SA/CPE上较在SA/CPE上的氧化峰电流(i_pa)和还原峰电流(i_pc)分别增大1.9倍和1.7倍, 式电势(E_f)负移8 mV. 把ssDNA/SA/CPE放在互补ssDNA溶液中杂交后, MB的i_pa 和i_pc较在SA/CPE上分别增大1.0倍和0.8倍, E_f负移18 mV. 用0.5 mol/L 的NaOH溶液冲洗使电极表面杂交而成的dsDNA变性洗脱, MB的伏安信号几乎与在ssDNA/SA/CPE上一样. i_pc与SA/CPE上固定的ssDNA质量在1.0×10^－7～5.0×10^－6 g范围内成线性关系, 检测限为2.0×10^－9 g (S/N＝3). 这种既廉价又灵敏的电化学生物传感器有望在转基因植物产品检测研究中得到应用.     

炭糊电极电位法测定痕量银

炭糊电位广泛应用于伏安法的测定,特别是修饰的炭糊电极,对于提高灵敏度和选择性具有极大的潜力,我们首次应用炭糊电极作为银离子的电位传感器,发现其具有制作方便、灵敏度高以及采用适当的掩蔽措施可得到较好的选择性等优点。 1 实验部分 1.1 仪器和试剂 pHS-10A数字酸度/离子计(萧山市科学仪器厂),pHS-2型酸度计(上海第二分析仪器厂).314 S~(2-)离子选择电极(江苏电分析仪器厂)。     

土豆汁修饰碳糊电极测定色氨酸的研究

本提出了用于测定色氨酸的土豆汁修饰碳糊电极，该电极选择性好，能有效地消除酪氨酸的干扰，在ｐＨ＝７．４的ＮａＨ２ＰＯ４－ＮａＯＨ生理缓冲液中，电极响应与色氨酸在９．８×１０＾－６～９．８×１０＾－５ｍｏｌ／Ｌ的浓度范围内呈线性关系，最低检出限是１．５×１０＾－６ｍｏｌ／Ｌ．并详细讨论了电极抗干扰能力与测定条件的关系。用该电极测定了实际样品氨基酸注射液中色氨酸的含量，结果与标准值吻合。     

Electrochemical Behaviors of Adenosine‐5′‐triphosphate on Molecular Wire Modified Carbon Paste Electrode and Its Sensitive Detection

A new electrochemical method was proposed for the determination of adenosine‐5′‐triphosphate (ATP) based on the electrooxidation at a molecular wire (MW) modified carbon paste electrode (CPE), which was fabricated with diphenylacetylene (DPA) as the binder. A single well‐defined irreversible oxidation peak of ATP appeared on MW‐CPE with adsorption‐controlled process and enhanced electrochemical response in a pH 3.0 Britton‐Robinson buffer solution, which was due to the presence of high conductive DPA in the electrode. The electrochemical parameters of ATP were calculated with the electron transfer coefficient (α) as 0.54, the electron transfer number (n) as 1.9, the apparent heterogeneous electron transfer rate constant (k_s) as 2.67 × 10^?5 s^?1 and the surface coverage (Γ_T) as 4.15 × 10^?10 mol cm^?2. Under the selected conditions the oxidation peak current was proportional to ATP concentration in the range from 1.0 × 10^?7 mol L^?1 to 2.0 × 10^?3 mol L^?1 with the detection limit as 1.28 × 10^?8 mol L^?1 (3σ) by sensitive differential pulse voltammetry. The proposed method showed good selectivity without the interferences of coexisting substances and was successful applied to the ATP injection samples detection.     

用混合粘合剂修饰的碳糊电极测定诺氟沙星

在pH10.50的磷酸盐缓冲溶液中 ,当含有0.8mmol/L的NH4Cl,8mg/L的SLS(十二烷基磺酸钠)时 ,诺氟沙星在由69.1% (w)的石墨粉、24.5 % (w)的液体石蜡和6.4 % (w)的甘油组成的混合粘合剂碳糊电极上产生一灵敏的阴极溶出还原峰 ,峰电位为 -1.61V ;峰电流与诺氟沙星浓度在8.0×10 -9～4.0×10 -7mol/L范围内呈良好的线性关系 ,相关系数为r=0.9949 ,检出限为3.0×10-9 mol/L ;该法用于测定诺氟沙星胶囊含量 ,结果令人满意     

“金属的电化学腐蚀”教学设计创新

以学科理解为基础,注重创设真实的教学情境,创新实验设计,使学生在探究暖贴发热原理和钢铁腐蚀原理的过程中获得金属电化学腐蚀的知识,拓展认知结构,学习科学方法,发展科学探究能力。