偏滤器靶板磁预鞘层边界的离子流

利用流体力学模型研究了偏滤器等离子体条件下磁预鞘层边界离子流和预鞘层宽度之间的关系，并分析了粒子碰撞对预鞘层边界离子流的影响。由于粒子碰撞对离子的驱动效益，预鞘层边界离子流速度随着预鞘层宽度的增加而减少；只有当预鞘层宽度趋于零时，边界离子流沿磁力线的速度才趋近于离子声速。在固定预鞘层宽度的条件下，计算了预鞘层边界离子流速度与碰撞频率之间的函数关系。     

水切割机中超高压预应力复合缸体研究

针对水切割机中高压缸经常爆裂的现象,本文研究了预应力缸体、高压缸的失效原因及预应力缸体的基本特点,最后进行了缸体疲劳实验。     

Load-Carrying Capacity of Circular Plates Made of a Fiber-Reinforced Composite

The load-carrying capacity of circular plates made of a fiber-reinforced composite and loaded with axisymmetric transverse forces under axisymmetric boundary conditions is investigated. The plates can be freely supported or clamped along their contour. To the known yield condition used, in the plane of main bending moments, there correspond irregular hexagons, which depend on the mechanical properties of composite constituents and some characteristic geometrical parameters. It is shown that, depending on the ratio of ultimate radial and circumferential bending moments, in the plastic state, the circular plates (the central part of the clamped plates) take the form of a cone or a frustum of cone. For each of the cases, the limit load is found, which is a function of the above-mentioned mechanical parameters. The statically allowable fields of bending moments and the corresponding allowable fields of deflection rates are determined. The solutions found are exact. Special cases for the freely supported plates are analyzed, and the results obtained are presented in the form of graphs.__________Translated from Mekhanika Kompozitnykh Materialov, Vol. 41, No. 2, pp. 177–192, March–April, 2005.     

吴消元法在精确求解电力系统潮流方程中的应用

应用吴消元法求得算例系统潮流方程的全部精确解，得到了其他方法难以得到的完整的Py、Qy曲线，包括低压运行曲线，并通过平衡点稳定性分析，得到节点电压状态参数空间中平衡点稳定与不稳定的区域分界．阐述了系统受大扰动后过渡到低电压运行状态的可行性，为电压失稳机理的探明提供了依据．     

轴流泵端壁区域流动三维粘性数值计算

本文采用通用流场分析软件FLUENT,基于N-S方程,选用RNG κ—ε湍流模型与SIMPLEC算法,对轴流泵叶轮内部(及端壁间隙)流动进行了三维粘性数值计算。通过实验验证,表明数值计算结果和实测数据吻合较好。详细分析了叶顶附近流场形态以及叶轮出口轴向、周向速度分布,进行了性能预估。并给出了实验装置图。     

带电粒子作同频旋转振动的辐射

根据振动电偶极矩产生的辐射场的矢势,导出带电粒子作同频旋转振动的辐射,并讨论其辐射的特点.     

多排叶片内部流动以及叶片排与排气系统相互作用研究

本文采用高分辨率格式和多块多网格方法求解雷诺平均Navier-Stokes方程,数值模拟多排叶片内的三维粘性流动;使用数值激盘模拟叶片排的存在,研究叶片排与非轴对称排气部件之间的相互作用以及复杂的内部流动。文中描述了数值方法,给出了NASA透平导叶和单级透平内部流场的数值结果及其与相应实验结果的对比,也给出了多级透平内部流场的数值结果,以及透平与排气部件之间的耦合流场的结果。     

大兴井田4#煤层砂岩砾岩体特征及成因分析

运用沉积学理论,通过对铁法煤田大兴井田4#煤层中发育的砂岩、砾岩体的研究,指出它们均为河道沉积产物,并从中识别出了聚煤早期河道正常沉积、聚煤期后河道水携物与坍塌物混积和河道泥石流沉积三种成因类型,论述了它们各自的岩相和空间发育特征,这将有益于揭示其平面分布规律,为进一步指导采场的科学设计和修订提供了基础.     

Homogenization of two-phase flow: high contrast of phase permeabilityHomogénéisation d'écoulement diphasique : grand contraste de perméabilité d'une phase

The steady-state two-phase flow non-linear equation is considered in the case when one of phases has low effective permeability in some periodic set, while on the complementary set it is high; the second phase has no contrast of permeabilities in different zones. A homogenization procedure gives the homogenized model with macroscopic effective permeability of the second phase depending on the gradient and on the second order derivatives of the macroscopic pressure of the first phase. This effect cannot be obtained by classical (one small parameter) homogenization. To cite this article: G.P. Panasenko, G. Virnovsky, C. R. Mecanique 331 (2003).     

Finite element computations of two-dimensional arterial flow in the presence of a transverse magnetic field

A finite element solution of the Navier-Stokes equations for steady flow under the magnetic effect through a double-branched two-dimensional section of a three-dimensional model of the canine aorta is discussed. The numerical scheme involves transforming the physical co-ordinates to a curvilinear boundary-fitted co-ordinate system. The shear stress at the wall is calculated for a Reynolds number of 1000 with the branch-to-main aortic flow rate ratio as a parameter. The results are compared with earlier works involving experimental data and found to be in reasonable qualitative agreement. The steady flow, shear stress and branch flow under the effect of a magnetic field have been discussed in detail.