用于VLSI的新型介质膜界面陷阱的特征

采用雪崩热电子注入技术和高频Ｃ－Ｖ准静态Ｃ－Ｖ特性测试,研究了新型快速热氮化的ＳｉＯｘＮｙ介质膜界面陷阱的特征,侧重于研究界面陷阱的特性与分布。结果表明：这种ＳｉＯｘＮｙ薄膜禁带中央界面陷阱密度随氮化时间的分布变化呈现”回转效应“,且存在着不同类型、密度悬殊很大的电子陷阱、指出雪崩热电子注入过程中在Ｓｉ／ＳｉＯｘＮｙ界面上产生两种性质不同的快界面态陷阱;给出了这两种界面态陷阱密度在禁带中能量的分布     

Quantitative determination of chloride by means of flow injection analysis with spectrophotometric detection in the UV/VIS range

Chloride is determined indirectly by Spectrophotometric flow injection analysis. Two systems are compared, both based on the principle of ion exchange of easily detectable anions versus chloride from suitable mercury salts. The first method is based on the exchange of chloride with chloranilate which is detected at 332 nm or at 306 nm in neutral or in acidic medium respectively. In the second case, chloride reacts with Hg(SCN)₂. The liberated thiocyanate forms a strongly coloured complex with Fe(III) in acidic solution with an absorption maximum at 460 nm. Both methods have a detection limit of about 5 mol Cl^–/l (175 ng/ml). In the case of the thiocyanate method, the relative standard deviation is about 2% (7 measurements) in the range of 5 to 150 mol/l and decreases significantly to a value of approximately 0.2% at higher concentrations; for the chloranilate method it is 10% for lower and about 1% for higher concentrations respectively.     

车用发动机高压电控喷油器的开发研究

以提高大功率车用发动机的动力性,经济性和排放性能为目的,对电控高压喷油器进行开发设计和实验研究,采用中压油源,由系统内部增压器来产生理想喷射所需的高压;通过蓄压装置和高速电磁开关阀控制喷油正时。结果 实验表明：最高喷油压力达１２４ＭＰａ,喷油规律的控制不受发动机转速影响,在系统结构和供油压力确定不变的条件下,完全由高速电磁开关阀的控制信号决定。     

流动注射分光光度法测定水中痕量正磷酸盐

在一定酸度条件下,甲基绿与磷钼杂多酸在水相所形成的离子缔和物于６６５ｎｍ处有一最大吸收峰,而试剂空白的最大吸收在６３０ｎｍ左右。     

摩擦和传热联合作用下等截面喷枪内气体的流动特性——(Ⅰ)基本方程及计算程式

基于可压缩流体动力学和热力学及传热原理,导出了表征摩擦和热源联合作用下管式和套管式等截面喷枪内气体流动特性的基本方程和计算公式;对18t AOD炉用套管式喷枪内的气体流动,较合理地确定了喷枪内壁温度和气体滞止温度沿管长的分布,以及吹炼过程中喷枪的摩擦系数;给出了不同流态下喷枪内气体流动特性的计算程式.     

流动注射小柱预富集—石墨炉原子吸收联用分析茶汤和水样中不同形态的铝

将装有８－羟基喹啉修饰的玻璃小珠或ＸＡＤ－２聚合物小球的微型富集分离柱接入流动注射－石墨炉原子吸收联用系统,分析茶汤和水样中不同形态的铝．选择不同的富集分离条件,样品中的铝可被分为与８－羟基喹啉快速络合的无机态铝、有机疏水态铝和总铝等几个种类,并比较和讨论实验结果．     

利用真实砂岩微观孔隙模型研究粘性不稳定指进

利用真实砂岩微观孔隙模型进行了不同油水粘度比下的油水两相驱替试验,研究了粘性不稳定指进;提出了控制注入水粘性指进的注入速度及油水粘度比的要求,对指导油田生产有一定的意义。     

Flow injection analysis of potassium using an all-solid-state potassium-selective electrode as a detector

The concentration of potassium was determined by a combination of flow injection analysis (FIA) with an all-solid-state potassium sensor detection. The all-solid-state potassium-selective electrode possessing long-term potential stability was fabricated by coating an electroactive polypyrrole/poly(4-styrenesulfonate) film electrode with a plasticized poly(vinyl chloride) membrane containing valinomycin. The simple FIA system developed in this laboratory demonstrated sensitivity identical to that in the batch system and achieved considerably rapid assay (150 samples h⁻¹). Analyses of soy sauce and control serum samples by this FIA system yielded results in good agreement with those obtained by conventional measurements.     

Flow injection manifolds for liquid-liquid extraction without phase separation assisted by ultrasound

Flow injection (FI) manifolds based on iterative change of the flow direction have been designed to study the influence of auxiliary energy on continuous liquid-liquid extraction without phase separation and compare it with the non-assisted process in a single experiment. In order to demonstrate the utility of ultrasounds as auxiliary energy for the extraction of polyphenols from an organic phase, the approach has been applied to samples of extra virgin olive oil, using an alkaline aqueous phase as extractant and subsequent derivatization with the Folin-Ciocalteu reagent. The proposed method provides results similar to those from the official method-recoveries between 97 and 100%. The sensitivity of the proposed method is 3.5 times higher than that of the non-ultrasound-assisted method. The precision, expressed as relative standard deviation (R.S.D.) for n=5, was within 1-5% and the relative errors for the irradiated and non-irradiated method were within 3 and 5%, respectively. The repeatability and within-laboratory reproducibility, studied at two concentration levels (379 and 813 μg ml⁻¹) ranged between 0.7-4.4% and 0.6-4.8%, respectively. The proposed manifolds can also be applied to either other type of auxiliary energies—microwave, thermal—or two different types of auxiliary energies at the same time.     

Determination of trace elements in human serum by inductively coupled plasma atomic emission spectrometry with flow injection

An analytical method for the simultaneous determination of some trace elements (Au, Fe, Mg, Li, Sr, Zn) in human serum by inductively coupled plasma atomic emission spectrometry (ICP-AES) with flow injection is described. Physical interference caused by the change of sample viscosity is discussed. When 100 μl of serum was injected, the relevant recoveries of > 99% for Li, > 98% for Cu and Mg, > 95% for Fe were obtained for an NIST SRM with R.S.D. > 1.3% using optimized flow injection parameters. The prepared lyophilized control serum for routine analysis in clinical laboratories was analyzed and verified for the validity of the technique employed in this experiment using NIST SRM 909 as a primary reference material.