流动注射化学发光传感器测定抗坏血酸

基于抗坏血酸抑制ＫＭｎＯ４－鲁米诺体系化光反应这一效应，设计出一种简便，快速，灵敏度高的消耗型化学发光抗坏血酸传感器。该传感器线性响应范围为１．０＊１０＾－５－４．０＊１０＾－３ｇ／Ｌ；相对标准偏差为２．３％（１．０＊１０＾－４ｇ／Ｌ，ｎ＝１１）；     

Determination of proteins in human serum by combination of flow injection sampling with resonance light scattering technique

A flow injection method combined with Resonance light scattering detection was developed for the determination of protein concentration in human serum samples. This method is based on the enhanced RLS signals of protein binding with the dye acid chrome blue K. The enhanced RLS intensities at 264 nm, in an acidic aqueous solution, were proportional to the protein concentration over the range of 2.0–40.0 μg·mL⁻¹ for human serum albumin (HSA) and the limit of detection (3σ) is 85 ng·mL⁻¹. This method was successfully applied to the quantification of total proteins in human serum samples. The maximum relative standard deviation is less than 2% and the recovery is between 97 and 103% for the standard addition method. The sample throughput was 60 h⁻¹.     

A very sensitive flow system for the direct determination of copper in natural waters based on spectrophotometric detection

A very sensitive flow injection method with spectrophotometric detection has been developed for the on-line determination of copper in natural waters. The method exhibits a limit of detection three times lower than the most sensitive direct spectrophotometric method previously described and then allows the direct and simple in situ determination of copper in most natural waters.The method was based on the measurement of the absorbance of the coloured complex formed by copper with the chromogenic reagent di-2-pyridyl ketone benzoylhydrazone (dPKBH) in an alkaline medium. This complex presents stoichiometry 1:2 (Cu:dPKBH), and exhibits maximum absorbance at 370 nm. The manifold used was very simple, and consisted of two channels. The first one contained the sample while the second one contained the colorimetric reagent (3.3×10⁻⁴ M dPKBH in 10% ethanol), in a 1.6×10⁻² M phosphate buffer solution at pH 8. The performance of the system was optimised by using both univariate and modified simplex methodologies. When modified simplex was used, the best signal was obtained for a sample injection volume of 529 μl, a reaction coil length of 1.29 m, and a reagent flow rate of 4.8 ml min⁻¹. Under optimum conditions, the response was linear up to 3 mg l⁻¹ copper, the equation of the straight line being y=0.314x+5.2×10⁻⁴ (r²=0.998). The method allowed a sampling frequency of 40 samples per hour and exhibited a precision of 2.11% (as R.S.D., n=11). The limit of detection was 4.6 μg l⁻¹ (calculated as 3s_b/m, where s_b is the standard deviation of the y-intercept and m represents the slope of the straight line), and was therefore more sensitive than all the direct continuous methods reported previously.The method was successfully applied to the analysis of real water samples, with an average relative error of 5.32%.     

气相色谱-质谱大体积进样法测定蔬菜、水果中17种农药残留

建立了GC—MS／SIM与大体积进样技术结合测定蔬菜、水果中包括有机磷类、氨基甲酸酯类、有机氯类、菊酯类在内的17种农药的方法。样品经丙酮提取，OASIS HLB固相萃取小柱净化后，采用GC—Ms的选择离子模式和大体积进样技术进行测定，能够使相对检出限降低1～2个数量级。大多数农药的线性范围为0．05～10mg／kg，相关系数为0．9943—0．9996，相对标准偏差为3．5％-10．3％，回收率范围在77％～107％之间．方法能满足果蔬中17种农残限量的的检测要求，具有灵敏、快速、重复性好的特点。     

Determination of lithium in pharmaceutical formulations used in the treatment of bipolar disorder by flow injection analysis with spectrophotometric detection

In this work, a flow injection system with spectrophotometric detection was developed for the determination of lithium in pharmaceutical formulations used in the treatment of bipolar disorder. Reaction between Quinizarine (1,4-dihydroxyanthraquinone) and Li(I) ion in alkaline medium containing dimethylsulfoxide (DMSO) was explored for this purpose. The flow system was optimized regarding to its chemical (DMSO, Quinizarine and NaOH concentrations and sample pH) and physical parameters (sample loop volume, carrier flow rate and reactor length) in order to establish better conditions in terms of sensitivity and sampling frequency. The results obtained showed that the concentration of DMSO in the reagent solution presents remarkable influence on the magnitude of analytical signal. Chemical species that could be found in the formulations such as Na(I), K(I), Mg(II), Ca(II), Ti(IV), Cl⁻, CO₃²⁻ e sodium dodecylsulfate were tested as possible interfering ions. Among them, only non-monovalent cations presented noticeable interference on lithium signal. However, they were not found in concentrations high enough to cause interference in the determination of lithium in the samples. Sample preparation was performed by sonicating a slurry prepared by dispersing 100 mg of powdered sample in 15 mL of 0.10 mol L⁻¹ HCl solution. Results obtained by developed methodology were not statistically different from those obtained by flame emission spectrometry. In the optimized conditions the method presented a linear range of 5-40 mg L⁻¹ and a relative standard deviation of 3.6% at 5 mg L⁻¹ Li concentration. Detection and quantification limits were 0.54 and 1.8 mg L⁻¹, respectively. Sampling frequency, calculated as the time interval passed between two consecutive injections, was 60 samples per hour. The methodology was successfully applied in the determination of lithium in three commercial samples.     

合并带流动注射分光光度法研究硫羟乳酸掩蔽性能

本文运用合并带流动注射分析技术，建立了以Ｙｂ＾３＋ＸＯ显色体系为参考体系研究硫羟乳酸掩蔽性能的方法，在ｐＨ５．６硫羟乳酸能掩蔽Ｓｎ＾４＋，Ｂｉ＾３＋，Ｔｌ＾３＋，Ｈｇ＾２＋，Ｃｕ＾２＋，Ｃｒ＾３＋和Ｃｄ＾２＋测定Ｙｂ＾３＋的线性范围为１．３６×１０＾－６～２．７２×１０＾－５ｍｏｌ／Ｌ，采样频率可达１２０次／ｈ。     

流动注射萃取火焰原子吸收光谱法测定硫酸镍电解液中微量铅

本文采用流动注射在线萃取火焰原子吸收光谱法测定硫酸电解液中微量铅，考察了水相介质，共存离子，萃取装置，相比等因素的影响。分析含铅１．４ｍｇ／Ｌ和０．１６ｍｇ／Ｌ的试样，分析值的相对标准偏差（ｎ＝１０）分别为３．９％和１２．３％，方法检出限为０．０２４ｍｇ／Ｌ。     

Determination of trace amounts of bromide by flow injection/stopped-flow detection technique using kinetic-spectrophotometric method

A simple, sensitive and selective method for the determination of bromide in seawater by using a flow injection/stopped-flow detection technique was examined. The detection system was developed for a new kinetic-spectrophotometric determination of bromide in the presence of chloride matrix without any extraction and/or separation. The detection was based on the kinetic effect of bromide on the oxidation of methylene blue (MB) with hydrogen peroxide in a strongly acidic solution. Large amounts of chloride could enhance the sensitivity of the method as an activator. The decolorisation of the blue color of MB was used for the spectrophotometric determination of bromide at 746 nm. A stopped-flow approach was used to improve the sensitivity of the measurement and provide good linearity of the calibration over the range of 0-3.2 μg ml⁻¹ of bromide. The relative standard deviation was 0.74% for the determination of 2.4 μg ml⁻¹ bromide (n = 5). The detection limit (3σ) was 0.1 μg ml⁻¹ with a sampling frequency of 12 h⁻¹. The influence of potential interfering ions was studied. The proposed method was applied to the determination of bromide in seawater samples and provided satisfactory results.     

Sequential injection analysis for benzophenone-4 and phenylbenzimidazole sulphonic acid in sunscreen sprays by solid-phase extraction coupled with ultraviolet spectrometry

A sequential injection UV method was developed to determine benzophenone-4 (BZ4) and phenylbenzimidazole sulphonic acid (PBS) simultaneously, these being the most commonly used UV-filters in aqueous formulations used as sunscreen sprays. The selective elution of both was performed by on-line solid-phase extraction, by retention on a SAX microcolumn and separation by varying the pH of elution. The sensitivity obtained was 0.042±0.001 ml μg⁻¹ for PBS and 0.0159±0.0003 ml μg⁻¹ for BZ4. The limit of detection was 1.6 μg ml⁻¹ for PBS and 0.6 μg ml⁻¹ for BZ4. The R.S.D. of the results was 1-6% for PBS and 1-12% for BZ4. The method was validated using commercial sunscreen formulations with concentrations determined by a liquid chromatographic procedure. The two procedures gave comparable results. Automation of the method means the amount of reagents used and residues generated are decreased. The system allows the required analysis sequence to be programmed using suitable software.     

Coupling of flow injection wetting-film extraction without segmentation and phase separation to flame atomic absorption spectrometry for the determination of trace copper in water samples

A flow injection wetting-film extraction system without segmentor and phase separator has been coupled to flame atomic absorption spectrometry for the determination of trace copper. Isobutyl methyl ketone (MIBK) was selected as coating solvent and 8-hydroxyquinoline (oxine) as the chelating reagent. By switching of a 8-channel valve and alternative initiation of two peristaltic pumps, MIBK, sample solution containing copper chelate of oxine, and air-segment sandwiched eluting solution (1.0 mol l⁻¹ nitric acid) were sequentially aspirated into an extraction coil made of PTFE tubing of 360 cm length and 0.5 mm i.d. The formation of organic film in the wall of the extraction coil, extraction of the copper chelate into the organic film and back-extraction of the analyte into the eluting solution occurred consecutively when these zones aspirated into the extraction coil were propelled down the extraction coil by a carrier solution at a flow rate of 2 ml min⁻¹. After leaving the extraction coil, the concentrated zone was transported to the nebulizer at its free uptake rate for atomization. Under the optimized conditions, an enrichment factor of 43 and a detection limit of 0.2 μg l⁻¹ copper were achieved at a sample throughput rate of 30 h⁻¹. Eleven determinations of a standard copper solution of 60 μg l⁻¹ gave a relative standard deviation of 1.5%. Foreign ions possibly present in tap water and natural water did not interfere with the copper determination. The developed method has been successfully used to the determination of copper content of tap water and river water.