Structural study and electrical properties of Zr-doped Nd<Subscript>2</Subscript>Sn<Subscript>2</Subscript>O<Subscript>7</Subscript> pyrochlore compounds

Nd₂Sn₂O₇ pyrochlores with the substitution of Zr⁴⁺ were prepared by conventional ceramic double sintering technique. The single-phase formation was confirmed by X-ray diffraction and neutron diffraction techniques. Relative intensity calculations for X-ray diffraction analysis were performed for oxygen positional parametersx = 0.331 and 0.375, while Rietveld refinements were employed for neutron diffraction data. The neutron diffraction study revealed that there are only two anion sites with 48f and 8b positions. This indicates that the 8a site, i.e. O(3) sublattice, is completely vacant and the structure is a perfect cubic pyrochlore with space group Fd3m (O _h ⁷ ). From the conductivity measurements, it is observed that the electronic conductivity dominates from room temperature up to about 525 K and forT > 525 K, the oxygen ion conduction dominates the charge transport in these compositions. Complex impedance spectroscopy indicates the existence of grain and grain boundary as two separate elements.     

Protection of iron corrosion by stearic acid and stearic imidazoline self-assembled monolayers

A type of stearic imidazoline (IM) inhibitor was prepared using stearic acid (SA) and diethylenetriamine (DETA) as raw materials. The monolayers of IM and SA were assembled on the iron surface. The electrochemical characterization of stearic acid (SA) and stearic imidazoline (IM) on an oxide free iron surface had been studied. The monolayers of IM inhibitor were characterized by electrochemical impedance spectroscopy (EIS), electrochemical polarization curves, double layer capacitance, X-ray photoelectron spectroscopy (XPS) and molecular simulation. The results of electrochemical studies had illustrated that the inhibition efficiency of IM was higher than SA. XPS showed that the IM molecules adsorbed on the iron surface. The molecular simulation calculations showed that the IM molecules were tilted at an angle on the iron surface.     

LiNbO3∶Cr∶Cu晶体吸收特性及非挥发全息存储研究

研究了LiNbO3∶Cr∶Cu晶体的吸收特性,发现LiNbO3∶Cr∶Cu（含0.14 wt.% Cr2O3 和 0.011 wt.% CuO）晶体存在两个明显的吸收峰,中心波长分别位于480 nm和660 nm; 随着Cr的含量逐渐减小,Cu的含量逐渐增大,短波段不存在明显吸收峰,掺Cr的含量越大,中心波长在660 nm处的吸收越大；633 nm红光虽然位于中心波长为660 nm的吸收峰内,但它无助于光折变过程.分别采用390 nm紫外光和488 nm蓝光作为敏化光,514 nm绿光作为记录光的记录方案,实现了非挥发全息记录,掺入适量的Cr( 比如NCr=2.795×1025 m－3,NCr/ NCu=1)有助于全息记录性能的提高.     

DIELECTRIC EFFECT ON THE RADIO-FREQUENCY CHARACTERISTICS OF A RECTANGULAR WAVEGUIDE GRATING TRAVELING WAVE TUBE

A new type of partial-dielectric-loaded rectangular waveguide grating slow-wave structure (SWS) for millimeter wave traveling wave tube (TWT) is presented in this paper. The radio-frequency characteristics including the dispersion properties, the longitudinal electric field distribution and the beam-wave coupling impedance of this structure are analyzed. The results show that the dispersion of the rectangular waveguide grating circuit is weakened, the phase velocity is reduced and the position of the maximum E _z is basically invariant after partially filling the dielectric materials in the rectangular waveguide grating SWS. Although the coupling impedance decreases a little, it still keeps above 40 Ω.     

�����װ�õĻԹ�ŵ�����

在四阳极直流放电装置上,测量并分析了辉光放电的电流-电压和发光特征随气压的变化关系。结果表明,采用稳流放电模式比稳压放电具有更宽的稳定放电气压和电流范围,能在从1～800Pa的较宽气压范围内实现氦气辉光放电,放电电流可达到500mA左右。随着电极表面亮斑的变化,对于同一气压,在低电流区,放电电压几乎成指数增长;随电流增大,电压的增长速度变缓;对于高的气压,碰撞频率的增大使得电压随电流升高的速率变小。分析表明,放电处于异常辉光区。从放电管的CCD图像可以看出,对于同一放电电流,随气压的升高,等离子体往阴极收缩。     

Electrochemical impedance spectroscopy and linear polarization applied to evaluation of porosity of phosphate conversion coatings on electrogalvanized steels

In this work, electrochemical impedance spectroscopy and linear polarization are used in determining porosity of zinc phosphates, and of nickel and manganese modified zinc phosphates on electrogalvanized steel. The porosity of the phosphate layers ranges from 0.1% for the manganese-modified hopeite to 8% for hopeite, using the linear polarization and the electrochemical impedance spectroscopy techniques. The porosity values measured using the two techniques were in agreement. All impedance spectra of coated samples showed two steps, with two capacitive arcs and an inductive looping.     

高功率型镍氢电池的循环性能

由于没有镉污染,对环境友好,用于高功率设备的镍氢电池的需求量增长很快,目前每年的需求量约为5亿只.但是镍氢电池的一些性能还不能完全满足电动工具的使用要求,突出表现在电池大电流充放循环寿命较差.因此,研制高性能的高倍率镍氢电池不仅具有重要的研究意义,也有很大的应用价值.本文研究影响SC型动力电池循环寿命衰减的主要因素,测量了在大电流循环过程中镍氢电池的内阻、温度及重量变化,并运用SEM、XRD对电池内阻升高的原因进行了分析.我们认为电池内阻升高是镍氢电池大电流循环寿命差的主要原因,分析发现在镍氢电池进行大电流充放电循环时,电池正极膨胀,负极微粉化,电池内部孔隙率增加,致使电解液干涸,电池内阻升高.通过增加负极容量,抑制正极膨胀,可以有效改进镍氢电池大电流充放时的循环性能.     

自组装双硫醇分子膜阻抗谱的研究

对交流电场下双巯基烷烃硫醇自组装分子膜的阻抗谱进行了研究.利用汞金属作为衬底,制备出双巯基烷烃硫醇自组装分子膜,并通过交流频谱仪对其进行频谱的扫描．明确了膜的作用范围为阻抗谱中频部分为了解释该阻抗谱,提出了一种串联的等效电路来进行了拟合,并与其他的模型进行比较.同时,观察到在损耗谱中损耗峰随硫醇碳链原子数的增加而向低频方向移动并得出双巯基硫醇(C6-C10)在交流电场下的激活能为23～39 meV．     

Holographic interferometry as electrochemical emission spectroscopy of a carbon steel in 5–20 ppm TROS C-70 inhibited seawater

In the present investigation, holographic interferometry was utilized for the first time to determine the rate change of the number of the fringe evolutions during the corrosion test of a carbon steel in blank seawater and seawater with different concentrations of a corrosion inhibitor. In other words, the anodic dissolution behaviors (corrosion) of the carbon steel were determined simultaneously by holographic interferometry, as an electromagnetic method, and by the electrochemical impedance (EI) spectroscopy, as an electronic method. So, the abrupt rate change of the number of the fringe evolutions during corrosion tests, EI spectroscopy, of the carbon steel is called electrochemical emission spectroscopy. The corrosion process of the steel samples was carried out in blank seawater and seawater with different concentrations, 5–20 ppm, of TROS C-70 corrosion inhibitor using the EI spectroscopy method, at room temperature. The electrochemical-emission spectra of the carbon steel in different solutions represent a detailed picture of the rate change of the anodic dissolution of the steel throughout the corrosion processes. Furthermore, the optical interferometry data of the carbon steel were compared to the data, which was obtained from the EI. spectroscopy. Consequently, holographic interferometry is found very useful for monitoring the anodic dissolution behaviors of metals, in which the number of the fringe evolutions of the steel samples can be determined in situ.     

Diophantine Undecidability of Function Fields of Characteristic Greater than 2, Finitely Generated over Fields Algebraic over a Finite Field

Let F be a function field of characteristic p > 2, finitely generated over a field C algebraic over a finite field C _p and such that it has an extension of degree p. Then Hilbert's Tenth Problem is not decidable over F.