抽指加权宽带扇形叉指声表面波滤波器的等效电路分析

扇形换能器可以看成若干个沿孔径方向划分的均匀孔径换能器电端并联而成，根据梅森(Mason)等效电路模型以及由其延伸的混合场等效电路模型，推导出整个扇形换能器的导纳矩阵和频率响应，其中采用复阻抗模型考虑了叉指电极与自由表面的阻抗不连续的因素。本方法能够模拟指间反射、三次行程、指条寄生阻抗以及外围电路等对器件性能的影响；理论模拟与实验结果吻合。     

树立地方文献品牌建设地方特色馆藏——公共图书馆地方文献的开发和利用

介绍了公共图书馆地方文献的收藏特色,论述了树立地方文献品牌的途径,提出了全面开发地方文献资源的建议。     

Determination of the degree of cure under dynamic and isothermal curing conditions with electrical impedance spectroscopy

This article presents a new methodology for the quantitative determination of the progress of the curing reaction of a thermosetting resin, using the results of electrical impedance spectroscopy. The method is an extension of the use of the imaginary impedance maximum as a reaction progress indicator and is based on the demonstration of a close correlation between the reaction rate, as measured by conventional differential scanning calorimetry, and the rate of change of the value of the imaginary impedance spectrum maximum. Tests on a commercial aerospace epoxy resin under both isothermal and dynamic heating conditions with calorimetry and impedance spectroscopy have demonstrated the validity of the method and set the accuracy limits involved. This technique can be used as a real-time online control tool for thermoset composite manufacturing. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 146–154, 2004     

螺旋线径向挤压变形对其慢波结构冷测特性的影响

 介绍了用MAFIA软件的准周期边界条件计算螺旋线行波管慢波结构的色散和耦合阻抗，以及用ANSYS软件对螺旋线径向挤压变形建模的方法，并对螺旋线受挤压径向变形对其冷测特性的影响进行了详细的分析。结果表明:螺旋线径向挤压变形会导致相速增大，而在通常的变形范围内耦合阻抗也会增加；当变形继续增大时耦合阻抗上升到最大值后开始下降。     

Investigation of thin-film electroluminescent structures on rough subsrates

Results of experimental investigations of the volt-brightness characteristics, frequency dependences of brightness, and the directional radiation pattern of electroluminescent MSDM, MSCM, and MSDCM emitters, where M stands for the first transparent and second nontransparent electrodes, S is a semiconductor, D is a thin-film dielectric, and C is a silicone-based composite liquid dielectric with a powdered segnetoelectric filler, developed on conventional “smooth” and rough glass substrates are presented. It is shown that electroluminescent structures on rough surfaces have a brightness approximately two times higher than that of similar structures developed on a “smooth” substrate. Ul’yanovsk State University, 42, L. Tolstoi St., Ul’yanovsk, 432700, Russia. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 4, pp. 507–512, July–August, 1997.     

非线性控制系统的最小实现

对于那些由代数微分方程描述的具有输入输出关系的非线性控制系统，本文采用两种方法讨论了其最小实现问题：一种方法是直接计算系统的特征列；另一种方法则采用了本原元定理．两种方法给出的最小实现所需的状态变量最小数目是相等的．文中的大量代数与微分运算则可利用数学机械化来完成     

理想非线性单组分色谱模型理论解与实验的比较

用气相色谱的分析方法研究了理想非线性单组分不同温度下的流出曲线，用＂特征点＂法回归出了各组分的物理常数Ｇ和ｂ，代入理论模型公式，并与实验结果进行子比较。     

太阳电池I－V数据采集系统

本文利用ＩＥＥＥ－４８８接口板，Ｋｅｉｔｈｌｅｙ６１７静电计，ＩＢＭ－ＰＣ微机，编程实现了太阳电池Ｉ－Ｖ数据的自动采集、存储．以ａ－Ｓｉ：ＨＰｉｎ型太阳电池为样品，计算出相应的电池参量，验证了该系统的可行性和准确性．     

多功能剧场建筑设计与可调混响时间的应用

本文以一座大型厂矿文化宫建筑设计实例,扼要论述了多功能厅堂的设计要点,结合我国目前多功能厅堂使用状况,提出以电声为主的设计原则和实施办法,以改善多功能厅堂的音质效果。     

岩芯筒压入地层的塑性力学问题

摘要首先从库仑定律出发导出了地层介质塑性流动条件。其结果类似于一般塑性力学中的Tresca,Mises条件。其次列出了轴对称地层塑性流动的微分方程组,并推出了其简化近似方程。最后提出了简化方程的特征线解法,并举例说明。