风沙运动的DPM数值模拟

采用离散颗粒模型对风沙气固两相流动进行了数值计算．在该模型中,采用体平均的Navier-Stokes方程来描述气相的运动,对离散颗粒采用拉格朗日方法模拟,求解颗粒运动方程．采用硬球模型描述颗粒问碰撞作用．计算结果表明,沙粒平均水平速度廓线在0．02 m以上高度可以表示为按对数函数或幂函数规律增加,在0．02 m以下则发生偏离;在大于0．02 m的高度,输沙通量随高度按指数规律衰减,而在地面附近由于颗粒蠕移的影响发生偏离,这与已有文献结果一致。本文的模拟有助于风沙运动规律的研究与掌握。     

一步制备高比表面积介孔Co3O4-CeO2及其表征

以有序介孔二氧化硅KIT-6为硬模板,硝酸钴、硝酸铈为金属源,分别在真空辅助条件和普通搅拌条件下制备了介孔CoCeOx复合氧化物。采用XRD、SEM、TEM、N2吸脱附等技术表征了复合氧化物的物化性质,并评价其氧化甲苯的性能。结果表明,在真空辅助和搅拌条件下制备的CoCeOx氧化物是由Co3O4和CeO2组成的介孔Co3O4-CeO2复合氧化物,其比表面积分别为141和89 m^2·g^-1,平均孔径分别为8.7和9.6 nm。真空辅助纳米复制过程有利于金属盐的前驱体充分填充到模板的孔隙中,去除模板后,可以得到有序的介孔复合金属氧化物。所制备介孔钴铈复合氧化物具有孔道有序性好、比表面积大的特点,在挥发性有机化合物的氧化去除方面具有一定的应用前景。     

磁头/磁盘滑动接触下磁盘温度及热退磁临界条件的研究

采用二维轴对称有限元模型计算磁头/磁盘滑动接触下,铝质磁盘的稳态温度和热应力场以及热退磁临界条件.结果表明:磁盘温度在极短时间内升至摩擦稳态值,然后缓慢线性升高到最终稳态值;经过充分热传导和热交换后磁盘的温度梯度较小,此时磁层内的热应力集中分布于磁盘固定端边缘附近;磁盘的稳态温度和热应力均随速度增大而增大,且载荷越大其值增大越快;热应力小于1.2 GPa时所对应的速度和载荷为安全工况;温升大于373 K时所对应的工况将导致磁盘退磁.     

同步辐射硬x射线衍射增强成像新进展

对于相位衬度成像的实验方法研究及其在医学、材料等领域的应用研究已成为国际上研究的热点.衍射增强成像方法(DEI)作为其中的一种方法通过测量相位衬度的一阶导数而成像.在北京同步辐射装置(BSRF)4W1A束线上，对衍射增强成像方法进行了研究，并对一系列生物医学样品及材料样品成像，得到了非常清晰的相位衬度图像. 关键词： 衍射增强成像 同步辐射 硬x射线     

晶粒尺寸和热处理对Sm2Fe17N3/Fe3N/BN软磁/硬磁复合材料的合成及磁性能影响

采用高能球磨和真空热处理方法制备Sm2Fe17N3/Fe3N/BN复合材料, 并研究球磨过程中晶粒尺寸变化对固态相变和磁性能的影响.  结果表明: Sm2Fe17N3和Fe3N相产生的条件是Fe的晶粒尺寸达到纳米量级（D＜80 nm）并形成Fe(Sm)固溶体; 随着退火时间的增加, 300 ℃真空退火的球磨样品中Sm2Fe17N3的结晶物增多, 矫顽力提高, 表明样品的磁性能与Sm2Fe17N3的结晶程度有关.     

弘扬延安精神,加强和改进党的作风建设

延安精神是我们党的传家宝,是中华民族宝贵的精神财富;延安精神对加强和改进党的作风建设有极其重要的意义;新形势下弘扬延安精神,加强和改进党的作风建设,一是认真贯彻党的全心全意为人民服务的根本宗旨;二是大力发扬艰苦奋斗的作风。     

The Conflict Between the Traditional Value and Reality In Sister Carrie

Theodore Dreiser relates a story of Carrie 's rise from a poor country girl to a Broadway star in Sister Carrie.An attempt is made in this paper to analyze the cold society.By way of analyzing this unequal and cruel reality to prove:in the world only the fittest can survive,the standards and requirements of morality are challenged and the traditional value is suspected.In the cold reality,any way that can protect oneself or survive in the world is sensible,morality and traditional value are weak and meaning...     

Energy spectrum of multi-radiation of X-rays in a low energy Mather-type plasma focus device

The multi-radiation of X-rays was investigated with special attention to their energy spectrum in a Mather-type plasma focus device （operated with argon gas）. The analysis is based on the effect of anomalous resistances. To study the energy spectrum, a four-channel diode X-ray spectrometer was used along with a special set of filters. The filters were suitable for detection of medium range X-rays as well as hard X-rays with energy exceeding 30 keV. The results indicate that the anomalous resistivity effect during the post pinch phase may cause multi-radiation of X-rays with a total duration of 300 ± 50 ns. The significant contribution of Cu-Kα was due to the medium range X-rays, nonetheless, hard X-rays with energies greater than 15 keV also participate in the process. The total emitted X-ray energy in the forms of Cu-K and Cu-K/3 was around 0.14 ± 0.02 （J/Sr） and 0.04 ±0.01 （J/Sr）, respectively. The total energy of the emitted hard X-ray （〉 15 keV） was around 0.12± 0.02 （J/Sr）.     

The spreading behaviour of perfluoropolyether droplets on solid surfaces

The spread of perfluoropolyether （PFPE） droplets on solid surfaces has been measured from the top-down view through a microscope system. Effects of substrates, molecular weight and end-group functionality on spreading of the PFPE droplets have been studied experimentally and the results were compared with those by molecular dynamics （MD） simulations. Silicon wafer and diamond-like carbon （DLC） substrates were used to study the effect of substrates on spreading. Two types of PFPE, Z-dol and Z-tetraol, with the same chain structure and various molecular weights （2000 and 4000 g/mol） were employed in experiments. Effect of molecular weight has been investigated through comparing the spreading of Z-dol 2000 and Z-dol 4000, and it is found that the increase of molecular weight will decrease the mobility of PFPE. Comparison between spreading of Z-dol and Z-tetraol of the same molecular weight proved that functional end group plays a significant role on the spreading of PFPE, which confirmed the MD simulation results.     

硬磁铁氧体磁取向技术

本文讨论制造硬磁材料的重要技术——磁取向技术。文章从描述物质的磁畴结构入手,联系到磁性材料实际的生产工艺,对磁取向方法进行了广泛的述评。