Preparation and characterization of functional group gradient surfaces

Functional group gradient surfaces where the density of functional groups changes gradually along the sample length were prepared. The functional group (? COOH, ? CONH₂, and ? OH group) gradient surfaces were produced by the treatment of low-density PE sheets using a corona with gradually increasing power, followed by the graft copolymerization of acrylic acid and subsequent substitution reaction of carboxylic acid groups to amide or hydroxyl groups. The prepared gradient surfaces were characterized by the measurement of water contact angle, FTIR-ATR, and ESCA. The gradient surfaces prepared can be used to systematically investigate the interactions of biological or other species in terms of the surface functional groups and their density of polymeric materials. © 1994 John Wiley & Sons, Inc.     

壳多糖与丙烯酸丁酯的乳液接枝共聚研究

以十二烷基苯磺酸钠为乳化剂，过硫酸钾－亚硫酸氢钠为引发剂，研究了壳多糖与丙烯酸丁醋的乳液共聚合，结果表明当［Ｋ２Ｓ２Ｏ８］＝［ＮａＨＳＯ３］＝２．５７×１０－３ｍｏｌ·１－１，［ＢＡ］＝０．６８ｍｏｌ．１－１，［Ｃｈｉｔｏｓａｎ］＝１９．２ｇ·ｌ－１，在７０℃下反应５小时，共聚反应的接技率和接枝效率均较高．用红外光谱，差热分析，Ｘ射线衍射，扫描电镜对接技共聚物进行了表征，此外测试了共聚物胶乳成膜的机械性能，表明用丙烯酸丁酯对壳多糖进行接枝改性，可提高壳多糖的韧性，扩大其应用范围．     

利用大分子单体技术合成接枝共聚物

大分子单体和小分子共单体共聚是合成接枝共聚物的重要途径之一。本文综述了大分子单体通过各种聚合方式(自由基共聚、离子型共聚、配位共聚、基团转移共聚和逐步共聚)和普通小分子单体的共聚反应,详细讨论了大分子单体和小分子单体的自由基共聚反应动力学,并简要介绍了接枝共聚物的应用背景。     

窄分布聚丙烯酸-g-聚甲基丙烯酸酯接枝共聚物的合成

利用合成的一种新型原子转移自由基聚合大分子引发剂和从主干接枝的方法制备了窄分布的两亲性接枝共聚物聚丙烯酸-g-聚甲基丙烯酸酯, 并对其结构进行表征. 产物主链和侧链的分子量可分别通过调整单体与引发剂的投料比和反应时间进行控制, 结构规整, 侧链单体适用范围广. 该合成方法不仅推动了接枝共聚物合成研究的进展, 其产物更为两亲性接枝共聚物自组装行为的研究提供了很好的研究对象.     

四氢呋喃-水-乙醇三元溶液体系制备高合金化Pt-Ru/CMK-3催化剂

提出了在四氢呋喃(THF)、H2O和乙醇三元体系中用一般的化学还原法在室温下制备高合金化Pt-Ru/CMK-3催化剂的新方法. 与在纯水中制得的商品化ETEK催化剂相比, 其Pt-Ru粒子的合金化程度高、平均粒径较小且相对结晶度低, 因此, 该催化剂对甲醇氧化的电催化活性远高于在纯水中制得的Pt-Ru催化剂. 高合金化程度的原因是H2PtCl6和RuCl3在THF、H2O和乙醇三元溶液体系中的起始还原电位相近. 此外, CMK-3以其规整的二维有序孔道结构, 为直接甲醇燃烧电池(DMFC)中电子和物质的传输提供了方便的路径, 其巨大的比表面积也为Pt-Ru 纳米粒子的均匀分散提供了良好的载体.     

淀粉接枝丙烯酸/醋酸乙烯酯高吸水性树脂的制备

以过硫酸铵为引发剂,N,N-亚甲基双丙烯酰胺为交联剂,淀粉与丙烯酸/醋酸乙烯酯混合单体通过接枝共聚,制备了吸水及耐盐性能均较好的淀粉接枝丙烯酸/醋酸乙烯酯高吸水性树脂(CGAV)。最佳工艺条件为:淀粉10.0 g,m(混合单体)∶m(淀粉)=4∶1,w(引发剂)=0.3%,w(交联剂)=0.05%,于45℃反应2h~3 h。在最佳工艺条件下制得的CGAV吸去离子水率760 g.g-1,吸0.9%NaC l水溶液率68 g.g-1。     

SBS与甲基丙烯酸丁酯本体接枝反应的研究

本文研究了以过氧化苯甲酰(BPO)为引发剂,甲基丙烯酸丁酯(BMA)既作溶剂又作为单体与苯乙烯-丁二烯嵌段共聚物(SBS)进行接枝共聚反应。用红外光谱、核磁共振谱及透射电镜表征了接枝共聚物(SBS-g-BMA)的组成及结构,讨论了时间、温度及SBS和BPO的用量对接枝的影响。     

Grafting of maleic anhydride to hydrocarbons below the ceiling temperature

Maleic anhydride has been grafted to eicosane and squalane at 60–80°C using 1,2-dichlorobenzene as solvent and benzoyl peroxide as initiator. These hydrocarbons are low molecular weight models for hydrocarbon polymers containing secondary and tertiary hydrogen atoms. In the absence of the hydrocarbon and with monomer concentrations of the order of 1M, low molecular weight poly(maleic anhydride) is formed. On addition of the hydrocarbon, the main product is grafted material and very little homopolymer is formed. The grafts consist primarily of single succinic anhydride units but some of them are short poly(maleic anhydride) chains. Ceiling temperature considerations control the formation of homopolymer in the absence of hydrocarbon substrate. In the presence of eicosane or squalane, initiation of grafting proceeds by hydrogen abstraction from the hydrocarbon. The main factor controlling graft length is then the ratio of the rates of intramolecular hydrogen abstraction and of monomer addition to succinic anhydride radicals © 1995 John Wiley & Sons, Inc.     

表面活性剂对纤维素接枝共聚物溶液粘度性质的影响

研究了阴离子十二烷基硫酸钠(SDS)、阳离子十六烷基三甲基溴化铵(CTAB)和非离子聚乙二醇辛基苯基醚(OP)等三种不同类型的表面活性剂对疏水化水溶性两性纤维素接枝共聚物(CGAO)溶液粘度性质的影响.结果表明,在SDS和OP的临界胶束浓度(cmc)附近，CGAO溶液粘度最大，SDS引起CGAO粘度的变化大于OP；即使在CTAB的cmc附近，随着CTAB浓度的增加，CGAO的粘度一直呈下降趋势；非疏水改性的纤维素接枝共聚物的溶液粘度随SDS或CTAB浓度的增加而下降，但几乎不随OP浓度的增大而变化.此外，通过凝胶渗透色谱法测得的保留时间证实了SDS、CTAB和OP与CGAO之间的疏水缔合作用.     

Pre-irradiation induced grafting of styrene into crosslinked and non-crosslinked polytetrafluoroethylene films for polymer electrolyte fuel cell applications. II: Characterization of the styrene grafted films

Crosslinked and non-crosslinked polytetrafluoroethylene films (RX-PTFE and V-PTFE films, respectively) were irradiated by γ-ray and then grafted with styrene in liquid phase. Microscope FT-IR spectroscopy, TGA, solid state ¹³C CP/MAS and high resolution HS/MAS NMR spectroscopy, wide-angle X-ray diffraction (WAXD) study were used to get the structural information of the styrene grafted RX-PTFE and V-PTFE films. From microscope FT-IR spectra of the grafted RX-PTFE films, the “grafting front mechanism” was proved. TGA analysis showed that the grafted films have a small degradation step and two main degradation steps. In the ¹³C CP/MAS NMR spectra of the non-grafted films, there are no signal due to the absence of the hydrogen atom. While in the spectra of the grafted films, there are signals attributed to the polystyrene grafts. In the ¹³C HS/MAS NMR spectra of the grafted films, the relative intensity of the peaks attributed to the polystyrene grafts increased while the relative intensity of the peak attributed to PTFE matrix decreased with the increase in the DOG. From WAXD patterns, the intensity of the crystalline peak decrease with the increase in the DOG. The grafted films were sulfonated by chlorosulfonic acid and the results of highest IEC value exceeded 3.0. Those results will be reported in the near future.