金属基底对石墨烯薄膜阴极气体击穿稳定性影响

利用石墨烯二维材料极好的场发射能力和发射稳定性,提出了石墨烯阴极提高气体开关击穿稳定性的技术路线。采用化学气相沉积法和基底腐蚀转移法两种方法制备金属基底石墨烯薄膜阴极。利用扫描电子显微镜和拉曼光谱表征了石墨烯薄膜阴极质量,确认了石墨烯层数和均匀性。实验研究了两种石墨烯薄膜阴极气体开关,在微秒脉冲均匀电场作用下的击穿特性,获得了击穿电压幅值和分散性的变化规律。结果表明:当气体为0.6 MPa N2、电极间距为5 mm时,铜基底石墨烯薄膜阴极平均击穿电压为85.9 kV,相对标准差为3.2%;不锈钢基底石墨烯薄膜阴极平均击穿电压仅为59.8 kV,相对标准差为2.4%。当两种阴极击穿电压均为80 kV时,相对标准差比较,不锈钢基底仅为铜基底的44%。分析认为,不锈钢基底石墨烯薄膜质量优于铜基底,石墨烯薄膜导致阴极表面微观场增强因子更高,表面分布更均匀,在电场作用下场致发射产生均匀稳定的大量初始电子流,降低了气体开关击穿电压,有效提高了击穿稳定性。     

不同实验条件对激光诱导等离子体的影响机理研究

常温常压下,采用波长532 nm的Nd:YAG纳秒激光器激发诱导空气中的铝合金,由高分辨率的光谱仪和ICCD对等离子体发射光谱采集和实现光电转换。研究激光能量、ICCD门延迟和聚焦透镜到样品表面的距离(lens-to-sample distance,LTSD)对谱线信号强度和等离子体电子温度的影响,并分析了产生影响的物理机制。结果表明,固定ICCD门延迟和LTSD,随着激光能量的增大,谱线强度和电子温度均增大;计算结果表明,当激光能量从20 mJ增加到160 mJ时,原子谱线Al I 396.15 nm,Mg I 518.36 nm,离子谱线Mg II 279.54 nm谱线强度相较于20 mJ分别提高了12.83,6.45,10.56倍。固定激光能量和LTSD,ICCD门延迟在100~4000 ns范围内变化时,随着延迟的增加,谱线强度和等离子体电子温度均呈指数形式衰减。固定ICCD门延迟和激光能量,采用焦距为75 mm的聚焦透镜,研究了LTSD对等离子体参数的影响机理。结果表明,聚焦透镜到样品的距离对等离子体的谱线强度和电子温度有较大的影响。等离子体的特征谱线强度和等离子体的电子温度的变化规律基本一致,分别在聚焦透镜到样品表面的距离为73 mm和79 mm处取得峰值,并在73 mm处对应最大值。     

绝缘油击穿电压实验研究

利用第3代SY型便携式绝缘油耐压试验仪,测定在不同温度、水分和机械杂质下,绝缘油介电强度的变化。结果表明：温度的升高能使绝缘油的击穿电压增大,当温度达到一定的时候,击穿电压开始下滑;而油中水分、机械杂质的增多,会使油液击穿电压有较明显的下降,因此在绝缘油运行前应该注意防潮、去杂。     

Ar/air介质阻挡放电丝的时空相关特性

采用特殊的水电极介质阻挡放电实验装置,测量了大气压下氩气和空气混合气体放电的击穿电压;利用光学方法测量了介质阻挡放电中放电丝的时空特性.发现随着空气体积分数的增加,击穿电压也随之升高,总光电流脉冲半宽度变窄,放电丝间的时空相关性变弱,放电丝的直径逐渐减小,亮度变暗.     

盐引发阴离子/非离子表面活性剂复配体系中囊泡自发形成

在无盐时, 阴离子表面活性剂十二烷基苯磺酸钠(SDBS)与非离子表面活性剂壬基酚聚氧乙烯(10)醚(TX-100)的复配体系中只有混合胶束存在, 而盐的加入即可以引发体系中囊泡的自发形成, 这使得囊泡的形成变得更加简单. 引发机理可以归因于盐对离子表面活性剂的极性头双电层的压缩作用, 减少了极性头的面积, 加上非离子表面活性剂的参与使得堆积参数P增加, 导致了半径更大的聚集体的形成. 制作了SDBS/TX-100/盐水拟三元相图, 通过目测和表面张力的变化确定了囊泡形成的带状区域, 并用负染色电镜(TEM)对囊泡进行了表征, 同时测定了盐度以及相同盐度下表面活性剂浓度对囊泡粒径的影响, 发现囊泡的粒径随着盐度的增加而增加, 而在同一盐度下, 囊泡的粒径基本不受表面活性剂浓度的影响.     

正负离子表面活性剂复配系统

正负离子表面活性剂复配系统,由于其带有相反电荷的离子头基间的强静电相互作用,具有强协同效应和高表面活性,在水溶液中可形成丰富的微观结构,表现出复杂的相行为。本文在相关研究的基础上,对于正负离子表面活性剂复配系统在表面（界面）性质,囊泡的制备及稳定性,虫状胶束的生成和性质,双水相系统的性质及其在萃取方面的应用,拟相分离模型、热力学胞腔模型、分子热力学模型及分子模拟等理论研究和作为模板合成纳米材料等方面的研究进展进行了综述。对于双水相系统的研究,指出了一些有待于进一步解决的问题。     

CTAB/SDBS囊泡的自发形成与聚合

讨论了CTAB/SDBS复配比例、体系浓度对其囊泡自发形成的影响和不同制备方法与放置时间对囊泡尺寸的影响,同时用TEM考察了囊泡的结构与形态。通过TEM发现囊泡之间有相互聚集融合变大的趋势,粒径分析也发现随放置时间延长囊泡尺寸增大。所以这里采用聚合法来改善囊泡的稳定性。经粒径分析证实经聚合法处理的囊泡其尺寸明显比未处理的稳定。     

Structural Phase Behavior of High-Concentration,Alignable Biomimetic Bicelle Mixtures

The structures of bicelle mixtures composed of dimyristoyl and dihexanoyl phosphatidylcholines (DMPC and DHPC) with DMPC/DHPC molar ratios of 3.2 and 5 are characterized using polarized optical microscopy (POM) and small angle neutron scattering (SANS). Three phases, isotropic (I), chiral nematic (N^*) and smectic (S) are observed as temperature (T) varies from 10 to 70 °C. The structure of the magnetically alignable N^* phase, which was previously considered to be made up of discoidal micelles, is found to be composed of “ribbons”. Doping with the charged lipid, dimyristoyl phosphatidylglycerol (DMPG), which has the same 14:0 hydrocarbon chains as DMPC, results in a structural change of the aggregates where only the isotropic and smectic phases are observed. The smectic phase for the mixtures doped with DMPG is shear-alignable and follows one-dimensional swelling. However, at high-T zwitterionic DMPC/DHPC mixtures form multi-lamellar vesicles (MLV) with a relatively constant lamellar spacing of 66 Å, independent of water content.     

A titration microcalorimeter and the vesicle of mixed surfactants

A titration microcalorimeter with the sample cells of 1 mL and 3 mL volume was constructed by combining LKB-2107 ampule microcalorimeter with an improved Thermometric titration microcalorimeter. Its sensitivity and precision were tested with the baseline noise and stability, the measurement of energy equivalent, and the linear relation of electric energy and integral area as the function of voltage (V)-time (f). Its accuracy was demonstrated by measuring the dilution enthalpy of a concentrated sucrose solution and the micelle-forming enthalpy of sodium dodecyl sulfate (SDS) in aqueous solution respectively. At the same time, the enthalpy of interaction between SDS and didodecyldimethylammonium bromide (DDAB) was measured by using the titration microcalorimeter, and the phase behavior of SDS-DDAB aqueous mixture was discussed. The microcalorimetric results show that the enthalpy of interaction between SDS and DDAB micelles is -29.53 kJ/mol, the enthalpy of formation of 1:1 SDS-DDAB salt is -125.8 kJ/mol,     

Mechanisms of broadening of emission lines of a laser-induced plasma generated on the surface of rigid targets

This article reports the results of an experimental investigation of the basic mechanisms that cause the broadening of emission lines of a laser-induced plasma generated on the surface of rigid targets in a gaseous atmosphere. The contribution of Stark and resonance mechanisms of emission-line broadening for the resonance doublet Al I 3s²3p²P_3/2,1/2-3s²4s²S_1/2 and triplet Mg I 3s3p³P _0,1,2 ⁰ -3s4s³S₁ is discussed. The concentrations of neutral Al atoms in the laser-induced plasma are evaluated by the magnitude of resonance line broadening. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 67, No. 2, pp. 234–237, March–April, 2000.