Voltammetric Behavior of Water‐Soluble Endohedral Metallofullerene Derivatives

Voltammetric behavior of water‐soluble endohedral metallofullerene derivatives Gd@C₈₂(OH)₅(NHCH₂COOH)₉ (GN) and Gd@C₈₂(OH)₆(NHCH₂CH₂SO₃H)₈ (GS) was characterized in 0.1 M KCl solution by CV and DPV. They showed similar redox behavior, that is, a reversible electroreduction process on HMDE was found; in the mean time, an irreversible oxidation process and an irreversible reduction process on GC electrodes were also observed. The results reveal that these two water‐soluble endohedral metallofullerene derivatives have good electron donating ability and poor electron accepting ability due to hydroxy groups, aminoacetic acid and aminoethyl sulfonic acid connected to the C₈₂ cage in comparison with Gd@C₈₂.     

聚丙烯酰胺固定化糖化酶特性的研究

本研究以丙烯酰胺单体通过反向悬浮聚合技术合成聚丙烯酰胺作为载体材料，采用包埋—交联法固定化葡萄糖淀粉酶，并对其特性进行了研究．结果表明，该固定化酶最适pH值为5．0，最适温度为55～58℃，而且具有较好的贮存稳定性和操作稳定性，8个月后该固定化酶的残余活力仍保持在94％左右，可重复使用43批次，此固定化酶酶活回收率达到56％．实验表明丙烯酰胺悬浮聚合固定化糖化酶的方法是简便可行的．     

Zur Struktur und Reaktivität des Diammoniumhexafluoromanganats(IV)

About the Structure and Reactivity of Diammonium Hexafluoromanganate(IV) Electrolytic oxidation of an aqueous suspension of MnF₂ containing NH₄F, and subsequent crystallization in 40% HF yields yellow crystals of (NH₄)₂MnF₆. It crystallizes in the hexagonal K₂MnF₆ type structure with the space group P6₃mc and a = 5.903; c = 9.565 Å; Z = 2. With in situ powder diffraction studies it is shown, that (NH₄)₂MnF₆ is gradually reduced in a NH₃ atmosphere between 30 and 230 °C to afford (NH₄)₃MnF₆, (NH₄)₂MnF₅, and finally NH₄MnF₃. (NH₄)₃MnF₆, thereby, forms a hitherto unknown cubic (a = 9.082 Å) high temperature modification with the cryolite type structure. Under N₂ the thermal decomposition of (NH₄)₂MnF₆ proceeds via NH₄MnF₄ to yield MnF₂.     

三组分(NiO、La2O3、SiO2)负载型加氢催化剂中La2O3的作用

用X射线衍射分析、FT-IR、小角X光散射等方法研究了浸渍法制备的NiO/SiO_2和NiO/(La_2O_3+SiO_2)样品中组分之间的相互作用。La_2O_3在SiO_2上可形成近乎密置单层的分散。在负载了La_2O_3的SiO_2上,NiO的分散程度比在SiO_2上有明显提高,也更容易被还原,而且还原后所得金属镍粒子的平均粒度降低,小粒子所占百分比提高。这些结果表明,NiO/(La_2O_3+SiO_2)比NiO/SiO_2样品具有更高的加氢还原硝基普鲁卡因为胺基普鲁卡因的活性,与Ni/(La_2O_3+SiO_2)比Ni/SiO_2活性高的情形相一致。     

超高交联吸附树脂吸附对硝基苯乙酮的热力学研究

比较两种超高交联聚苯乙烯吸附树脂NJ-8、AM-1与Amberlite XAD-4(以下简称XAD-4)对对硝基苯乙酮的静态吸附行为，根据吸附等温线研究了吸附热力学性质．在298～318K和研究的浓度范围内，NJ-8，AM-1、XAD-4对对硝基苯乙酮的吸附平衡数据符合Freundlich吸附等温方程．结果表明：吸附为放热过程，适当降低温度有利于吸附．计算了对硝基苯乙酮在NJ-8，AM-1、XAD-4树脂上的吸附焓变、自由能变，吸附熵变．对吸附行为作了合理的解释。     

Microporous, fast response cellulose ether hydrogel prepared by freeze-drying

A simple and effective method of preparing fast-response gels is developed. The freeze-drying and subsequent rehydration of thermosensitive gels alters the microstructural properties of the gels in a way that leads to rapid shrinking rates. Microporous hydroxypropyl cellulose (HPC) gels were created by this method to investigate the influence of the process on the swelling and shrinking kinetics of the gels in response to temperature changes. Micropores of different size ranges were produced by freezing gels with different amounts of water at −20 °C. Water content was the key factor to control the microporosity and the shrinking rates of gels. After the freezing treatment, an effective diffusion coefficient for shrinking could be determined by fitting Fick's law to the data (5.2 × 10⁻⁴ cm²/s). This was an increase of two orders of magnitude over that of the untreated, non-porous gel (6.0 × 10⁻⁶ cm²/s). The magnitude of the shrinking coefficient indicates that the shrinking rate of the microporous gel is probably limited by the convective flow, as unsteady flow through porous media follows the same differential equation as Fick's law, but with much greater transport coefficients, as observed here. Physically, the shrinking rate may be determined by the level of interconnected-cells in a microporous structure present at the beginning of shrinking process because the convection through the interconnected-cells is estimated to be much slower than the polymer network diffusion rate of the struts of micropores (0.1–3.0 μm) as well as heat transfer.     

聚丙烯酰胺凝胶结构非均匀性的动态光散射研究

利用动态光散射技术研究了聚丙烯酰胺 (PAAm)凝胶结构的非均匀性 ,分析了PAAm凝胶结构非均匀性的形成原因及凝胶动态光散射的数据处理方法和分析结果的物理意义 .研究结果表明 ,PAAm凝胶中含有动态相关长度 (LC)不同的两相 ,其中 ,LC 为 10～ 2 0nm的区域是聚合物稀疏相 ,LC 为 85nm左右的区域是聚合物密集相 ,两相的不均匀分布形成了PAAm凝胶结构的非均匀性 .分析表明 ,PAAm凝胶存在两相主要是由于单体和交联剂的溶解度存在差异所致 .随交联度增大 ,PAAm凝胶结构的非均匀性显著增强     

Mixtures of branched non-ionic oligo-oxyethylene surfactants in aqueous solutions — the effect of molecular geometry on LC phase behaviour 4

The LC phase behavior of ternary mixtures of the two corresponding branched non-ionic surfactants 1,3-bis-(methoxy-tetraoxyethylene)-2-propoxy-tetradecane (Y-surfactant) and 1,3-bis-(heptyloxy)-2-propoxyoctaoxyethylene mono-methyl ether (V-surfactant) and water were studied by polarizing microscopy. The two branched surfactants, which have different molecular geometries but nearly the same hydrophilic-lipophilic volume ratio, exhibit extremely different phase behavior in binary surfactant/water systems. For the ternary mixtures of Y- and V-surfactant and water we found-according to established packing models-a continuous stabilization of the cubic and hexagonal phases and a destabilization of the lamellar phase with increasing amount of Y-surfactant. On the other hand, we observed a thermal stabilization of the lamellar phase. The maximal transition temperatures of the lamellar phase pass a maximum with increasing amount of Y-surfactant.     

F-T合成Fe/Cu/K/Al2O3催化剂的结构性质、还原及碳化行为

采用连续共沉淀与喷雾干燥成型技术相结合的方法制备了微球状Fe/Cu/K/Al2O3催化剂, 结合TG、N2物理吸附、XRD、H2-TPR、CO-TPR、Mossbauer谱等表征手段, 研究焙烧温度对Fischer-Tropshc (F-T)合成铁基催化剂的结构性质、还原行为和碳化行为的影响. 结果表明, 较高的焙烧温度有利于碳酸盐的分解和结晶水的脱除, 促进了催化剂的还原. 随着焙烧温度的进一步升高, 催化剂的比表面积减小, 平均孔径增大, α-Fe2O3晶粒的粒径增大, 催化剂中金属与载体的相互作用增强, 从而削弱了CuO、K2O助剂的作用, 严重抑制了催化剂的还原和碳化.     

聚合物复合材料填充剂的表面性质及其分散性的研究

本文通过反气相色谱技术研究了未处理的、硅烷偶联剂处理的和钛酸酯偶联剂处理的三种Al(OH)_3粉末的表面性质,并通过塑化仪和扫描电子显微镜研究了Al(OH)_3填充聚丙烯体系的流变行为及其在聚丙烯中的分散效果.结果表明Al(OH)_3的表面性质对其在聚丙烯介质中的分散效果有着重要的影响.