低速二维流动的粒子仿真研究

本文运用信息保存法对低速二维的流动现象进行模拟，考察了低速条件下的有限平板绕流以及微槽道气体流动问题。研究表明：在对低速流动的模拟过程中，运用IP法在能够获得较好的结果的同时，具有比DSMC方法更高的计算效率。     

Limit Regimes of Braking of Disc-Type Composite Flywheels Made by Filament Winding

A set of invariants describing the limit regimes of braking disk-type wound composite flywheels is suggested. The limit regime is determined by using a linear failure criterion. It is shown that, for generating short-time impulses of very high power, a set of small identical flywheels is more effective than one large flywheel with an equivalent mass. Particular examples illustrating the theory considered are discussed.     

Temperature factor effect on the structure of the separated flow within a supersonic gas stream

The effect of the temperature factor, that is, the ratio of the body temperature to the freestream stagnation temperature, on the structure of the separated flow formed in the presence of a concave corner in a supersonic stream is studied. The strong influence of the temperature factor on the separation zone length and the flow-generated aerodynamic characteristics is established. It is shown that for fairly large deflection angles this flow cannot be described by free interaction, or triple deck, theory.     

流水施工组织方法及经济效益剖析

简要介绍了3种不同的流水施工组织方法,并阐述了流水施工的经济效益,指出流水施工的组织方法是建设项目早日投产的首要条件。     

高分子流体材料拉伸流动研究

成纤材料的可纺性是合成新的成纤材料或是度量现有材料的成纤条件的关键性参数,拉伸率是衡量材料的可纺性的依据,本文就纤维纺丝拉伸的类型和特点进行分析研究,其结果与材料本构方程联立求解,可分析求解高分子材料拉伸流动中的流动参数.     

μA级低功耗流量检测仪的设计

针对目前的流量检测仪在缺乏供电的场所无法对流量进行连续监测的问题,提出一种以零功耗磁敏传感器为信号采集前端,以低功耗MSP430F413单片机为控制器的流量检测仪的设计方法.介绍其工作原理和关键芯片的选型、硬件电路和软件流程.用此方法设计的流量检测仪功耗只有μA级,采用普通锂电池供电,非常适合在没有通电的地方使用.     

Analysis and finite element simulations of a second‐order fluid model in a bounded domain

This article is concerned with the equations governing the steady motion of a viscoelastic incompressible second‐order fluid in a bounded domain. A new proof of existence and uniqueness of strong solutions is given. In addition, using appropriate finite element methods to approximate a coupled equivalent problem, sharp error estimates are obtained using a fixed point argument. The method is applied to the two‐dimensional lid‐driven cavity problem, at low Reynolds number and in a certain range of values of the viscoelastic parameters, to analyze the combined effects of inertia and viscoelasticity on the flow. © 2007 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq, 2007     

等截面垂直管道中气粉流的临界管长

考虑重力和摩擦力的影响，建立了描述垂直管道中气粉流行为的数学模型，采用马赫数检验法，确定了产生摩擦壅塞时的临界管长，计算表明，当气粉流以不同方式喷入相同的冶金熔池时，底吹垂直管道比顶吹垂直管道需要更大的临界管长。     

乙醇增敏光泽精－H_2O_2－Pb（Ⅱ）化学发光体系的研究及应用

本文研究了Ｈ＿２Ｏ＿２氧化光泽精发光反应及乙醇的敏化作用，发现加入乙醇可使铅催化Ｈ＿２Ｏ＿２，氧化光泽精的发光强度有较大幅度的增强；铅量在３×１０￣（－７）～８×１０￣（－５）ｇ／ｍＬ。范围内与发光强度成正比．方法检出限为０．１０μｇ／ｍＬ；对含４μｇ／ｍＬＰｂ（Ⅱ）１１次重复测定，其ＲＳＤ为２．３％．对３２种常见的阴阳离子进行了干扰实验，表明方法具有较好的选择性。本法应用于水样及沉积物标样中痕量铅的测定，结果良好。     

Use of dynamic trees in a network simplex algorithm for the maximum flow problem

Goldfarb and Hao (1990) have proposed a pivot rule for the primal network simplex algorithm that will solve a maximum flow problem on ann-vertex,m-arc network in at mostnm pivots and O(n ² m) time. In this paper we describe how to extend the dynamic tree data structure of Sleator and Tarjan (1983, 1985) to reduce the running time of this algorithm to O(nm logn). This bound is less than a logarithmic factor larger than those of the fastest known algorithms for the problem. Our extension of dynamic trees is interesting in its own right and may well have additional applications.Research partially supported by a Presidential Young Investigator Award from the National Science Foundation, Grant No. CCR-8858097, an IBM Faculty Development Award, and AT&T Bell Laboratories.Research partially supported by the Office of Naval Research, Contract No. N00014-87-K-0467.Research partially supported by the National Science Foundation, Grant No. DCR-8605961, and the Office of Naval Research, Contract No. N00014-87-K-0467.