Selective detection of unknown organic bromine compounds and quantification potentiality by negative-ion electrospray ionization mass spectrometry with induced in-source fragmentation

For the detection of unknown organic bromine compounds, a liquid chromatography–mass spectrometry (LC-MS) method with negative-ion electrospray ionization (NI-ESI) and induced in-source fragmentation (IISF) was established. After LC separation, the molecules are fragmentized in the source, and bromide is detected via m/z 79 and m/z 81 based on the isotopic occurrence of bromine. In this way, the retention times of the unknown organobromine compounds are determined, and this can be used to extract additional structural information (number of bound bromine atoms, molecular mass and fragmentation scheme) from measurements in the commonly used but less sensitive scan mode. The analysis of known organobromine compounds shows that LC/NI-ESI-IISF mass spectrometry with detection of m/z 79 and 81 is more sensitive than the detection of daughter ions (LC/ESI/MS-MS). Therefore, we present a method not only for the detection of unknown organic bromine compounds, but also for the selective and sensitive detection and quantification of known organobromine compounds.     

Determination of levodopa methyl ester and its metabolites in rat serum by CZE with amperometric detection

A reliable and reproducible method, capillary zone electrophoresis with amperometric detection (CZE–AD), has been developed for separation and quantification of levodopa methyl ester (LDME) and its biotransformation products levodopa (L-DOPA) and dopamine (DA) in rat serum. A carbon-disk electrode was used as working electrode. The optimum conditions for CZE detection were 50 mmol L^–1 phosphate solution at pH 7.0 as running buffer, 17 kV as separation voltage, 1.0 V (vs Ag/AgCl, 3.0 mol L^–1) as detection potential, and sample injection for 8 s at 17 kV. The linear ranges were from 2.4×10^–2 to 2.2 g mL^–1 for LDME, 2.9×10^–1 to 49.5 g mL^–1 for L-DOPA, and 1.4×10^–2 to 1.5 g mL^–1 for DA with correlation coefficients of 0.9997, 0.9994, and 0.9999, respectively. The detection limits for LDME, L-DOPA, and DA were 14.6, 98.0, and 9.7 ng mL^–1, respectively. Recoveries were 80.3% for LDME, 93.5% for L-DOPA, and 86.5% for DA. This method was applied to serum samples after intravenous injection of LDME and L-DOPA to rats.     

应用安培检测-流动注射分析法快速测定制革废液中的硫

采用安培检测 流动注射分析法快速测定制革浸灰、脱毛工序废液中硫的含量,与常规的铁氰化钾法相比,不仅分析速度快(30～60s),测定准确,而且精度和灵敏度高,检测下限为0.10μmol/L,在制革工业中有广阔的应用前景.     

毛细管电泳-电化学法测定阿莫西林含量

阿莫西林(结构如图所示)是广谱半合成的青霉素,属于β-内酰胺类抗生素。阿莫西林胶囊的含量测定,有分光光度法、液相色谱法、毛细管电泳-光检法。电化学仪器简单,不受毛细管光程短的限制,特别是安培检测灵敏度较高。本文对其测定和分离条件进行研究,结果令人满意。     

Chemometric data analysis of pollutants in wastewater—a case study

In this study, chemometric techniques such as cluster analysis (CA), discriminant analysis (DA), principal component analysis (PCA) and partial least squares (PLS) were used to analyse the wastewater dataset to identify the factors which affect the composition of sewage of domestic origin, spatial and temporal variations, similarity/dissimilarity among the wastewater characteristics of cis- and trans-drains and discriminating variables. Samples collected from 24 wastewater drains in Lucknow city and from three sites on Gomti river in the month of January/February, May, August and November during the period of 5 years (1994-1999) were characterized for 32 parameters. The multivariate techniques successfully described the similarities/dissimilarities among the sewage drains on the basis of their wastewater characteristics and sources signifying the effect of routine domestic/commercial activities in respective drainage areas. Spatial and seasonal variations in wastewater composition were also determined successfully. CA generated six groups of drains on the basis of similar wastewater characteristic. PCA provided information on seasonal influence and compositional differences in sewage generated by domestic and industrial waste dominated drains and showed that drains influenced by mixed industrial effluents have high organic pollution load. DA rendered six variables (TDS, alkalinity, F, TKN, Cd and Cr) discriminating between cis- and trans-drains. PLS-DA showed dominance of Cd, Cr, NO₃, PO₄ and F in cis-drains wastewater. The results suggest that biological-process based STPs could treat wastewater both from the cis- as well as trans-drains, however, prior removal of toxic metals will be required from the cis-drains sewage. Further, seasonal variations in wastewater composition and pollution load could be the guiding factor for determining the STPs design parameters. The information generated would be useful in selection of process type and in designing of the proposed sewage treatment plants (STPs) for safe disposal of wastewater.     

Amperometric morphine sensing using a molecularly imprinted polymer-modified electrode

This study incorporates morphine into a molecularly imprinted polymer (MIP) for the amperometric detection of morphine. The polymer, poly(3,4-ethylenedioxythiophene), PEDOT, is an electroactive film that catalyzes morphine oxidation and lowers the oxidization potential on an indium tin oxide (ITO) electrode. The MIP-PEDOT modified electrode is prepared by electropolymerizing PEDOT onto an ITO electrode in a 0.1 M LiClO₄ solution with template addition (morphine). After template molecule extraction, the oxidizing current of the MIP-PEDOT modified electrode is measured in a 0.1 M KCl solution (pH = 5.3) at 0.75 V (versus Ag/AgCl/sat’d KCl) with the morphine concentration varying in the 0.1-5 mM range. A linear range, displaying the relationship between steady-state currents and morphine concentrations, from 0.1 to 1 mM, is obtained. The proposed amperometric sensor could be used for morphine detection with a sensitivity of 91.86 μA/cm² per mM. A detection limit of 0.2 mM at a signal-to-noise ratio of 3 is achieved. Moreover, the proposed method can discriminate between morphine and its analogs, such as codeine.     

Fabrication and performance of a three-dimensionally adjustable device for the amperometric detection of microchip capillary electrophoresis

A microchip CE-amperometric detection (AD) system has been fabricated by integrating a two-dimensionally adjustable CE microchip and an AD cell containing a one-dimensionally adjustable disk detection electrode in a Plexiglas holder. It facilitates the precise 3-D alignment between the channel outlet and the detection electrode without a complicated 3-D manipulator. The performance of this unique system was demonstrated by separating five aromatic amines (1,4-phenyldiamine, aniline, 2-methylaniline, 4-chloroaniline, and 1-naphthylamine) of environmental concern. Factors influencing their separation and detection processes were examined and optimized. The five analytes have been well separated within 140 s in a 74 cm long separation channel at a separation voltage of +2500 V using a 10 mM phosphate buffer (pH 3.5). Highly linear response is obtained for the five analytes over the range 20-200 microM with the detection limits ranging from 0.46 to 1.44 microM, respectively. The present system demonstrated long-term stability and reproducibility with RSDs of less than 5% for the peak current (n = 9). The new approach for the microchannel-electrode alignment should find a wide range of applications in CE, flowing injection analysis, and other microfluidic analysis systems.     

An online fiber-optic UV-visible detector for continuous free-flow electrophoresis

A PC-controlled, scanning online UV detector for continuous free-flow electrophoresis (CFFE) was designed to allow for single UV wavelength monitoring across a 1-D array of 48 longitudinal flow cells interfaced to a CFFE apparatus. In the detection scheme, the UV light is sequentially passed through each of the flow cells. The design integrates online acquisition of absorbance spectra of components separated by CFFE. Benzoic acid standard solutions were used to examine the performance of the detector. Chloroquine diphosphate and 4-nitrophenol were used as test solutes to determine the detector's ability to distinguish analytes separated in the CFFE.     

In-channel indirect amperometric detection of nonelectroactive anions for electrophoresis on a poly(dimethylsiloxane) microchip

In the present paper, we describe a microfluidics-based sensing system for nonelectroactive anions under negative separation electric field by mounting a single carbon fiber disk working electrode (WE) in the end part of a poly(dimethylsiloxane) microchannel. In contrast to work in a positive separation electric field described in our previous paper (Anal. Chem. 2004, 76, 6902-6907), here the electrochemical reduction reaction at the WE is not coupled with the separation high-voltage (HV) system, whereas the electrochemical oxidation reaction at the WE is coupled with the separation HV system. The electroactive indicator is the carbon fiber WE itself but not dissolved oxygen. This provides a convenient and sensitive means for the determination of nonelectroactive anions by amperometry. The influences of separation voltage, detection potential, and the distance between the WE and the separation channel outlet on the response of the detector have been investigated. The present detection mode is successfully used to electrochemically detect F-, Cl-, SO4(2-), CH3COO-, H2PO4-. Based on the preliminary results, a detection limit of 2 microM and a dynamic range up to three orders of magnitude for Cl- could be achieved.     

Determination and Differentiation of Two Seemingly Identical Medicinal Herbs by Capillary Electrophoresis with Electrochemical Detection

A high-performance capillary electrophoresis with electrochemical detection (CE-ED) method has been employed for the determination of six bioactive ingredients in traditional Chinese herbs, Herba cepbalanoplosis segeti and Herba cirsii japonici. The effects of several factors such as the acidity and concentration of running buffer, the separation voltage, the applied potential and the injection time on CE-ED were investigated. Under the optimum conditions, the six analytes could be well separated within 21 min in a 75 cm length capillary at the separation voltage of 15 kV in a 50 mmol L^–1 borax running buffer (pH 8.4). A 300 m diameter carbon disk electrode was used as the working electrode positioned carefully opposite the outlet of the capillary in a wall-jet configuration at potential of +950 mV (vs. SCE). Good linear relationship was established between peak current and concentration of analytes over two orders of magnitude with detection limits (S/N=3) ranged from 1.5×10^–7 to 6.0×10^–7 g mL^–1 for all six analytes. This proposed method has been successfully applied for the analysis of traditional Chinese herbs after a relatively simple extraction procedure, further on, for the differentiation of these above two seemingly identical herbs based on their electropherograms or characteristic electrochemical profiles.