电极条件对硫酸介质中电解还原提纯镱过程的影响

研究了以钌铱钛合金网和汞分别为阳、阴电极, 在无气氛保护条件下, 采用电解还原方法从铥、镱、镥硫酸盐溶液中分离提纯镱的过程. 讨论了在8 V恒电压时的电极间距、位置, 以及阴、阳极表面积对电解过程中的电流、还原率影响. 优化了电解还原过程, YbSO4产品的纯度稳定达到99.5%以上, 一次收率可达80%;提镱后母液中的铥和镥被富集4倍以上, 其中Lu含量高于50%, 十分有利于后续铥/镥分离.     

壳聚糖修饰玻碳电极卷积伏安法测定环境水中的EDTA

制备了壳聚糖修饰玻碳电极 ,研究了Fe(EDTA) -在修饰电极上的吸附还原行为 ,用卷积伏安法通过Fe(EDTA) -的检测测定了环境水中的EDTA。在优化的实验条件下 ,峰电流值与 8.0× 1 0 -7～ 5 .0× 1 0 -6mol L的EDTA呈线性关系 ,回归方程为epp′ =0 .75 2 5c - 0 .661 3,r =0 .991 ,最低检出限为 5 .0× 1 0 -7mol L ,5次测定的相对标准偏差小于 5 .8%。对实际样品测定的回收率为98 1 %～ 1 0 5 % ,对比HPLC的结果 ,相对偏差小于 5 %。     

电化学方法获得具有表面增强拉曼活性镍电极的研究

利用纯电化学手段获得了具有较强表面增强拉曼活性的镍电极, 改进了原有的镍电极表面预处理方法. 结果表明, 在0.5 mol/L的NaClO4溶液中, 结合电化学阶跃技术和循环伏安技术, 可以得到合适的粗糙镍电极; 同时, 还得到了探针分子吡啶在该粗糙镍电极表面随电极电位变化的表面增强拉曼光谱(SERS), 此时谱峰强度获得了极大的增强; 还研究了粗糙镍电极的扫描电子显微镜(SEM)图像, 并估算出其SERS增强因子约为104, 此结果比以前的镍电极表面粗糙方法所能达到的增强因子高一个数量级.     

Characteristic behavior of macro-, semimicro- and microelectrodes in voltammetric and chronoamperometric measurements

The advantages of microelectrodes such as the improvement of signal-to-noise ratio, the ability to perform electrochemical measurements in high resistive solutions and small RC-time constants give the possibility of an extended use for voltammetric and chronoamperometric techniques in analytical chemistry. In this comparative study, the microelectrode properties of three selected electrodes were examined. The characterization of a RAM-microarray electrode, an epoxy-impregnated carbon electrode and a conventional glassy carbon macroelectrode was performed by cyclic voltammetry at different scan rates, by DP-voltammetric measurements using different concentrations of supporting electrolyte and by transient measurements. It could be shown, that in comparison to the microarray electrode and to the glassy carbon macroelectrode, respectively, the results obtained by using the epoxy-impregnated carbon electrode are caused by its semimicroelectrode character.     

聚乙烯醇缩丁醛膜涂丝酶电极构造方法的研究

本文以三月桂胺为中性载体制成聚乙烯醇缩丁醛膜涂丝pH电极,再以该pH电极为换能器,采用三种共价交联固定化酶方法制成涂丝乙酰胆碱酯酶电极。该酶电极能用于测定0.1～10mmol/L浓度范围内的乙酰胆碱,响应时间在3～6min之内,寿命可达两个多月。     

An Inexpensive Biosensor for Uric Acid Determination in Human Serum by Flow‐Injection Analysis

An inexpensive and easy to construct miniaturized biosensor is described for the determination of uric acid in biological fluids. The amperometric biosensor was prepared by using a carbon paste electrode prepared with uricase from Arthrobacter globiforms and tetracyanoquinodimethane as electron transfer mediator. When incorporated into a flow‐injection system it was enabled to perform 50 measurements/h of uric acid in the analytical range of 1–100 μmol dm^?3 with a relative standard deviation of 0.20% (n=14). The system was applied to human serum samples analysis providing good data correlation with those obtained by the reference spectrophotometric method. A linear relationship AM (μmol dm^?3)=1.02 (±0.05) SP (μmol dm^?3) ?0.12 (±0.13) was obtained evidencing the absence of significant error. The constructed biosensor was successfully used for at least four months (250 assays) with only a 13% of decrease in the enzymatic activity.     

聚酰胺修饰碳糊电极测定槲皮素的研究

用聚酰胺修饰碳糊电极在ｐＨ３６０的Ｂｒｉｔｏｎ－Ｒｏｂｉｎｓｏｎ缓冲溶液中，将槲皮素开路富集一定时间后，从０４５Ｖ（ｖｓ．Ａｇ／ＡｇＣｌ）向阴极化扫描至－０５５Ｖ获得Ｉ－Ｅ曲线。槲皮素的峰电位为０１８Ｖ。峰电流与槲皮素浓度在１０～４００μｍｏｌ／Ｌ范围内呈良好的线性关系。所拟定方法用于芦丁水解产物测定，结果满意。     

互通多孔碳/二氧化锰纳米复合材料的原位水热合成及电化学性能

以互通多孔碳（IPC）为载体，水热条件下在碳表面原位反应生成纳米结构的二氧化锰（MnO₂），制备互通多孔碳/二氧化锰纳米（IPC/MnO₂）复合电极材料. 采用扫描电镜（SEM），透射电镜（TEM），X射线衍射（XRD），热重分析（TGA）对其结构进行表征；采用循环伏安法、恒流充放电和交流阻抗对其电化学性能进行研究. 结果表明：生成的MnO₂均匀地负载在碳的表面，形成多层次结构，并且随着温度的升高IPC表面负载的MnO₂由纳米颗粒变为纳米片状结构；MnO₂纳米片具有典型的K-Birnessite 型晶体结构；复合物中MnO₂的含量约为34%（w）. 在100 ℃制备的IPC/MnO₂复合材料在三电极系统中最高比电容达到了411 F·g^-1；随着反应温度的升高,比容量先增长后基本保持不变. 以IPC/MnO₂为正极，活性炭（AC）为负极，1 mol·L^-1 Na₂SO₄溶液为电解液组装成IPC/MnO₂//AC 混合超级电容器，发现IPC/MnO₂电极的电容器其电位窗口从1 V扩展到1.8 V，容量可达86F·g^-1，且表现出良好的电容特性和大电流放电性能.     

Microchip capillary electrophoresis with amperometric detection for several carbohydrates

Microchip capillary electrophoresis (μCE) with amperometric detection at Cu electrode benefited fast separation and direct detection of carbohydrates. The working electrode of 50-μm Cu wire attached nearly against the channel outlet—4 μm, where it benefited collecting detection current and suppressing overwhelming noise. The use of alkaline medium was essential to separating and detecting carbohydrates, which dissociated into the sensitive alcolate anions. The 10-cm serpentine chip, though lengthening the migration time, it provided better efficiency. Sucrose, cellobiose, glucose, and fructose migrated from the outlet in 400 s +2000 V. The linear calibration plots ranging from 10 to 1000 μM with regression coefficients better than 0.996 were obtained. The injection-to-injection reproducibility of 1.24% (n=7) for glucose in peak current and 0.6% for migration times were excellent. The detection limit was low, down to 2.3 μM for glucose (S/N=3) or 27.6 attomole in mass detection.