建筑物变形观测的过程控制与安全措施

分析了引起建筑物变形的原因及建筑物变形的类型，介绍了建筑物变形观测的实施过程及具体方案，并根据观测结果提出了确保施工与建筑物使用的安全措施。     

Influence of chemistry and hot rolling conditions on high permeability non-grain oriented silicon steel

This paper discusses the influence of chemical composition on the final electromagnetic properties in higher permeability material. Furthermore, the effect of the hot rolling practice and the end of austenite transformation temperature range on the hot band microstructure is described. The magnetic polarization J₅₀₀₀ better than 1.7 T, using hot rolling conditions 40 mm transfer bar thickness, finish mill entry temperature 1000 °C, and finishing temperature 800–840 °C and after decarburization heat treatment and grain growth treatment, was obtained.     

外电场下光聚合反应动力学的表征方法

外电场下光聚合反应动力学的表征方法李从武，潘昂上海材料研究所，上海２０００８２）关键词光聚合反应、液晶、外电场、动力学、表征近年来，液晶单体在外场（电场、磁场和剪切力）下在位光聚合反应的研究工作受到了很大的关注［’，ＺＩ．众所周知，热致型侧链高分子液...     

Ni-SDC固体氧化物燃料电池阳极的合成和性质

采用柠檬酸-硝酸盐溶胶-凝胶低温自蔓延燃烧法制备氧化镍（NiO）粉末和Ce0.8Sm0.2O1.9（SDC）粉末，并将NiO与SDC按不同质量比和不同制备工艺制备了固体氧化物燃料电池（SOFC）的阳极前身。再用自组装的还原装置将其在820℃经2．5h还原后，采用四端子法测量其电导率值。分析了阳极片电导率与阳极片微结构、Ni的质量百分数、混合研磨时间及烧结温度之间的关系。结果显示，阳极片的电导率强烈依赖于镍含量和制备工艺。     

Darstellung und Kristallstruktur von TICu[CuO2]

Investigations on Electronically Conducting Oxide Systems. XVI. Solid Solutions and Conductivity in the System MgTi₂O₅? Ti₃O₅ Solid solution formation is reported for the system Mg_1–xTi_2–x^IVTi_2x^IIIO₅. With increasing x there is at room temperature a transition from the orthorhombic pseudobrookite structure to the monoclinic low-temperature modification of Ti₃O₅. The X-ray diffraction pattern results are supported by DSC measurements, electrical and magnetic investigations. The tendency of Ti? Ti pair formation in the low-temperature Ti₃O₅ structure is accompanied by a drop of the activation energy for electrical conductivity and a decreasing susceptibility at high Ti^III concentrations.     

Development of a new analytical method for the evaluation of hazards from slow decomposition of waste streams and process solutions

A wide variety of liquid streams are generated as part of the process research and development effort. Frequently these streams are drummed off, either as intermediates that must be held for processing or as wastes that must be sent off-site for disposal. Because of the long times and low concentrations often involved, current thermoanalytical techniques were inadequate to detect the potential of streams to generate gas. A custom-made apparatus, the gas evolution test cell (GETC), was developed in the Merck Research Laboratories to measure the gas generation potential of various streams under precisely defined conditions, is the key innovation for the development of a quantitative gas-generation test method.     

Synthesis and thermal stability of the resins prepared from the reactions of 1,4-bis(2,2-dicyanovinyl)benzene with aromatic diamines and electrical conductivity of the resulting materials following pyrolysis

New thermosetting resins were prepared from the reaction of 1,4-bis(2,2-dicyanovinyl)benzene with aromatic diamines in varying molar ratios. The thermal stability of these resins was correlated with their composition and the curing conditions. They were stable in N₂ up to 370–448°C and afforded anaerobic char yields of 73–84% at 800°C after curing at 300°C for 20–60 h. The temperature dependence of the electrical resistivity of all resins pyrolyzed at 700°C for 15 h was studied in the temperature range from ?173–327°C (100–600 K). The results showed that at room temperature the unpyrolyzed polymers have insulating properties, whereas a dramatic decrease in the electrical resistivity is observed following pyrolysis. The temperature dependence of the electrical resistivity suggests that all of the materials studied have semiconducting properties. The observed electrical conductivity is thermally activated with activation energies ranging from 0.03–0.06 eV. © 1994 John Wiley & Sons, Inc.     

Effect of Inorganic Ions on Oleate Adsorption at a Nigerian Hematite–Water Interface

Using “pure” natural hematite selected from a high silica Nigerian hematitic ore, oleate adsorption densities at the hematite–water interface were determined in the presence of various inorganic ions (anions and cations) of different charges and at varying concentrations. Adsorption density was determined using electrical conductivity measurements. The specific surface area of the hematite particles was determined using the method of adsorption of paranitrophenol in aqueous solution. Inorganic ions in solution depressed oleate adsorption at the aqueous hematite surface. The charge of the ion proved to be the dominant factor determining the depression of oleate adsorption. Ionic strength also was an influence, up to a limiting value at which monolayer oleate coverage of the hematite surface occurred. The inorganic ions in solution are considered to function through nonspecific adsorption in the diffuse region of the electric double layer.     

Synthesis and characterization of oligo-4-[(pyridin-3-ylimino)methyl]phenol

The oxidative polycondensation of 4-[(pyridin-3-ylimino)methyl]phenol (4-PIMP) with O₂, H₂O₂, and NaOCl was studied in an aqueous alkaline medium between 50°C and 90°C. Oligo-4-[(pyridin-3-ylimino)methyl]phenol (O-4-PIMP) prepared was characterized by ¹H-NMR, ¹³C-NMR, FT-IR, UV-VIS, size-exclusion chromatography, and elemental and thermal analyses techniques. At the optimum reaction conditions, the yield of O-4-PIMP was 18.9%, 39.4%, and 46.8% using H₂O₂, O₂, and NaOCl oxidant, respectively. According to the TG analysis, the initial degradation temperature of O-4-PIMP was 218°C, which was by 50°C higher than that of 4-PIMP. Thermal analyses of 4-PIMP and O-4-PIMP were carried out in N₂ atmosphere at 15–1000°C. The highest occupied molecular orbital, the lowest unoccupied molecular orbital, and electrochemical energy gaps of 4-PIMP and O-4-PIMP were determined from the onset potentials for n-doping and p-doping, respectively. Also, optical band gaps of 4-PIMP and O-4-PIMP were determined according to UV-VIS measurements.