Uniformity in radon exhalation from construction materials using can technique

The uniformity in radon exhalation rates for 46 tiles of granite, marble and ceramic used as construction materials were determined using “Can Technique” employing CR-39 nuclear track detectors (NTDs). On each tile, two sealed cans, each enclosing one NTD fixed at the center of the tile surface area covered by the can, were mounted at two different locations of each individual tiles. The track production rates on the NTDs representing radon exhalation rates were measured. The radon exhalation rates from the surface of individual tiles showed uniform exhalations within the calculated uncertainties of the measured values. This makes Can Technique an alternative simple method to measure radon exhalation rates. Calibration required to convert track production rates into radon exhalation rates for the used can and NTD was done using an active technique. The correlation between the measurements by the two techniques shows a good linear correlation coefficient (0.83).     

单光子探测器量子效率的绝对自身标定方法

提出一种单光子探测器量子效率的绝对自身标定方案，利用光参量下转换过程中产生的光子对在时间上的相关性，先将参量光束分为两路，然后引入相对延时，使同时产生的孪生光子先后进入单光子探测器，然后将探测器之后的电路分为三路，其中一路直接进入计数器得到探测器所探测到的光子的总计数率，另两路用电路方法引入和光路相当的相对延时，经符合电路后进入计数器，得到前后到达探测器的光子对之间的符合计数率.这样，从符合计数率与总光子计数率之比即可在不需要任何其他探测器或者参照标准的情况下获得探测器的量子效率.文中给出两种方案，分别适     

强直电流伸展弧CVD硬质合金金刚石涂层工具

采用自行研制的强电流直流扩展电弧设备对酸浸和渗硼预处理的YG6刀片进行了金刚石薄膜涂层沉积，并对放于不同位置的沉积刀片表面涂层的激光Raman谱和SEM形貌进行了分析、研究。结果表明：渗硼预处理工艺优于酸浸预处理工艺；在渗硼处理的GY6刀片上，沉积的金刚石薄膜涂层具有大面积、均匀性好和质量高的特点。     

Memory effects in gas chromatographic detection with a microwave-induced plasma

Capillary gas chromatography coupled to microwave-inducedplasma detection furnishes sensitivity adequate for trace analysis when the signal is monitored at a carbon emission line. Work performed with one of these systems at high electronic gain for the carbon signal has revealed solvent band widths in excess of four minutes; these impeded quantification of peaks eluting after the solvent. This report discusses two phenomena which could be related to the unexpected intensity of this solvent response: photomultiplier tube saturation and carbon deposits in the quartz plasma discharge tube.     

托卡马克能量约束及自举电流效应的初步考虑

基于Lee等人的离子温度梯度模导致的反常热能输运系数,本文研究了辅助加热托卡马克等离子体的能量约束行为,并对自举电流的效应作了初步考虑。结果表明,计算得到的能量约束时间随等离子体电流I_p和托卡马克大半径R增大而增长,随注入功率P_t、环向场B_t以及等离子体小半径α的增大而缩短。这些结果与Kaye-Goldston的经验约束定标具有相同的趋势。自举电流的存在总是导致能量约束时间的增加,当自举电流与总电流的比值γ较小时,能量约束时间的增加率约为γ/2。此外,自举电流将造成锯齿反转半径的减小。     

防止PWM逆变器直通短路的原理及应用

本文提出了通过上下桥臂开关电流互访与联锁、故障断诊、故障处理与记忆等措施,消除PWM逆变器上下桥臂同时直通短路的新原理,并提供了实验验证的结果.     

单电极直流电弧炉电热特性理论研究

运用电磁理论与流体静压力原理,导出了电弧自身的电磁向心压缩力以及电弧对熔池冲力的解析式。又运用辐射传热原理,导出了单电极电弧对熔池与炉衬辐射传热的解析式。解析式揭示出电弧自身电磁向心压缩力、电弧对熔池冲力,单电极电弧对熔池以及对炉衬辐射传热的规律。     

惯性约束中子测温的误差研究

综合分析了ＩＣＦ（惯性约束）中子测温系统的误差与其参数的关系，这些参数包括靶核温度，探测的中子数、靶到探测器的距离、探测器的响应函数以及闪烁体厚度等，考虑到中子与探测器的相互作用，探测器的响应与靶的烧蚀过程，在此基础上提出了新的统计误差计算方法，该方法对于改善中子测温的相对误差并应用于闪烁体的设计具有重要意义。     

相对论带电粒子经典多体问题

为建立相对论经典等离子体统计力学作准备，讨论了相对论带电粒子经典多体问题，重点分析相对论流线分布函数和动力学方程组。     

Optical current transducer with bulk type Bi12SiO20 faraday sensor for power systems

Two types of optical current transducers (OCTs) have a bulk Faraday sensor inserted into the gap of an iron core and a porcelain insulator with optical fiber. The sensor consists of Bi₁₂SiO₂₀ (BSO) single crystal, a polarizer, and an analyzer. The OCTs satisfied the target performance requirement for fault location and metering and demonstrated maintained performance at some power utilities in Japan and the US. We have developed a fault location system that immediately detects the fault current with the OCTs, there by locating the fault section. The OCT can easily replace the existing support insulators for the disconnecting switch without any modifications to structure height or bus-bar. For metering requiring 0.3% class accuracy, use of a BSO with right optical rotatory power combined with BSO with left optical rotatory power results in a Faraday sensor with improved temperature characteristics. The OCT demonstrated 0.3% class accuracy for metering described in the current transformer Specifications of IEEE C57–13, 1993.