PHASE INVERSION AND ITS MECHANICAL MODEL STUDIES FOR THE TWO-PHASE POLYMER BLEND SYSTEMS (Ⅱ)——DYNAMIC VISCOELASTIC RESPONSE

The dynamic viscoelastic response of the two-phase polymer blend systems shows the characteristics of the thermorheologically complex materials. In this paper theoretical equations for describing the dynamic viscoelastic response of such polymer blend systems have been established by means of the mechanical modeling technique. The dynamic viscoelastic response of the blend systems at any blend composition can be predicted theoretically by using the equations established, provided that the dynamic viscoelastic response of the two pure components and the mechanical model parameters are known in advance. Thus, we provide an effective method for studying the dynamic mechanical properties and the molecular relaxation characteristics of the two-phase polymer blend systems.     

Quantitative determination of UV filters in sunscreen lotions using microemulsion electrokinetic chromatography

Microemulsion electrokinetic chromatography (MEEKC) has been applied to the separation of some UV filters (Eusolex 4360, Eusolex 6300, Eusolex OCR, Eusolex 2292, Eusolex 6007, Eusolex 9020, Eusolex HMS, Eusolex OS, and Eusolex 232) commonly used in sunscreen lotions. Use of a MEEKC buffer with a mixed surfactant system to stabilize the oil droplets and an organic modifier in the aqueous phase allowed separation of most of the selected analytes in a single run in a system fitted with a diode array detector recording three wavelengths (240 nm, 300 nm, and 380 nm) simultaneously. The microemulsion employed consisted of 2.25 g of SDS, 0.75 g of Brij 35, 6.6 g 1‐butanol, 0.8 g n‐octane, 17.5 g 2‐propanol, and 72.1 g of 10 mM borate buffer (pH 9.2). Detection limits from 0.65 to 6.0 μg/mL were obtained and the calibration plots were linear over at least one order of magnitude for all analytes. The developed method could be applied to the determination of UV filters in several sun protection products including lotions, milks, and oils. Comparison of the obtained data with those from an HPLC method described in the literature showed acceptable agreement.     

D072型树脂脱除过氧化氢中金属阳离子的工艺研究

实验考察D072型阳离子交换树脂在交换柱中脱除过氧化氢中微量金属阳离子的动态行为．通过改变料液流速、高径比、料液中交换离子浓度及料液组成等参数，绘制不同条件下的透过曲线，以此考察D072型树脂对过氧化氢中金属阳离子的动态交换性能，从而确定适宜的工艺条件，为工业化生产提供科学依据．     

高速磁浮车-轨耦合系统动态机理与振动响应

对高速磁浮车-轨耦合系统进行动态机理和振动响应研究。首先,对高速磁浮中的各类耦合关系进行建模;其次,分别分析了动态和静态条件下的车-轨耦合作用机理;然后,建立了高速磁浮车-轨耦合动力学有限元模型;最后,对磁浮列车高速通过桥梁时轨道梁、功能件的动力响应和车-轨共振速度进行分析。结果表明：高速运行时车-轨作用频率不同,长时间共振速度下运行时车-轨振动明显增大;若桥梁动力放大系数小于1.2,则基频比最小值为1.16;若桥梁动力放大系数小于1.3,则基频比最小值为1.04。     

震区中小跨径桥梁墩柱配筋率取值范围

为研究配筋率对钢筋混凝土桥梁延性抗震性能的影响,并在不同设防烈度对主筋配筋率的合理取值进行细分。以钢筋混凝土桥梁为研究对象,通过拟静力模型试验与有限元数值分析的方法,研究竖向钢筋(主筋)配筋率对桥墩延性的影响,提出典型桥墩的多级性能水平量化指标;并探究在氯离子侵蚀的恶劣环境下,不同配筋率对桥梁抗震性能所带来的影响,从而对氯离子侵蚀环境下的震区中小跨径桥梁墩柱配筋率取值范围提供参考建议。结果表明：考虑氯离子侵蚀作用下的恢复力模型能够较好地反映刚度的退化特性,墩柱的最佳配筋率取值范围为1.11%～2.72%;当加速度为0.3g(g为重力加速度)时,仅从配筋率的角度已无法满足墩柱的损伤指标,建议采用减隔震体系进行抗震设计,如采用延性体系时配筋率不得小于2.64%。研究结果可为中小跨径连续桥梁抗震设计提供参考。     

动态可控残差卷积神经网络的低剂量 CT 图像处理

针对计算机断层扫描(Computed Tomography, CT)中因采用低剂量扫描方式,导致图像噪声伪影干扰,尤其 是不同部位噪声和伪影强度存在较大差异这一问题,提出了一种基于动态可控残差的卷积神经网络(DC-ResNet) 算法。 DC-ResNet 的主要思想是在常规残差网络连接中添加一个图像质量指导的控制变量,以允许获取残差的加 权和,从而实现残差特征的动态可控。 所设计的 DC-ResNet 网络是一种包括两个子网络的组合型结构,一个是作 为主干网络的基础子网络,在该子网络中使用全局动态残差块和局部动态残差块来实现低剂量 CT 图像质量的提 高;另一个是作为辅助网络的条件子网络,用来生成基础子网络中不同动态可控残差块的权值,辅助基础子网络的 学习。 通过 Mayo 与 UIH 数据实验验证,其视觉结果表明:处理后的不同部位 CT 图像噪声伪影均能够得到较好的 抑制,并能有效地保留结构细节及组织纹理;量化结果表明:处理后的 CT 图像峰值信噪比( Peak-Signal to Noise Ratio, PSNR)和结构相似性(Structure Similarity, SSIM)均优于对比方法。     

适用于DC/DC 变换器的预测函数控制优化策略

针对使用预测函数控制(Predictive Function Control, PFC)的 DC / DC 变换器在负载切换时产生的扰动对变 换器响应速度有较大影响的问题,提出通过设计观测器观测扰动来优化预测函数控制算法的控制效果;相对于其 他提高系统抗扰动的方法,通过设计观测器来提高变换器抗扰动的方法的优点是实现简单、优化后控制效果好等; 设计 Luenberger 观测器对负载切换时产生的扰动进行观测,将观测值反馈给预测函数控制算法进行最优化分析, 并结合仿真结果对目标函数进行调整,优化后的目标函数能更好地响应扰动并尽快达到稳态;最后将优化后的控 制算法与 PI 双闭环控制方法进行比较,结果显示优化后的控制算法在受到扰动后比双 PI 控制方法动态性能更 好,实现了应对负载切换时提高系统动态性能的目标,增强了 DC / DC 变换器的抗干扰能力;优化后的算法只考虑 了负载切换时的扰动对于系统其他方面的扰动没有考虑进去,可以通过设计整个系统的观测器来进一步提高 DC / DC 变换器抗扰动的能力。     

Critical slope gradient for compulsory abandonment of farmland on the hilly Loess Plateau

Scientific evidence for the upper limit of farmland is proposed. Shallow gully erosion is one of erosion types distributed extensively on sloping farmland in the hilly regions of the Loess Plateau. Field observation and aerial photos interpretation, as well as laboratory experiments show that the shallow gully erosion occurring on the steeper farmland in the hilly regions of the Loess Plateau is an important factor leading to intensive erosion on slope, because of its extensive distribution and intensive runoff collection. The data on the formation, development and distribution of shallow gullies on sloping farmland indicate that critical slope gradient for shallow gully initiation ranges from 15 to 20 degrees with an average of 18.2 degrees. Therefore, it is suggested that critical slope gradient for compulsory abandonment of farmland on the hilly Loess Plateau should be kept within the critical slope gradient for shallow gully initiation to prevent shallow gully formation in order to control soil loss more effectively. But as the first step, the cultivation on the slopes with slope larger than 25 degrees where the maximum erosion occurs should be strictly forbidden.     

连续滚动生产作业安排中初始状态非平凡的P//C_(max)问题

以实际中连续滚动生产为背景,研究了一类新的平行机作业安排问题,即初始状态非平凡的Ｐ∥Ｃ_ｍａｘ问题。基于经典的Ｂｉｎ－ｐａｃｋｉｎｇ（装箱）理论和技巧,提出改进的Ｍｕｌｔｉｆｉｔ算法及相应的ＩＦＦＤ装法,并分析算法在最坏情况下的性能指标上界为４／３．最后,提出连续生产中周期滚动式作业安排的实施算法,实现了设备不空闲而连续运行。     

冷热兼供热泵空调器的性能模拟与分析

针对冷热兼供热泵空调器的特点,建立了冷热兼供热泵空调器稳态运行的数学模型,对该系统进行了较全面的模拟分析,并将模拟结果和实验数据进行了比较,两者吻合良好．同时应用该软件对不同设备参数和不同工况下性能进行分析,得到若干有用的结果．