Migration of Ethylene Terephthalate Oligomers from Roasting Bags into Olive Oil

Summary A high-performance liquid-chromatographic method with UV detection (HPLC–UV) has been developed for quantification of ethylene terephthalate oligomers in olive oil, from which they were extracted with acetonitrile. Oligomers, from monomers (M₁) to pentamers (M₅), were jointly and/or individually identified by liquid chromatography with mass spectrometry (electron-impact mass spectrometry (EIMS) low- and high-resolution) and were quantified by HPLC–UV using an acetonitrile solution of the major oligomer (the trimer M₃) as standard. For M₃ recovery was 98.9%, the detection limit was 60 g L^–2, and method precision was 2.03% (RSD). Migration of oligomers M₁–M₅ into 50 mL olive oil sealed in each of two brands of 10 cm × 10 cm poly(ethylene terephthalate) roasting bag was evaluated under two sets of conditions that approached but remained below the limit at which the bag material became physically deformed – heating for 7 min at 850 W in a microwave oven, or for 60 min at 200 °C in a conventional oven. Total migration was approximately 2.7 mg dm^–2 under the former conditions and 3.5–4.1 mg dm^–2 under the latter.Presented at the International Symposium on Separation and Characteristics of Natural and Synthetic Macromolecules, Amsterdam, The Netherlands, February 5–7, 2003     

无机阴离子的毛细管电泳分析

本文研究了常见无机阴离子的毛细管电泳规律，考察了分离电压、电解质熔液组成、浓度、ｐＨ值等对分离的影响，建立了高效、快速的无机阴离子毛细管电泳分析方法。在选定的实验条件下，各种常见无机阴离子在５ｍｉｎ内达到完全分离，对Ｂｒ＾－和Ｃｌ＾－的分离柱效每米可达７６万理论板数。迁移时间的相对标准偏差小于１％，峰面积的相对标准偏差小于５％，各离子的最低检测浓度为０．０５￣０．５μｇ／ｍｌ。     

Surface modification by calcium ions—Effect on chromatographic properties of silica

Summary A liquid chromatographic method incorporating column-switching and fluorimetric detection for the determination of triamterene in untreated urine, is described. The urine samples (5 L) were directly introduced onto an Hypersil ODS-C18, 30 m (20 mm×2.1 mm I.D.) pre-column. Polar urinary compounds were removed by flushing the pre-column with water for 1 min, and the analyte was then switched onto an HP-LiChrospher RP C18,5 m (125 mm×4mm ID) analytical column using an acetonitrile/phosphate buffer gradient elution. Fluorescence detection was performed at 230 nm excitation and 430 nm emission wavelengths. The recovery of drug was 102±2% in the 0.10–20.0 g/mL concentration range, the limit of detection being 5 ng/mL. A validation of the usefulness of this procedure was accomplished by analysing urine extracts obtained from real samples.Hypersil ODS is not a product of Merck, Germany. Please give supplier (p. 5).     

A study for quality evaluation of Taxilli Herba from different hosts based on fingerprint-activity relationship modeling and multivariate statistical analysis

In this study, a fingerprint-activity relationship modeling between chemical fingerprints and antirheumatic activity was established, and multivariate statistical analysis was used to evaluate the quality of Taxilli Herba (TH) from different hosts. Characteristic fingerprints of 20 batches of TH samples were generated by high-performance liquid chromatography coupled with triple quadrupole-time of flight tandem mass spectrometry (HPLC-Triple TOF-MS/MS), and the similarity analysis was calculated based on thirteen common characteristic peaks by hierarchical clustering analysis (HCA). Subsequently, nine efficacy markers were discovered by combining fingerprints and antirheumatic activity through grey correlation analysis (GCA) and bivariate correlation analysis (BCA). Meanwhile, the content of 5 constituents in 9 markers was determined by high-performance liquid chromatography coupled with triple quadrupole-linear ion trap tandem mass spectrometry (HPLC-QTRAP-MS/MS). The comprehensive quality of TH was assessed using multivariate statistical analysis, including principal components analysis (PCA) and technique for order preference by similarity to ideal solution (TOPSIS). The results showed that a high dose of TH extract could markedly ameliorate arthritis damage compared to other doses, with flavonoids playing an important role in the antirheumatic activity. The comprehensive quality of samples from Morus alba L. (SS) was superior to those from Liquidambar formosana Hance (FXS). The present study will demonstrate the markers associated with efficacy, and provide an applicable strategy for more comprehensive quality control and evaluation of TH.     

Quantitation of agmatine by liquid chromatography with laser-induced fluorescence detection

A high performance liquid chromatography (HPLC) method is described for the determination of agmatine, an endogenous neuromodulator. The method involves pre-column derivatization of the sample with a fluorescent tagging reagent, 7-fluoro-4-nitrobenzoxadiazole (NBD-F). The resulting agmatine derivative is stable and can be readily extracted into ethyl acetate at pH 8.5. The extraction enhances the quantification of low level agmatine because it eliminates chromatographic peaks caused by endogenous amino acids. The HPLC separation is carried out on a C₈ reversed phase column and completed in less than 10 min. With laser-induced fluorescence (LIF) detection, the detection limit is 5×10⁻⁹ M agmatine. Method precision (coefficient of variation) is 5% for agmatine in human plasma at the sub-μM level. This method has been validated by determination of agmatine in biological samples including human plasma and rat brain and stomach tissues.     

A microfabricated capillary electrophoresis chip with multiple buried optical fibers and microfocusing lens for multiwavelength detection

We present a new microfluidic device utilizing multiwavelength detection for high-throughput capillary electrophoresis (CE). In general, different fluorescent dyes are only excited by light sources with appropriate wavelengths. When excited by an appropriate light source, a fluorescent dye emits specific fluorescence signals of a longer wavelength. This study designs and fabricates plastic micro-CE chips capable of performing multiple-wavelength fluorescence detection by means of multimode optic fiber pairs embedded downstream of the separation channel. For detection purposes, the fluorescence signals are enhanced by positioning microfocusing lens structures at the outlets of the excitation fibers and the inlets of the detection fibers, respectively. The proposed device is capable of detecting multiple samples labeled with different kinds of fluorescent dyes in the same channel in a single run. The experimental results demonstrate that various proteins, including bovine serum albumin and beta-casein, can be successfully injected and detected by coupling two light sources of different wavelengths to the two excitation optic fibers. Furthermore, the proposed device also provides the ability to measure the speed of the samples traveling in the microchannel. The developed multiwavelength micro-CE chip could have significant potential for the analysis of DNA and protein samples.     

A surface plasmon resonance biosensor for detecting Pseudomonas aeruginosa cells with self-assembled chitosan-alginate multilayers

A self-assembled multilayer (SAMu) including the alginate layer was prepared for detecting Pseudomonas aeruginosa cells in a solution and its potential was evaluated with a BIAcore system. After layer-by-layer formation, the refractive units (RU) values monitored with the biosensor increased by the interaction between the layers. The responses by the binding of P. aeruginosa cells to the alginate-immobilized SAMu were visualized immediately upon injection of the cell suspension. The RU values after injection of the cells were measured with approximately 1152, 656 and 173 for 1 × 10⁹, 1 × 10⁸ and 1 × 10⁷ CFU/ml. This result suggests that the alginate-immobilized SAMu will have useful application for detecting P. aeruginosa cells in a biosensor analysis.     

An automated analyzer for vancomycin in plasma samples by column-switching high-performance liquid chromatography with UV detection

An automated analyzer for vancomycin in rat plasma by column-switching high-performance liquid chromatography (HPLC) with UV detection was developed. The method includes in-line extraction of vancomycin by ion-exchange cartridge column and a separation on a reversed-phase column with UV detection at 215 nm. Plasma samples were diluted by mobile phase solution and directly injected to HPLC. Vancomycin was quantitatively recovered from rat plasma samples. The separation was completed within 15 min. The calibration curve was linear over the range from 0.5 to 100 microg/mL with the detection and quantification limits of 0.5 microg/mL (2.5 ng on column; signal-to-noise ratio = 3). The values of precision in intra- and inter-day assays (n = 3) were less than 1.92 and 3.69%, respectively. This method does not require time-consuming pre-treatment and is suitable for the routine assay of plasma samples.     

Detection of Escherichia coli O157:H7 bacteria by a combination of immunofluorescent staining and capillary electrophoresis

As the number of incidents of bacterial infections continues to rise around the globe, simpler, faster, and more sensitive diagnostic techniques are required to improve the safety of the food supply and to screen for potential bacterial infections in humans. We present here direct and indirect approaches for the detection of bacteria, which are based upon a combination of immunofluorescent staining and capillary electrophoresis. In the direct approach, Escherichia coli O157:H7 bacteria stained with fluorescein-tagged specific antibodies are detected by CE, while in the indirect approach fluorescein-tagged specific antibodies to E. coli are first captured by E. coli O157:H7 bacteria and then released and detected by CE. We have identified suitable bacteria staining and CE protocols, which involved a 10 mM Tris-borate-EDTA (TBE) buffer, 0.25 micro g antibody/1 million bacteria, and capillaries dynamically coated with poly-N-hydroxyethylacrylamide (polyDuramide). We have also successfully detected the presence of E. coli O157:H7 in contaminated meat. The total time required for analysis was 6-8 h, which is less than that realized in most commercial assays presently available.     

Effect of drying temperature and blanching on the degradation of chlorophyll a and b in mint (Mentha spicata Huds.) and basil (Ocimum basilicum): Analysis by high performance liquid chromatography with photodiode array detection

Summary The effect of drying conditions on the preservation of chlorophyll pigments in mint and basil have been investigated in order to determine the effects of drying temperature and whether or not there was a prior blanching.Pigments extracted from fresh and dried samples were analyzed by reversed phase high performance liquid chromatography coupled to a photodiode array detector; isocratic separation was performed on a Zorbax ODS C18 column.The purity of the chromatographic peaks of chlorophylls and breakdown products was investigated. The visible spectra of standard samples of chlorophylls and pheophytins were compared, using least squares normalization with those of peaks from the extracts of fresh and dried mint and basil. The study has shown that chlorophylls were better preserved when drying was preceded by a short blanching; if samples were not blanched before drying, the degradation of chlorophylls a and b was best prevented by drying at low temperatures.