纳米材料在热管中的应用

在普通热管的工质(水)中分别加入ZnO,SiO2,Al2O3和TiO2纳米粉制成了4根新型热管与1根普通热管,共5根热管,均由铜管制成,长度为800 mm,外径12 mm,内径为10 mm,加入水10 mL.在相同的实验条件下研究了这5根热管的启动性能、管壁温度以及输出热量,并对其物理机理进行了探讨,得出如下结论:新型热管比普通热管启动速度快,管壁温度低,换热性能好;加入的纳米粉的尺寸越小,热管的换热性能越好;在一定范围内,纳米粉加入的量越多,热管换热性能越好,但是超过一定量后,会使热管换热性能变差.     

石油套管射孔检测传感器的研制

通过介绍磁通法检测石油井套管射孔质量的基本原理, 研究了磁检测传感器的结构及其环境适应性, 在实验室模拟井中对套管的射孔进行了检测, 给出了具体的检测结果.     

航空导管弯曲试验的疲劳裂纹萌生寿命

飞行器液压导管受接头和卡箍等约束,在使用的振动环境中,会因弯曲应力而导致破裂,影响到飞行安全．本文对飞行器液压系统通用的不锈钢导管的裂纹萌生寿命进行了试验研究．首先在对8 mm、12 mm 无缺陷导管和含U 型缺口8 mm 导管的疲劳试验和有限元分析的基础上,得到了导管的最大拉应变-裂纹萌生寿命数据．然后采用基于强度极限和弹性模量估算法的Manson-Coffin 公式来预测导管裂纹萌生寿命．最后引入加载类型修正系数、表面质量修正系数、试样尺寸修正系数、应力集中敏感系数和有效应力集中系数,使修正后的公式对三种类型的导管均有较好的裂纹萌生寿命预测精度．     

Numerical analysis of swirling turbulent droplet-laden flow and heat transfer in a sudden pipe expansion

The effect of swirling intensity on the structure and heat transfer of a turbulent gas–droplet flow after a sudden pipe expansion has been numerically simulated. Air is used as the carrier phase, and water, ethanol, and acetone are used as the dispersed phase. The Eulerian approach is applied to simulate the dynamics and heat transfer in the dispersed phase. The gas phase is described by a system of Reynolds-averaged Navier-Stokes (RANS) equations, taking into account the effect of droplets on mean transport and turbulent characteristics in the carrier phase. Gas phase turbulence is predicted using the second-moment closure. A swirling droplet-laden flow is characterized by an increase in the number of small particles on the pipe axis due to their accumulation in the zone of flow recirculation and the action of the turbulent migration (turbophoresis) force. A rapid dispersion of fine droplets over the pipe cross-section is observed without swirling. With an increase in swirling intensity, a significant reduction in the length of the separation region occurs. The swirling of a two-phase flow with liquid droplets leads to an increase in the level of turbulence for all three types of liquid droplets investigated in this work due to their intensive evaporation. It is shown that the addition of droplets leads to a significant increase in heat transfer in comparison with a single-phase swirling flow. The greatest effect of flow swirling on heat transfer intensification in a two-phase gas-droplet flow is obtained for the droplets of ethanol and water and smallest effect is for the acetone droplets.     

Nonlinear dynamics of imperfectly-supported pipes conveying fluid

In this paper, the nonlinear dynamics of a pipe imperfectly supported at the upstream end and free at the other and conveying fluid is investigated. The imperfect support is modelled via cubic translational and rotational springs. The equation of motion is obtained via Hamilton’s principle for an open system, and the Galerkin method is used for discretizing the resulting partial differential equation. The dynamics of a system with either strong rotational or strong translational stiffness is examined in details. Numerical results show that similarly to a cantilevered pipe, the system undergoes a supercritical Hopf bifurcation leading to period-1 limit cycle oscillations. The Hopf bifurcation may, however, occur at a much lower flow velocity compared to the perfect system. At higher flow velocities, quasi-periodic and chaotic-like motions may be observed. The amplitude of transverse displacement is generally much higher than that for a cantilevered pipe, mainly due to large-amplitude rigid-body motion. In addition, effects of the mass ratio, internal dissipation, hardening- or softening-type nonlinearity, as well as concentrated- or distributed-type nonlinearity on the dynamics of the system are examined.     

托卡马克真空室内线圈水冷管道接头强化二次流的数值研究

基于计算流体力学(CFD)理论,研究了不同曲率半径的螺旋导流片的托卡马克真空室内线圈水冷管道接头。利用湍流数值模拟方法,分析了线圈管道接头导流片曲率半径比、冷却水入口流速对线圈管道内流体平均雷诺数分布的影响。结果表明,不同导流片曲率半径比的线圈管道内的流体雷诺数分布曲线相似,平均雷诺数随入口流速的增加而增大,管道接头出口雷诺数随导流片曲率半径比的增大而减小,导流片曲率半径比小的管接头更适用于线圈水冷曲线管的二次流强化。此外,还为导流片曲率半径比为0.2的管接头拟合了管接头出口雷诺数与入口流速的关系式,为进一步研究类似于托卡马克真空室内线圈管道的曲线管接头的二次流强化提供理论基础。     

Gate-induced drain leakage (GIDL) in MFMIS and MFIS negative capacitance FinFETs

The gate induced drain leakage (GIDL) effect in negative capacitance (NC) FinFET is investigated. A Landau–Ginzburg–Devonshire equation (which considers the polarization gradient in ferroelectric material) is used to estimate the characteristics of the NC FinFET. Specifically, metal-ferroelectric-metal-insulator-semiconductor (MFMIS) and metal-ferroelectric-insulator-semiconductor (MFIS) NC FinFETs are compared, in order to figure out the effect of the internal metal layer on the GIDL effect. To analyze the impact of the polarization gradient on the GIDL effect in NC FinFET, a polarization gradient coefficient is varied. For MFMIS, the polarization gradient doesn't significantly affect the device performance. The subthreshold swing improves but the GIDL effect deteriorates because of the “uniform” NC effect in channel region. For MFIS, the device performance is explicitly affected by the polarization gradient. Smaller polarization gradients result in non-uniform NC effect in channel region, resulting in severe GIDL effects. On the other hand, higher polarization gradients alleviate GIDL effects.     

排水板施工对软黏土扰动的现场试验研究

通过软黏土地基上塑料排水板施工过程的孔隙水压力观测及现场十字板强度试验,研究了排水板施工前后地基土体孔隙水压力增长和消散的规律,并且从软黏土地基的有效应力变化和结构扰动等方面分析了土体强度损失及恢复过程.结果表明:单根排水板施工引起的孔隙水压力增长较小,仅对表层孔隙水压力影响大;板群的施工对4 m范围内土体孔隙水压力的增长有叠加效应;排水板施工一方面使软土地基内的孔隙水压力增长,有效应力减小,导致软土强度的降低,另一方面使地基软土结构发生破坏而引起软土强度降低;孔隙水压力的增长引起的地基土强度损失恢复较快,而结构扰动引起的强度损失恢复较慢.     

管道可视化检测系统的研究与实现

文章设计了基于Windows操作系统的可视化检测系统,采取数据库连接方式,把所有的检测信息存入数据库中,使查询简单而又高效;由于检测监控模块是整个检测系统软件的核心与基础部分,因而重点介绍了实时检测程序主要设计流程;结果证明,检测系统实现了对钢管的自动化、智能化及可视化检测,在实际生产领域中得到了广泛应用。     

低温预冷换热规律及表面改性影响研究

调研了低温管路预冷及两相换热的研究现状,阐述了低温预冷瞬态换热特性;介绍了金属表面改性对预冷规律的影响,仿真了低导热涂层管的预冷换热规律.研究发现:液氮预冷主要由膜态沸腾支配,且预冷耗时较长;液氢预冷未见膜态沸腾,预冷耗时更短.促进膜态沸腾向过渡沸腾的更早转化有利于预冷加速,且转化温度迁移可通过内壁表面结构改性实现,可...