托卡马克真空室内线圈水冷管道接头强化二次流的数值研究

基于计算流体力学(CFD)理论,研究了不同曲率半径的螺旋导流片的托卡马克真空室内线圈水冷管道接头。利用湍流数值模拟方法,分析了线圈管道接头导流片曲率半径比、冷却水入口流速对线圈管道内流体平均雷诺数分布的影响。结果表明,不同导流片曲率半径比的线圈管道内的流体雷诺数分布曲线相似,平均雷诺数随入口流速的增加而增大,管道接头出口雷诺数随导流片曲率半径比的增大而减小,导流片曲率半径比小的管接头更适用于线圈水冷曲线管的二次流强化。此外,还为导流片曲率半径比为0.2的管接头拟合了管接头出口雷诺数与入口流速的关系式,为进一步研究类似于托卡马克真空室内线圈管道的曲线管接头的二次流强化提供理论基础。     

Vortex dynamics of a trapezoidal bluff body placed inside a circular pipe

The influence of Reynolds number and blockage ratio on the vortex dynamics of a trapezoidal bluff body placed inside a circular pipe is studied experimentally and numerically. Low aspect ratio, high blockage ratio, curved end conditions (junction of pipe and bluff body), axisymmetric upstream flow with shear and turbulence are some of the intrinsic features of this class of bluff body flows which have been scarcely addressed in the literature. A large range (200:200,000) of Reynolds number (Re_D) is covered in this study, encompassing all the three pipe flow regimes (laminar, transition and turbulent). Four different flow regimes are defined based on the distinct features of Strouhal number (St)–Re_D relation: steady, laminar irregular, transition and turbulent. The wake in the steady regime is stationary with no oscillations in the shear layer. The laminar regime is termed as irregular owing to irregular vortex shedding. The vortex shedding in this regime is observed to be symmetric. The emergence of separation bubble downstream of the bluff body on either side is another interesting feature of this regime, which is further observed to be symmetric. Two pairs of mean streamwise vortices are noticed in the near-wake regime, which are termed as reverse dipole-type wake topology. Beyond the irregular laminar regime, the Strouhal number falls gradually and vortex shedding becomes more periodic. This regime is named transition and occurs close to the Reynolds number at which transition to turbulence takes place in a fully developed pipe. The turbulent regime is characterised by a nearly constant Strouhal number. Typical Karman-type vortex shedding is noticed in this regime. The convection velocity, wake width formation length and irrecoverable pressure loss are quantified to highlight the influence of blockage ratio. These results will be useful to develop basic understanding of vortex dynamics of confined bluff body flow for several practical applications.     

Internal Flow Patterns on Heat Transfer Performance of a Closed-Loop Oscillating Heat Pipe with Check Valves

This article presents the experimental results of an evaluation of the influence of internal flow patterns on the heat transfer performance of a closed-loop oscillating heat pipe with check valves. It was found that the internal flow patterns could be classified according to four flow patterns: dispersed bubble flow, bubble flow, slug flow, and annular flow, respectively. The main regime of each flow pattern can be determined from a flow pattern map. The map can be used to predict the trend of the heat transfer rate in the closed-loop oscillating heat pipe with check valves.     

水平管油水两相流摩擦阻力特性实验研究

本文对水平管内油水液液两相流的摩擦阻力压降特性进行了实验研究。水平管实验段由有机玻璃管制成,内径为40mm。根据油水两相流流型的不同,通过建立物理模型或对实验数据的整理得到了各种典型流型下的摩擦阻力压降计算式。揭示了摩擦阻力压降随混合物速度和体积含水率等的变化规律。     

高性能计算机用热管复合制冷系统设计研究

根据高性能计算机全天候温控的需要,提出了综合应用蒸气压缩和动力型分离式热管制冷技术的复合冷源方案。在冬季及春、秋过渡的低温季节,运行热管循环不仅大幅降低环控装置的能耗,而且可以避免在低温环境运行压缩式制冷易发生的冷启动、回油润滑等问题。提出了蒸气压缩制冷、蒸气压缩/热管复合制冷和热管制冷的分区工作模式,引入复合制冷模式有效拓宽了热管运行温区,大幅提高了制冷系统的综合COP。模拟分析了在北京地区应用热管复合制冷技术的节能性能,相比常规的压缩制冷节能率高达40%。研究表明:热管复合制冷系统具有显著的节能减排优势,特别适用于全天候工作的机房、基站等高热密度电子集成系统的温控。     

小长径比垂直管气液两相流动特性分析

实验观察了小长径比垂直上流管内流型及特点,并对管入口处的压力波动特性和系统的压差波动特性进行了试验研究.结果表明:小长径比(L/D)垂直管内流型表现为泡状流、塞状流、乳沫状流、环状流和液束环状流;分别增加管线中的气量、液量,或者同时增加气液流量,均会造成垂直管入口处压力波动的均值和最大压力的增加;压力信号的概率密度(PDF)大部分呈双峰分布,也存在单峰和多峰分布;差压信号的概率密度符合正态分布,其功率谱密度同压力信号相比具有频率波动范围宽、幅值小的特点.     

CPL技术在空间飞行器上的应用

本文对ＣＰＬ技术进行了简要概述,介绍了其工作原理与工作特性,并讨论了ＣＰＬ技术在空间飞行器上的可能应用方式。其中,对ＣＰＬ技术应用于空间设备的散热进行了全面阐述,并给予理论分析;此外,对ＣＰＬ技术应用于空间设备的主动热控制,也作了简要介绍;对ＣＰＬ技术未来有发展前景的应用方式进行了展望。     

铜-钼源漏电极对非晶氧化铟镓锌薄膜晶体管性能的改善

在铜(Cu)和非晶铟镓锌氧化物(a-IGZO)之间插入30 nm厚的钼(Mo)接触层, 制备了具有Cu-Mo源漏电极的a-IGZO薄膜晶体管(TFT). Mo接触层不仅能够抑制Cu与a-IGZO有源层之间的扩散, 而且提高了Cu电极与玻璃基底以及栅极绝缘层的结合强度. 制备的Cu-Mo结构TFT与纯Cu 结构TFT相比, 具有较高的迁移率(～9.26 cm²·V^-1·s^-1)、更短的电流传输长度(～0.2 μm)、更低的接触电阻(～1072 Ω)和有效接触电阻率(～1×10^-4Ω·cm²), 能够满足TFT 阵列高导互联的要求.     

U型管内液柱振动的演示实验研究

根据实验结果，分析了影响U型管中液柱振动的各种因素，给出了获得好的演示效果的改进措施．     

高温及超高温热管的启动特性和传热极限

根据局部高温、高热流加热等特殊场合的需求,设计、加工了钠高温热管及锂超高温热管,并对热管的启动和极限特性进行了研究。高温及超高温热管能够顺利启动,但启动时应注意可能到来的声速传热极限。端部加热启动时,端部附近管体部分会形成一段等效的加热段,可以将工质从启动时的固体状态到全部熔化形成相变传热及流动循环的时间确定为启动时间。热管的传热极限特性表明,超高温热管应工作在更高的温度和更大的热流密度。热管的结构和工艺优化有利于启动和运行。