离心力场下H2O和R12热驱动换热特性实验研究

本文实验研究了离心力场下细微封闭循环通道中,以H2O和氟利昂R12为热驱动介质的热驱动流动规律和换热特性,重点分析了热驱动换热效果随Ra数Ro数的变化规律以及冷却效果。实验结果表明:在热流密度和旋转速度相同的条件下,采用介质R12可以获得较高的平均换热系数,冷却效果也优于以H2O为介质的冷却效果。最后建立了两种介质条件下相应的准则关系式。     

双预脉冲驱动X射线激光实验研究

 在“星光-Ⅱ”激光装置上进行了双预脉冲驱动类氖铬X射线激光实验，介绍了实验方法和实验结果，并对结果进行了简短讨论。由于目前“星光”装置输出能量较低，所进行的双预脉冲驱动未能显著提高X射线激光强度，改变预脉冲幅度时X射线激光强度也未有显著变化。利用MED103程序进行了模拟计算，其结果与实验结果一致。     

基于LVDT的新型信号调理电路的设计研究

LVDT线性可变差动变压器,其输出信号为两个线圈的差动电压信号,能够实时的、高准确性的将机械位移信号转化成电信号。传统LVDT信号调理电路存在不易散热、检测修复困难、性价比低、适用范围窄等问题,本文设计了一种新型LVDT信号调理电路,该信号调理电路由驱动电路、整流归一化电路和滤波放大电路组成,测试结果能够匹配LVDT的输出信号特性,达到LVDT信号调理的各项指标要求,实验结果表明本设计具有一定的可行性。     

弹丸爆炸驱动过程中层裂控制的研究

在弹丸爆炸驱动过程中,对厚度大于一定尺寸的弹丸,为降低弹丸内部负压以避免其层裂,通常对弹丸前端进行封装。研究发现,在爆炸产生的加载脉冲下,封装后的弹丸可能产生两次负压。一次负压的产生仅与选择的封装材料有关,二次负压的产生同时还与封装材料的厚度有关。通过理论推导得到了在给定弹丸材料和封装材料的情况下,为使弹丸不产生一次负压,加载冲击波和卸载稀疏波波后压力应满足的临界条件;同时导出了一次负压为零时,在弹丸不产生二次负压的条件下,封装材料厚度的临界值。采用AUTODYN有限元软件,对钢、铝弹丸封装材料不同的情况进行数值模拟,验证理论解的正确性;另外还对比研究了三角形冲击波加载的情况。研究结果可为弹丸爆炸驱动过程中封装材料的设计提供参考。     

Bifurcation analysis of visual angle model with anticipated time and stabilizing driving behavior

In the light of the visual angle model (VAM), an improved car-following model considering driver's visual angle, anticipated time and stabilizing driving behavior is proposed so as to investigate how the driver's behavior factors affect the stability of the traffic flow. Based on the model, linear stability analysis is performed together with bifurcation analysis, whose corresponding stability condition is highly fit to the results of the linear analysis. Furthermore, the time-dependent Ginzburg-Landau (TDGL) equation and the modified Korteweg-de Vries (mKdV) equation are derived by nonlinear analysis, and we obtain the relationship of the two equations through the comparison. Finally, parameter calibration and numerical simulation are conducted to verify the validity of the theoretical analysis, whose results are highly consistent with the theoretical analysis.     

固体炸药的磁驱动准等熵压缩实验研究

较宽压力范围内未反应炸药的本构关系和状态方程对于深入和精确认识压缩波作用下炸药组分间相互作用的力学过程和起爆热点的形成机制具有重要意义。较之冲击压缩,磁驱动准等熵压缩加载(无冲击压缩)是获取较宽压力范围内未反应炸药的动态压缩力学特性更有效的手段。基于大电流产生的电磁力作用原理,在国内率先实现了炸药的磁驱动无冲击压缩实验技术。通过对负载电极、炸药样品参数的优化设计和安装工艺的控制,实现了5 GPa载荷内JO-9159炸药的磁驱动准等熵压缩加载。基于激光位移干涉测量技术和Lagrange数据处理方法,获得了JO-9159炸药的速度响应历史和准等熵压缩线。所得结果与文献数据进行了比较,结果表明,在实验压力范围内,JO-9159炸药的等熵压缩线与PBX9501炸药的等熵压缩线一致。     

Dipole bands in nucleus ~(139)Pm

High-spin states in nucleus 139Pm have been studied using the reaction 116Cd(27Al,4n)139Pm.Two dipole cascades have been found.Spin and parity assignments were based on the Directional Correlation of Oriented Nuclei(DCO) ratios and systematic behavior in neighboring odd-proton nuclei.The level structures of 139Pm are compared with those of the N =78 isotone 141Eu in which two dipole bands have been confirmed as magnetic rotational bands.The close similarity between them suggests that the dipole bands in 139...     

In-Situ Intrinsic Interface Strength Measurement at Elevated Temperatures and its Relationship to Interfacial Structure

A previously developed laser spallation technique has been modified to measure the tensile strength of thin film interfaces in-situ at temperatures up to 1100°C. Tensile strengths of Nb/A-plane sapphire, FeCrAl/A-plane sapphire and FeCrAlY/A-plane sapphire were measured up to 950°C. The measured strengths at high temperatures were substantially lower compared with their corresponding strengths at ambient temperature. For example, at 850°C, the interface tensile strength for the Nb/sapphire (151 ± 17 MPa), FeCrAl/sapphire (62 ± 8 MPa) and FeCrAlY/sapphire (82 ± 11 MPa) interface systems were lower by factors of approximately, 3, 5, and 8, respectively, over their corresponding ambient values. These results underscore the importance of using such in-situ measured values under operating conditions as the failure criterion in any life prediction or reliability models of such coated systems where local interface temperature excursions are expected. The results on alloy film interfaces also demonstrate that the presence of Y increases the strength of FeCrAl/Al₂O₃ interfaces.     

基于LPC2210和SSD1339的PM-OLED驱动控制电路

为了避免早期无源矩阵有机电致发光器件驱动控制电路的一些缺陷,如:"串扰"和"交叉"效应以及电路连接比较复杂,用两种方法实现了基于飞利浦公司生产的LPC2210控制芯片和晶门科技公司的SSD1339驱动芯片的驱动控制电路。首先介绍了有机电致发光器件的结构和发光原理以及芯片SSD1339和LPC2210的主要的特点;分析和比较了SSD1339的8080系列并行口和LPC2210外部存储控制单元的读写时序;分别利用LPC2210的通用输入输出单元和外部存储控制单元,成功的控制SSD1339驱动128RGB×128点阵有机电致发光屏。实验结果表明:两种方法不仅可以有效地克服早期驱动控制电路的缺陷,而且可以使有机电致发光屏显示出高质量的图片;用外部存储控制单元实现的驱动控制电路,可以实现约80 Hz的驱动帧频;而使用通用输入输出单元实现的驱动控制电路,可以单步跟踪数据的传输,因此它具有方便查错的优势。本次实验为在不同的集成环境下无源矩阵有机电致发光器件驱动控制电路的设计奠定基础。     

The Role of Potential Structure in Excitation Functions of Synthesizing Superheavy Nuclei

The excitation functions of two very similar reaction channels, 58Fe＋ 208pb→ 265Hs ＋ 1n and 58Fe＋ 209Bi → 266Mt ＋1n are studied in the framework of the dinuclear system conception. The fusion probabilities are found to be strongly subject to the structure of the driving potential. Usually the fusion probability is hindered by a barrier from the injection channel towards the compound nuclear configuration. The barrier towards the mass symmetrical direction, however, also plays an important role for the fusion probability, because the barrier hinders the quasi-fission, and therefore helps fusion.