Polytetrafluoroethylene and metal structure convective-flow CO laser

A convective flow CO laser composed of polytetrafluoroethylene discharge tubes, nickel–chromium steel components, a cupric heat exchanger and other components is described. Operating in liquid nitrogen condition, output power of 60 W has been obtained from a non-selective cavity.     

Hydrophobicity-induced drying transition in alkanethiol self-assembled monolayer—water interface

During the course of our investigation of the electron transfer properties of some redox species through highly hydrophobic long chain alkanethiol molecules on gold in aqueous and non-aqueous solvents, we obtained some intriguing results such as unusually low interfacial capacitance, very high values of impedance and film resistance, all of which pointed to the possible existence of a nanometer size interfacial gap between the hydrophobic monolayer and aqueous electrolyte. We explain this phenomenon by a model for the alkanethiol monolayer—aqueous electrolyte interface, in which the extremely hydrophobic alkanethiol film repels water molecules adjacent to it and in the process creates a shield between the monolayer film and water. This effectively increases the overall thickness of the dielectric layer that is manifested as an abnormally low value of interfacial capacitance. This behaviour is very much akin to the ‘drying transition’ proposed by Lum, Chandler and Weeks in their theory of length scale dependent hydrophobicity. For small hydrophobic units consisting of apolar solutes, the water molecules can reorganize around them without sacrificing their hydrogen bonds. Since for an extended hydrophobic unit, the existence of hydrogen bonded water structure close to it is geometrically unfavourable, there is a net depletion of water molecules in the vicinity leading to the possible creation of a hydrophobic interfacial gap.     

铝厂污水零排放研究

本文从水质方面分析了西南某铝厂污水零排放的可行性。为了实现污水零排放,对该铝厂东片区、氧化铝厂、热电厂三大污水处理系统进行改进。从现场试验监测及统计分析结果表明,改进后的处理系统处理的水质满足再生水水质指标要求,该铝厂污水零排放的实现创造了极大的经济和社会效益。     

对浙江高平均数背后城乡居民收入分配差距的冷思考

无论人均GDP、还是人均收入和人均储蓄,浙江在全国都名列前茅,但在高平均数的背后,城乡合一、城乡之间、城镇内部和农村内部都存在着事实上不断扩大的、在全国也非常突出的收入差距。浙江城乡居民收入分配差距不断拉大的原因,主要是巨富抬高人均水平和发展战略、分配原则、社保制度、再分配措施偏向所致。     

Benzene fused five-membered heterocycles. A theoretical approach

The Nuclear Independent Chemical Shift of each ring, as a criterion of aromaticity, is used to explain the stability order of benzopyrrole, benzofuran and benzothiophene, and their isomers. The results indicate that the benzene ring is aromatic in all the systems. The five-membered rings of benzopyrrole, benzofuran and benzothiophene are also aromatic, whereas those of isobenzopyrrole, isobenzofuran and isobenzothiophene are non-aromatic. This could be an explanation of the stability of the former molecules. The molecular orbitals and the condensed Fukui functions derived from the electronic structure calculations are also reported. These reactivity indices explain the expected electrophilic substitution of these compounds. The theoretical structure, ionization energies, order of aromaticity, stability and reactivity are in good agreement with the experimental results. The usefulness of this approach to determine the reactivity is discussed since their stability and reactivity may be understood. The reactivity indices are useful to explain and confirm the experimental information, and for molecules with unknown reactive behavior, this approach could help to predict some of the reactions.     

采用空心阴极放电等离子体化学气相沉积方法制备a-CH薄膜

 研究了不同衬底-阴极距离、直流电压和H₂流量对a-CH薄膜沉积速率的影响。结果表明：衬底-阴极距离必须大于0.5cm，随着该距离的增加，薄膜的沉积速率减少；直流电压达550V时沉积速率最大；随着H2含量的增加，CH₄含量相对减少，沉积速率随之降低。用AFM观察了以该方法制得的448.4nm CH薄膜的表面形貌，表面粗糙度约为10nm。最后测出了不同条件下CH薄膜的UV-VIS谱，由此可以计算得到薄膜的禁带宽度及折射率。     

硅基两维光子晶体的制备和光子带隙特性

利用反应离子束刻蚀设备制备了硅基的两维空气柱光子晶体，并用红外显微镜测试了样品的 反射谱. 理论上用时域有限差分(FDTD)方法计算了样品的光子带隙，从测试结果看光子带隙 和理论计算的光子带隙符合得很好.  关键词： 光子晶体 光子带隙 反射谱 时域有限差方法     

弱1—凸对策及其解的性质

本文提出了一类特殊的ｎ人合作对策模型─—弱１—凸对策，研究了弱１—凸对策的解的性质，并证明弱１—凸对策的解满足所有常见的公理化特征．     

Analysis of semiconducting materials by high-resolution radiofrequency glow discharge mass spectrometry

The analytical capabilities of a high-resolution mass spectrometer in combination with a 13.56 MHz glow discharge ion source for the analysis of semiconducting materials (silicon carbide and gallium arsenide) were studied. It was shown that single positively charged ions of sample material have about 10 eV higher average energy than the ions of the discharge and residual gas. Therefore effective energy separation of the ions of analyte from the ions of the discharge and residual gas was achieved by adjusting the ion transfer optics (breadth and position of energy slit), which improves the analytical capabilities of the developed method.Some analytical applications are presented to illustrate the performance of r.f. GDMS for the bulk analysis of semiconducting materials. The results of the trace element analysis of gallium arsenide and silicon carbide samples are compared with data of independent methods (LIMS, ICP-AES, SIMS).Dedicated to Professor Dr. rer. nat. Dr. h.c. Hubertus Nickel on the occasion of his 65th birthdayOn leave from the Institute of Inorganic Chemistry, 630090 Novosibirsk, Russia     

Towards cooling of high-intensity ion beams

Buffer gas beam coolers may become excellent beam preparation devices for high-resolution mass separation. The small beam emittance provided makes efficient isobar resolution a realistic goal. In order to fulfill the needs of future facilities providing high-intensity beams of rare isotopes, it is desirable to increase the beam intensity limit of such devices from typically several tens of nanoamperes to microamperes. This requires the usage of high-voltage radiofrequencies in a low-pressure gas environment. A buffer gas beam cooler, dedicated to this purpose, is under development at the NSCL. The study of voltage breakdowns under such conditions and the design of an electrode system minimizing them is mandatory.