Highly soluble and optically transparent poly (ether imide)s based on 2,6‐ or 2,7‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride and aromatic bis(ether amine)s bearing trifluoromethyl groups

Two series of novel fluorinated poly(ether imide)s (coded IIIA and IIIB ) were prepared from 2,6‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride and 2,7‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride, respectively, with various trifluoromethyl‐substituted aromatic bis(ether amine)s by a standard two‐step process with thermal or chemical imidization of the poly(amic acid) precursors. These fluorinated poly(ether imide)s showed good solubility in many organic solvents and could be solution‐cast into transparent, flexible, and tough films. These films were nearly colorless, with an ultraviolet–visible absorption edge of 364–386 nm. They also showed good thermal stability with glass‐transition temperatures of 221–298 °C, 10% weight loss temperatures in excess of 489 °C, and char yields at 800 °C in nitrogen greater than 50%. The 2,7‐substituted IIIB series also showed better solubility and higher transparency than the isomeric 2,6‐substituted IIIA series. In comparison with nonfluorinated poly (ether imide)s, the fluorinated IIIA and IIIB series showed better solubility, higher transparency, and lower dielectric constants and water absorption. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 5909–5922, 2006     

Divinylsiloxane‐bisbenzocyclobutene‐based polymer modified with polystyrene–polybutadiene–polystyrene triblock copolymers

Divinylsiloxane‐bisbenzocyclobutene (DVS‐bisBCB) polymer has very low dielectric constant and dissipation factor, good thermal stability, and high chemical resistance. The fracture toughness of the thermoset polymer is moderate due to its high crosslink density. A thermoplastic elastomer, polystyrene–polybutadiene–polystyrene triblock copolymer, was incorporated into the matrix to enhance its toughness. The cured thermoset matrix showed different morphology when the elastomer was added to the B‐staged prepolymer or when the elastomer was B‐staged with the DVS‐bisBCB monomer. Small and uniformly distributed elastomer domains were detected by transmission electron micrographs (TEM) in the former case, but TEM did not detect a separate domain in the latter case. A high percentage of the polystyrene–polybutadiene–polystyrene triblock copolymer could be incorporated into the DVS‐bisBCB thermoset matrix by B‐staging the triblock copolymer with the BCB monomer. The elastomer increased the fracture toughness of DVS‐bisBCB polymer as indicated by enhanced elongation at break and increased K1c values obtained by the modified edge‐lift‐off test. Elastomer modified DVS‐bisBCB maintained excellent electrical properties, high T_g and good thermal stability, but showed higher coefficient of linear thermal expansion values. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 1591–1599, 2006     

Magnetic resonance in amorphous metals based on Fe in the millimeter radiowave range

The research technique of amorphous magnetics is described. The paper gives the experimental data obtained by a multifunctional low-temperature radiospectrometer Buran in the mm radiowave range and presents their analysis.     

Surface properties of finite classical Coulomb systems: Debye-Hückel approximation and computer simulations

We report analytical and numerical studies of surface correlations in finite, homogeneously polarizable, classical Coulomb systems placed in an insulating or conducting environment. Their purpose is to understand the phenomenological, shape-dependent laws of electrostatics, from the point of view of statistical mechanics; we focus on the knowledge of the dielectric susceptibility of the system, a quantity proportional to the equilibrium fluctuation of the system's instantaneous polarization per unit volume. This goal has been achieved for a system in a conducting state. The picture is that the shape-dependent part of the susceptibilities results from the action of unbounded observables (the second moments of the instantaneous polarization of the system) on long-range surface correlations and that the relations of electrostatics are verified by means of shape-dependent thermodynamic limits. This picture is supported (i) by exact solutions and asymptotic analysis of the Debye-Hückel approximation of multicomponent plasmas in disks and spheres with insulating and conducting environment and also in ellipses in a vacuum, and (ii) by computer simulations of a one-component plasma in a disk with different environments, notably a conducting environment with permeable and impermeable wall. These observations have revealed for the first time the reason why the susceptibility of a conducting disk in a conductor with impermeable walls diverges linearly with the radius of the disk: this is due to the occurrence of long-range radial correlations in the conductor. These findings are quantitatively interpreted in terms of a novel canonical Debye-Huckel approximation as contrasted to the ordinary grand canonical version. Lastly a fresh look at the problem of the surface correlations of a conductor in a vacuum, which places the observer close to the surface of the conductor but in the vacuum, is presented and applied to the disk, the ellipse, the cylinder, the sphere, and the wedge.     

Dielectric relaxation studies of 1-hexanol and 1,2-hexanediol in heptane

Solutions of 1-hexanol and 1,2-hexanediol in heptane have been investigated tigated by means of dielectric time domain spectroscopy (TDS). The permittivity spectrum of 1-hexanol in heptane is characterized by a model function containing a sum of three elementary Debye dispersions, while 1,2-hexanediol in heptane is best described by a Cole-Davidson model function. It is shown that dilute solutions of 1-hexanol in heptane have a completely different behavior to that of 1,2-hexanediol. For the diol, the relaxation time levels off at a high value indicating an existence of higher hydrogen bonded complexes. It is possible to quantify the relative amount of monomeric 1-alcohol molecules from the dielectric spectrum. The monomerization rate for 1-hexanol upon dilution with heptane is initially low, but increases rapidly for mole fractions of heptane exceeding 0.4.     

电视用液晶材料的研究进展

液晶电视由于其优异的显示性能将会越来越受到青睐。本文简要综述了近年来电视用液晶材料的研究进展,归纳总结了这些液晶材料的合成方法及其热性能、介电各向异性、双折射率、粘度等特性。     

Dielectric relaxation of polystyrene with side-chain- and chain-end-labels

Polystyrenes with different concentrations of side groups with cyano groups were prepared and complex dielectric constants were measured in the range of the glass transition temperature and the frequency range of 10^–2–10⁷ Hz.The GPC and DSC measurements showed that the molecular weight of these polystyrenes was about 10500 g/mole and the glass transition temperatures were 89.5°C for all samples.The dielectric relaxation spectra obtained for the side group polystyrene labels and also the chain-end polystyrene labels prepared before [9] were analyzed to find out the degree of coupling of the chain-end and side-group labels with the cooperative reorientation of the polymeric matrix. The analysis of the spectra was carried out using the analysis method developed by Mansour and Stoll [6].The results obtained showed that both end- and side-group labels are strongly coupled with the segmental reorientation and relax with relaxation times longer than that of the segments.The value of logf _m = (logf _m(label)) – logf _m(matrix)) was obtained from the recently designed comparison diagram suggested by Mansour and Stoll [6, 14]. The value of logf _m depends on the label length in the case of chain-end labels.It was surprising to find that the side groups relax slower than the segments by only 0.9 decades. These results obtained implied that the label relaxes through a multistep relaxation mechanism of the side and end groups and not through a diffusion mechanism of the whole chain. In addition, the effective lengths of the relaxing units were determined using the empirical equation obtained before in the case of rodlike molecules in polyisoprene [7].     

Thermal properties of sodium acetylacetonate

Sodium acetylacetonate was prepared by the interaction of acetyl acetone with sodium hydroxide. The thermal conductivity, phonon velocity, mean free path, Yong's modulus, and the thermal expansion coefficient were studied. The thermal conductivity of the material decreases with increasing temperature due to the thermal lattice scattering of phonons. The velocity of phonons is also decreased due to the perturbation of thermal phonons. The linear thermal expansion coefficient increases with temperature due to the weakness of the attractive forces between the small Na⁺ cations and bulkier acetylacetonate anions in the lattice.

---

Zusammenfassung Natriumacetylacetonat wurde durch die Wechselwirkung zwischen Acetylaceton und Natriumhydroxid gewonnen. Es wurde die Wärmeleitfähigkeit, die Phononengeschwindigkeit, die mittlere freie Wegstrecke, das Elastizitätsmodul und der Wärmeausdehnungskoeffizient untersucht. Die Wärmeleitfähigkeit der Substanz nimmt wegen der thermischen Gitterstreuung der Phononen mit steigender Temparatur ab. Die Geschwindigkeit der Phononen nimmt auf Grund der Perturbierung der thermischen Phononen ebenfalls ab. Der lineare Wärmeausdehnungskoeffizient steigt mit zunehmender Temperatur an, was auf die schwachen Anziehungskräfte zwischen den kleinen Na⁺ Ionen und den massigen Acetylacetonat-Anionen im Gitter zurückzuführen ist.

     

由聚苯胺粒子组成的电流变液的研究

由经碱处理的掺杂态聚苯胺（ＰＡｎ）制得高介电常数的半导体ＰＡｎ粒子，将其悬浮于电绝缘油可组成电流变液，讨论了电流变（ＥＲ）液的静态屈服应力（τ＿ｓ），电流密度等性能与ＰＡｎ的介电常数（ε＿ｐ），导电率（σ），体积分数和应用电场强度的关系。对导电率相同的ＰＡｎ粒子，用氨水处理的ＰＡｎ粒子ε＿ｐ较用ＮａＯＨ液处理的高，前者在σ足够低如σ≤１．０×１０￣（－７）／ｃｍ时，ＥＲ液的τ＿ｓ随偶极系数的平方（β￣２）的增大而呈现非线性增加；后者ＥＲ液的τ＿ｓ随β￣２的增大出现一最大值．结果表明：由聚苯胺粒子可组成高电流变活性的无水ＥＲ液．     

Dielectric studies of binary mixtures of n -propyl alcohol and ethylenediamine

Dielectric constant (ε’) and dielectric loss (ε") of n-propyl alcohol (PA), ethylenediamine (EDA) and their binary mixtures, for different mole fractions of ethylenediamine have been experimentally measured at 11.15 GHz microwave frequency. Values of density (ρ), viscosity (η) and square refractive index (n _D ² ) of binary mixtures as well as those of pure liquids are reported. Excess square refractive index, viscosity and activation energy of viscous flow have also been estimated. These parameters have been used to explain the formation of complexes in the system.