New isothermal equation of state of solids applied to high pressures

In the present paper, a new two-parameter inverted equation of state (EOS) is developed which is found to be working very well in the high-pressure region. To check its success and validity, this EOS has been applied in a number of solids. The computed volume compression is found to be in very good agreement with the experimental data in the whole range of pressure in all the solids. The minimum and the maximum pressure range used in the present study is 0–320 kbar and 0–3000 kbar, respectively.     

圆形池壁滑模提升系统设计与施工

本阐述了郑州污水处理厂等直径钢筋混凝土消化池，采用滑升模板施工，连续浇筑混凝土提高工效，经过满水和闭气试验，符合设计要求，保证工程质量．取得较好的结果。     

后张法预应力混凝土T梁静载试验

简要叙述了后张法T梁静载试验的方法，步骤，并通过一元线性回归分析对试验结果进行了验证。     

我国最薄炉墙焦炉的设计、施工与生产

减薄炭化室炉墙是提高焦炉产量,节约能源,减少投资的重要途径之一。本文介绍我国厚80毫米炉墙焦炉的设计、施工与生产情况。     

Comparisons of pharynx, source, formant, and pressure characteristics in operatic and musical theatre singing

Belting, a vocal technique typically cultivated in musical theatre singing, differs timbrally from operatic singing in many interesting respects. The underlying phonatory differences have not been previously investigated in detail. Yet, belting is frequently associated with disturbances of voice function. Articulatory and phonatory characteristics are investigated in a female subject who is a professional singer (co-author JL) trained in both the operatic and belting styles and in an intermediate vocal technique (“mixed”). This article presents data obtained from this subject by video-fiberoptic observation of the pharynx, inverse filtering of airflow, and measurement of subglottal pressure. The results reveal that belting was characterized by very high subglottal pressures and sound levels, and apparently also by a comparatively high degree of glottal adduction. Comparisons with other investigations of related aspects of belting and operatic singing support the assumption that the data obtained from our subject are representative for these vocal techniques.     

地桩沉降量单片机智能检测系统的研究

论述了以８０３１为控制核心的地桩沉降量检测系统的工作原理、系统组成。重点介绍了主要硬件电路的设计特点及软件设计思想，提供了部分硬件电路图及控制软件流程图。该系统具有自检、置数、动态显示、数据处理、打印等功能，使用方便，造价低     

室温下压致铁钴镍合金的bcc→hcp相变

 本文采用高压X光衍射方法在金刚石对顶压砧中在位地（in situ）研究了Fe₆₈Co₂₄Ni₈（wt%）合金在室温下的压致bcc→hcp结构相变和直到40.5 GPa的等温压缩行为。实验结果表明该合金在常压下为bcc结构，晶格常数a₀=(0.287 0±0.000 1) nm，体积V₀=(7.119±0.007) cm³/mol，密度ρ₀=(7.981±0.008) g/cm³；在20.9 GPa附近出现bcc→hcp结构相变，两相共存压力区约10 GPa，在此区域内有晶面间距d(002)_hcp=d(110)_bcc，且原子平面(002)_hcp//(110)_bcc，hcp相比bcc相体积减小(0.33±0.02) cm³/mol；高压相hcp结构的晶格参数比值c/a=1.608±0.004；相变后原子配位数的增加使得hcp相(002)平面内及(002)平面间的最近邻原子间距比bcc相最近邻原子间距分别增大约1.6%和0.5%；用Murnaghan状态方程对实验数据进行最小二乘法拟合，得到bcc相B₀=(130±13) GPa，B₀'=12.6±0.5；hcp相V₀=(6.62±0.04) cm³/mol，B₀=(243±21) GPa，B₀'=6.8±0.3；对于该合金的bcc→fcp相变时的结构转变机制做了详细的讨论。     

高压下液态Ag-20 at%Ge合金的凝固及密排六方亚稳相的形成

 利用高压淬火方法，在液态Ag-20at%Ge合金的凝固过程中，对比液态急冷低四个数量级的冷却速率得到了单相密排六方结构亚稳相，其点阵参数为a=0.289 8 nm，c=0.470 8 nm，c/a=1.625。     

否定毛细永动机的唯象理论

本文从毛细现象自身所满足的规律、弯曲液面所具有的性质着手，给出了一种否定毛细永动机的唯象理论。     

复线电气化区段施工感应电对人体的危害及防护对策

感应电会对人体造成伤害。从电磁感应和静电感应原理入手，分析了产生感应电的过程，并就如何防止感应电的危害提出了防护对策，有一定实用价值。