阴极支撑型固体氧化物燃料电池的制备与测试

采用固相反应法合成A缺位的(La_0.8Sr_0.2)_0.95MnO₃(LSM95)作为阴极材料,Zr_0.9Sc_0.1SO_1.95(SSZ)商业粉体作为电解质材料,溶胶-凝胶法合成的La_0.8Sr_0.2Cr_0.5Mn_0.5O₃-(LSCrM)作为阳极电催化材料,利用流延、共烧结及浸渍法得到结构为LSCrM-CeO₂|SSZ|3YSZ-LSM95的阴极支撑型固体氧化物燃料电池,分别在氢气气氛和甲烷气氛中进行电化学性能测试. 结果表明,浸渍0.11 g·cm ^-2 CeO₂的LSCrM-CeO₂|SSZ|3YSZ-LSM95单电池在以CH₄为燃料时,600、650、700、750和800 ^oC下的功率密度分别为1.68、4.70、12.40、28.08和54.78 mW·cm ^-2,表现出一定的电化学性能和较好的稳定性.     

Carbyne — the third allotropic form of carbon

The history of the discovery of carbyne, the chemical and physical methods used to obtain it, the analysis of its structure, and some of its properties are briefly considered. The prospects for its practical applications are discussedThis publication is based on a number of works on carbyne submitted for the Russian State Prize in the field of science and technology in 1993; performed at the A. N. Nesmeyanov Institute of Organoelement Compounds, Russian Academy of Sciences and the M. V. Lomonosov Moscow State University.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 3, pp. 450–463, March, 1993.     

羧基化碳纳米管嵌入石墨修饰电极对多巴胺和抗坏血酸的电催化

采用涂层和嵌入修饰法 ,将羧基化多层碳纳米管制成两种修饰电极。以多巴胺 (DA)和抗坏血酸(AA)为模型化合物 ,研究了两种修饰电极对DA和AA共存时的电催化作用。结果表明 :嵌入的方式比涂层的方式显示了更多的优点。嵌入修饰电极不仅使峰电流增加 ,并且使两者共存时的氧化峰位分离达 16 0mV ,同时 ,该电极对DA的响应灵敏于AA ,这有利于在大量的AA存在下实现对DA的测定。在 1× 10 - 3 mol/L的AA的存在下 ,还原电流的一阶导数与DA浓度在 5× 10 - 7～ 1× 10 - 4 mol/L范围内呈良好的线性关系 ;检测下限达 1× 10 - 7mol L。     

Deposition and characterization of Langmuir‐Blodgett films of cadmium arachidate/SWCNTs composites

The incorporation of single‐wall carbon nanotubes (SWCNTs) in cadmium arachidate film by means of the Langmuir‐Blodgett (LB) technique was investigated as a function of arachidic acid/SWCNT mass ratio at the air/water interface and in Langmuir‐Blodgett films. The behaviour at the air/water interface shows that SWCNTs act as an independent phase with respect to the cadmium arachidate. Deposition conditions are optimized when the weight ratio between the arachidic acid (AA) and SWCNTs is in the range 0.018:1 to 1:1. The general order of the LB multilayered structure was destroyed by the progressive density increase in SWCNT quantity as evidenced by X‐ray reflectivity (XRR) analysis. Scanning electron microscopy images indicated that when a multilayered structure was formed its layers consisted of SWCNT bundles stacked one over the other. Copyright © 2006 John Wiley & Sons, Ltd.     

负载咖啡因-活性炭新吸附材料对钼(VI)的吸附行为的研究

以生物碱（咖啡因）为衍生化试剂，用浸渍法使其负载于活性炭（ＡＣ）上，制成一种新的金属阴离子吸附材料———负载咖啡因－活性炭（ＣＡＣ）。用ＩＣＰ－ＡＥＳ研究了该吸附材料对金属阴离子［Ｍｏ７Ｏ２４］６－的吸附性能；考察了其化学稳定性；还研究了不同浓度硫酸和氨水对待测物吸附率和解脱率的影响及共存离子的干扰影响。     

Application of thermal analysis to carbon black-elastomer systems

In this study a relationship between the surface and textural properties of carbon blacks and the gasification process induced thermally in air is noted. A temperature jump method was used to follow the gasification in air and to establish the relevant Arrhenius parameters. This can be associated with the activity of ‘basal’ plane carbon atoms as well as ‘edge’ carbon atoms at the surface. This is based on a model of carbon black structure consisting of the irregular packing of small graphite carbon structures. The carbon black surface was measured using a single measurement of adsorption based essentially on the BET volumetric method. The carbon black surface had a rate of oxidation per unit are which clearly indicated that the lower area carbon blacks had a predominately active area of ‘edge’ atoms at the surface while the surface of the higher area carbon blacks had a predominate amount of ‘basal’ plane graphite carbon atoms.     

稀土高碳当量灰口铸铁组织与性能的研究

本文研究了利用稀土合金改善高碳当量灰口铸铁质量的可能性,稀土合金对高碳当 量灰口铸铁组织和性能影响的规律,以及稀土夹杂物在铸铁各相中分布的规律．发现了 稀土合金加入量与铸铁的机械性能之间明显的对应关系——“双峰值效应”。对稀土高 碳当量灰口铸铁的某些高温机械、物理、化学性能进行了研究。结果表明稀土合金加入 到高碳当量灰口铸铁中以后能净化铁水,改善组织,并提高其性能．     

溶剂萃取法制备碳酸盐的热力学讨论

向金属氯化物(Ⅰ)的水溶液中通入CO_2气体,以期制备相应的碳酸盐和酸式碳酸盐,在常温常压下,体系的△G>0,反应几乎是不可能的。向反应体系中加入有机溶剂(S),使生成的HCl即被萃取,可促进Ⅰ的继续转化。分析计算表明,S对HCl必须有很强的萃取能力,其K_萃须在10~5以上。研究了加入有机溶剂N_(235)前后,体系的热力学状态、函数及其变化。加入N_(235)后,K_萃值增大了5个数量级。考察了温度、时间和通气次数对系统热力学性质的影响。根据反应的耦合原理和热力学分析,提出萃取剂选择的原则。结合实验数据的估算说明:溶剂萃取法由Ⅰ和CO_2制备碳酸盐的工艺路线是可行的。