Low-lying states of 6He studied via the 6Li(t,3He)6He reaction

We present the recent experimental results on the ⁶He structure studied by the ⁶Li(t, ³He)⁶He reaction at 336 MeV. Above the conspicuous peaks for ground and first excited states for ⁶He, we have observed a broad structures at E _x∼ 5 MeV, and E _x∼ 15 MeV. The angular distribution of this structure exhibits the dominance of a ΔL = 1 transition, indicating the existence of intruder dipole states at low excitation energies in ⁶He. A slight admixture of positive-parity states in this structure has been indicated as well. Received: 1 May 2001 / Accepted: 4 December 2001     

Influence of SiO2 in SiCp on the microstructure and impact strength of Al/SiCp composites fabricated by pressureless infiltration

The effect of SiO₂ in SiC_p and the following processing parameters on the microstructure and impact strength of Al/SiC_p composites fabricated by pressureless infiltration was investigated: Mg content in the aluminum alloy, SiC particle size, and holding time. Preforms of SiC_p in the form of rectangular bars (10 × 1 × 1 cm) were infiltrated at 1150°C in an argon→nitrogen atmosphere for 45 and 60 min by utilizing two aluminum alloys (Al-6 Mg-11 Si and Al-9 Mg-11 Si, wt.%). The results obtained show that the presence of SiO₂ in SiC affects the microstructure and impact strength of the composites significantly. When Al₄C₃ is formed, the impact strength decreases. However, a high proportion of SiC to SiO₂ limits the formation of the unwanted Al₄C₃ phase in the composites. Also, a higher content of Mg in the Al alloy lowers the residual porosity and, consequently, increases the composite strength. The impact strength grows with decrease in SiC particle size and increases considerably when the residual porosity is less than 1%. Russian translation published in Mekhanika Kompozitnykh Materialov, Vol. 42, No. 3, pp. 401–418, May–June, 2006.     

谈青少年业余运动员的力量训练

对青少年业余运动员力量训练的作用、影响因素和训练方法进行探讨,提出力量训练要针对青少年的身心特点和专项要求,长期坚持,重视质量,其效果取决于计划的系统性和训练方法的选择。     

某库岸滑坡稳定分析及治理措施研究

从地质条件出发,详细分析了滑坡的成因,以大型的岩土工程数值分析软件(ADINA)为研究手段,建立有限元计算模型,用强度折减的方法分析了滑坡体在初始工况、蓄水工况、暴雨工况、水位骤降工况和地震工况下的稳定情况,根据滑坡的失稳情况,在综合考虑的基础上,提出了削坡减载和地表排水相结合的治理措施,计算结果表明,治理措施是可行的,研究结果对设计和施工具有较大的参考价值.     

炼镁还原罐材质的成份设计

本文针对炼镁还原罐在使用条件下的破坏形式及对该材质的成份设计进行了分析 ,还原罐材质在具有单一奥氏体的基础上 ,进行良好的合金化处理是提高其抗蠕变性和热强性的有效方法 ,对提高材质的使用寿命起到良好的作用。     

Study of local lattice relaxation of substitutional impurities in silicon and germanium

Local lattice relaxation of substitutional donors in silicon investigated using self‐consistent multiple scattering Xα (MSXα) method within the framework of the standard muffin‐tin potential approximation is extended to substitutional donors in germanium and substitutional acceptors in both silicon and germanium. Incorporating the effect of lattice relaxation surrounding the impurity makes the model suitable for both shallow and deep levels. Chemical trends of some aspects of impurity states, such as local lattice relaxation and charge transfer, of the impurities both in silicon and germanium are inferred. © 2004 Wiley Periodicals, Inc. Int J Quantum Chem, 2004     

集中荷载下叠合梁抗剪强度

本文对低叠合面钢筋破简支在合梁二阶段受力的斜截面抗剪性能进行了试验研究，并运用非线性有限元分析和试验实测数据，得出了一个适合于集中荷载下高低叠合面叠合梁的抗剪强度计算公式．     

Interpretation of the polyelectrolyte and antipolyelectrolyte effects of poly(N‐vinylimidazole‐co‐sodium styrenesulfonate) hydrogels

Hydrogels of N‐vinylimidazole (VI) and sodium styrenesulfonate (SSS) were synthesized in aqueous solution by radical crosslinking copolymerization with N,N′‐methylene‐bis(acrylamide) as crosslinker. Swelling in several saline solutions was measured for hydrogel samples synthesized with different comonomer concentrations (C_T = 10, 25, or 40%) and with SSS mole fractions covering a broad range (f_SSS = 0–0.7), while the crosslinker ratio was 2 wt % in all cases. The degree of swelling in aqueous solution with a specific ionic strength (μ), plotted versus the SSS composition of the feed, shows a minimum for any set of samples synthesized with a fixed C_T. The dependence of swelling on μ shows both polyelectrolyte (f_SSS beyond the minimum) and antipolyelectrolyte behaviors (in the low f_SSS limit). It was found that the nonGaussian factor of the crosslinking density and the polymer‐solvent interaction parameter increase with f_SSS for any C_T. Moreover, in the low f_SSS limit, the osmotic swelling pressure is governed not only by the ionic contribution, but also by the polymer‐solvent mixing and, the concentration of mobile counterions inside the gel is not proportional to the net fixed charge but to the addition of cationic and anionic side groups, what discards the formation of ionic pairs. The antipolyelectrolyte effect is interpreted as due to the increasing protonation of VI as μ goes up. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1683–1693, 2007     

Y32－300型四柱式压力机工作台的设计

利用弹性力学的变分原理，对Ｙ３２－３００型四柱式万能压力机主机工作台的强度和刚度进行了研究，并给出了估算其变厚度的实用方法。     

碱金属对焦炭反应性和反应后强度的影响

作者通过焦炭的浸碱试验，阐述了碱金属对焦炭反应性和反应后强度的影响，认为碱金属加速了焦炭的气化反应。显微组织研究表明，气化后的焦炭有明显的烧蚀现象。由此产生裂隙，形成许多脆弱薄壁的连通孔，导致焦炭强度下降，块度变小