Synthesis,crystal growth and characterisation of 2-aminomethylpyridinium picrate (2-ampp)-a charge transfer molecular complex and organic nonlinear optical material

Single crystals of 2-aminomethylpyridinium picrate (2-AMPP) were grown by slow evaporation-solution growth technique at room temperature. The cell and structural parameters of the grown crystal were determined by single crystal X-ray diffraction analysis. The characteristic functional groups in the compound were identified from Fourier transform infrared spectroscopy. The transmission and absorption spectra of this crystal show that the lower cut-off wavelength lies at 360 nm. Thermal analysis was performed to study the thermal stability of the grown crystal. The powder second harmonic generation efficiency of the grown crystal measured by Kurtz technique is 2 times efficient than potassium dihydrogen orthophosphate (KDP). Vicker's microhardness test showed that the hardness value increases with increasing the applied load up to 50 g. The dielectric measurements of the compound in the frequency region from 50 Hz to 5 MHz showed that the material has lesser defects and can be used for optical application.     

Synthesis,Properties, and Applications of 2-D Materials: A Comprehensive Review

Recent advances in atomically thin two-dimensional (2-D) materials have led to a variety of promising future technologies for post-CMOS nanoelectronics and energy generation. This review is an attempt to thoroughly illustrate the current status and future prospects for 2-D materials other than graphene (e.g., BN nanosheets, MoS₂, NbSe₂, WS₂, etc.), which have already been contemplated for both low-end and high-end technological applications. An overview of the different synthesis techniques for 2-D materials is presented here, with an exploration of the potential for developing methods of controllable large scale synthesis. Furthermore, we summarize the underlying theories which correlate the structural and physical properties of 2-D materials with their state-of-the-art applications. Finally, we show that utilizing the unprecedented properties arising from these materials would lead to innovative devices. Such devices would significantly reduce both device dimensions and power consumption, as necessary for the creation of tomorrow's sustainable technology.     

Spectral,Optical and Mechanical studies on pure and thiourea doped ammonium di-hydrogen phosphate NLO single crystals

Pure and thiourea substituted single crystals of ammonium di-hydrogen phosphate have been grown from aqueous solution by isothermal solvent evaporation technique. Doped crystal exhibits prominent changes in physical and chemical properties. Single crystal XRD analyses of the samples are carried out and the results are compared. FTIR and UV–vis–NIR spectral analyses have been employed to identify the presence of various functional groups and the UV cut-off range in the grown crystals. Density measurements have been made and Photoconductivity studies revealed the negative photo conducting nature. Hardness measurement shows that the mechanical strength of the doped crystal is high when compared to pure ammonium di-hydrogen phosphate. The dielectric response of the samples has been studied in the frequency range 100 Hz–5 MHz at room temperature and the results are discussed.     

An unconventional method for measuring the Tc L3‐edge of technetium compounds

Tc L₃‐edge XANES spectra have been collected on powder samples of SrTcO₃ (octahedral Tc⁴⁺) and NH₄TcO₄ (tetrahedral Tc⁷⁺) immobilized in an epoxy resin. Features in the Tc L₃‐edge XANES spectra are compared with the pre‐edge feature of the Tc K‐edge as well as other 4d transition metal L₃‐edges. Evidence of crystal field splitting is obvious in the Tc L₃‐edge, which is sensitive to the coordination number and oxidation state of the Tc cation. The Tc L₃ absorption edge energy difference between SrTcO₃ (Tc⁴⁺) and NH₄TcO₄ (Tc⁷⁺) shows that the energy shift at the Tc L₃‐edge is an effective tool for studying changes in the oxidation states of technetium compounds. The Tc L₃‐edge spectra are compared with those obtained from Mo and Ru oxide standards with various oxidation states and coordination environments. Most importantly, fitting the Tc L₃‐edge to component peaks can provide direct evidence of crystal field splitting that cannot be obtained from the Tc K‐edge.     

Optical emission behaviors of C,Al, Ti,Fe, Cu,Mo, Ag,Ta, and W wire explosions in gaseous media

Electrical explosion of wires (EEW) is a promising method for nanopowders preparation and insensitive explosives ignition. Plasma radiation plays a key role in the ignition process while little attention has been paid on this phenomenon before. This letter introduces optical emission behaviors of electrical explosions for nine materials in air, Helium, and Argon with the SWE-2 platform. Experimental results indicated that the light intensity for non-refractory metals decayed rapidly after the discharge ended. In contrast, for refractory metals, the emission continued to increase and lasted for a long period after the discharge ceased. As for spectra, the emission consisted of line and continuous spectra. With the atomic number increased, the density of lines grew rapidly, leading to a “continuous” appearance.     

Ge-Sb-Se硫系玻璃的折射率和热光系数

Ge-Sb-Se硫系玻璃被认为是极佳的红外传输材料和有潜力的非线性光学材料.在光学设计中,玻璃的线性折射率(n)及其热光系数(ζ)是关键技术参数.以预测和调控Ge-Sb-Se玻璃的n和ζ为目的,考察了玻璃的n,ζ,密度(d)和体积膨胀系数(β)与化学参数dSe和拓扑网络结构参数r的内在联系.研究发现,玻璃的n随d的增加而增大;ζ随β的增大而近似线性减小;β随dSe的减小或r的增大而减小;当Ge含量固定时, d随dSe的减小或r的增大而增大,当Sb含量固定时, d在dSe=0时具有最小值.基于实测d和n,拟合获得了Ge, Sb和Se元素在2—12μm波段的摩尔折射度(R_i),分别为R_(Ge)=10.16—10.50 cm~3/mol,RSb=16.71—17.08 cm~3/mol和RSe=11.15—11.21 cm~3/mol,根据d和R_i计算得到的n与实测值的偏差小于1%.基于实测ζ和β,拟合得到了Ge, Sb和Se元素在2—12μm波段的摩尔折射度温度系数(φ_i),分别为φ_(Ge)=21.1—22.6 ppm/K,φ_(Sb)=7.2—8.4 ppm/K和φ_(Se)=90.2—94.2 ppm/K,根据β和φ_i计算得到的ζ与实测值的偏差小于6 ppm/K.     

锑烯吸附金属Li原子的密度泛函研究

锑烯(antimonene)是继石墨烯和磷烯之后出现的新型二维材料,在锂离子电池等领域受到关注.本文基于第一性原理的密度泛函理论,计算研究了锑烯对Li原子的吸附特性,包括Li原子的最稳定吸附构型、吸附密度以及吸附Li原子的扩散路径.结果表明:Li原子最稳定的吸附位置位于谷位,即底层Sb原子之上、顶层三个Sb原子中心位置,吸附能为1.69 eV,吸附距离为2.81?;能带计算发现,锑烯为带隙宽度1.08 eV的间接带隙半导体,吸附Li原子后费米能级上升进入导带,呈现出金属性;原子分波态密度分析发现, Sb原子的p电子态和Li原子的p和s电子态形成明显的共振交叠,表现出杂化成键的特征;随着吸附Li原子数量增加,锑烯晶格结构和电子结构发生较大变化.通过微动弹性带方法计算发现, Li原子在锑烯表面的扩散势垒为0.07 eV,较小的势垒高度有利于快速充放电过程.     

Self‐organization of functional gradient structure in the biodegradable chitosan/poly(vinyl alcohol) blend film

Biologically inspired optimal structures combining the bioresorbable and bioactive properties are expected for the next generation of biomaterials. A compositional gradient structure was found to be spontaneously formed in the film of biodegradable chitosan/poly(vinyl alcohol) blend by casting aqueous solution on an aluminum dish. The formation of compositional gradient structure was confirmed by FTIR mapping measurement, DMTA measurement, and SEM observation on the freeze‐fractured cross section. In DMTA measurement, a broadening of the α‐relaxation curve corresponding to the glass transition was observed for the compositional gradient film, while a composition‐dependent single glass transition was observed for the homogeneous blend films. The resulted film with stable self‐organized compositional gradient exhibits novel physical properties inaccessible for the film of homogeneous blends obtained by casting from the same solution on a Teflon dish. The compositional gradient films present a unique combination of stronger stress and higher yield strain when compared with those of the homogeneous films at both dry and wet states. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 43: 3069–3076, 2005     

Analyses of intrinsic inhomogeneity and metal segregation in samples of Ag–Ge–Se glasses

Ge_ySe_(1−y) glasses are semiconductors but when Ag is added above certain threshold concentration, Ag_x[Ge_ySe_(1−y)]_(100−x) glasses behave as fast ionic conductors [Ureña et al., Solid State Ionics 176 (2005) 505]. This peculiar behavior may be attributed to the intrinsically inhomogeneous nature of these glasses where zones rich in metals coexist with zones of the host material. The conductivity transformation may be ascribed to the percolation of the Ag rich phase [Pradel et al., J. Phys.: Condens. Matter 15 (2003) S1561].Ag_x[Ge_0.25Se_0.75]_(100−x) glasses either massive or as films were obtained by melt quenching and pulsed laser deposition (PLD), respectively, in compositions belonging to the Se rich corner of the ternary phase diagram. Their amorphous nature and intermediate range order was checked employing X-ray diffractometry (XRD), the short range order was characterized by extended X-ray absorption fine structure (EXAFS) (Ge and Se K absorption edge) and their microstructure was characterized by scanning electron microscopy (SEM) and small angle X-ray scattering (SAXS).     

高骨架填充率的SiO2有序大孔材料的制备

以SiO2有序大孔材料制备作为研究对象,系统考察了胶晶模板法中影响前驱物填充率的诸因素,包括填充方法、填充时间和填充次数.研究表明,直接浸渍法易导致大孔结构的收缩、脱落和表面覆盖.本文提出的在模板表面添加盖片再填充的方法有效解决了上述问题.当填充时间为5 min、填充次数为两次时,SiO2有序大孔材料的骨架填充率较高.扫描显微镜(SEM)和分光光度计的表征结果证实,实验成功制备了填充率高达22.53%的大面积SiO2有序大孔材料.