用微芯片化学反应器实现酶催化化学发光测定葡萄糖的研究

葡萄糖是临床化学诊断以及食品分析中重要的检测项目 ,最常用的测定方法是采用葡萄糖氧化酶(GOD)催化葡萄糖与氧分子间反应 ,生成葡萄糖酸和过氧化氢 [1] ,而对过氧化氢的检测则可采用过氧化酶 (POD)催化鲁米诺的化学发光反应进行 [2 ] .FIA对整个过程的实现是十分有效的方式 ,但由于多采用固定化酶反应器 [3～ 5] 使其在制备及分析上较复杂且费用高 .由 Manz等[6] 提出的微型全分析系统(μ- TAS)在针对不同体系的微量分析及在线监测上均具有突出的优越性 .本文使用的含微混合器的微芯片化学反应器采用μ- TAS设计思想 ,建立了化学发…     

O-取代苯基-O-(2-硬脂酰胺基)乙基-N,N-二(2-氯乙基)磷酰胺的合成和生物活性

N-脂肪酰基乙醇胺(NAE)作为植物体内的一种内源物质, 在调节植物生长方面起着重要作用. 为了弥补其分子结构中长的脂肪链所带来的溶解性能以及在植物体内传导性能的缺陷, 我们将N-硬脂酰乙醇胺(NAE18)引入氮芥磷酸酯中, 合成了一系列标题化合物. 在合成工作中发现: 在NAE18与氮芥芳基磷酰氯的反应过程中, 4-二甲氨基吡啶(DMAP)起着关键性的催化作用. 在不加DMAP的相同实验条件下, 反应不能进行. 对所合成的标题化合物进行了植物生长调节和杀菌活性的测定, 初步生测结果表明: 经过结构修饰后, 大多数目标化合物的活性相对NAE18有所增强, 但有关生物活性仍有待进一步研究.     

N′-5-四唑基-N-芳甲酰基硫脲的合成及其生物活性研究(I)

为寻找新的高活性农药 ,根据生物等排原理 ,设计合成了 10种未见文献报道的N′ 5 ( 1H 1,2 ,3 ,4 四唑基 ) N 芳甲酰基硫脲类化合物 .它们的结构经IR ,1HNMR和元素分析确证 .初步的生物活性测定结果表明 ,部分化合物具有优良的除草活性或植物生长调节活性 .     

Carbon Paste Electrode for the Potentiometric Flow Injection Analysis of Drotaverine Hydrochloride in Serum and Urine

A carbon paste electrode for drotaverine hydrochloride (DvCl) was prepared and fully characterized in terms of composition, life span, usable pH range, response time and temperature. The electrode was applied to the potentiometric determination of drotaverinium ions in pharmaceutical preparations and biological fluids in steady state and flow injection conditions (FIA). The electrode is based on a mixture of two ion exchangers, namely, drotaverinium-silicotungestate and drotaverinium-tetraphenylborate dissolved in tricresyl phosphate as pasting liquid. The modified electrode showed a near-Nernstian slope of 59.34±2mV over the concentration range of 5.0×10^–7–1.0 × 10^–2M. The electrode exhibits good selectivity for DvCl with respect to a large number of inorganic cations, organic cations, sugars and amino acids. Potentiometric titrations of DvCl with several titrants have been monitored using this modified carbon paste electrode as an end-point indicator electrode. The proposed electrode offers the advantages of simplicity, accuracy, automation feasibility and applicability to turbid and colored samples.     

Comparative study of 8-hydroxyquinoline derivatives as chelating reagents for flow-injection preconcentration of cobalt in a knotted reactor

8-Hydroxyquinoline (HQ), 2-methyl-8-hydroxyquinoline (CH₃-HQ), 5,7-dichloro-2-methyl-8-hydroxyquinoline (Cl₂-CH₃-HQ), 5,7-dibromo-8-hydroxyquinoline (Br₂-HQ), 5-sulfo-7-iodo-8-hydroxyquinoline (ferron) and 5-sulfo-8-hydroxyquinoline (SO₃H-HQ) were compared as chelating reagents for on-line sorption preconcentration of cobalt in a knotted reactor (KR) precoated with the reagent. The results obtained with the different HQ derivatives reveal those properties of the chelating reagent responsible for the processes taking place in the KR. The influence of hydrophobicity, acidity, stability of the cobalt chelate and type of substituents in the HQ ring system on the separate steps of the flow injection (FI) preconcentration procedure are discussed. According to the performance characteristics of the different HQ derivatives, the most important parameters for on-line preconcentration in a KR are the hydrophobicity of the reagent and the stability of the chelate complex with the analyte.     

Characterization of the Converging Jet Region in a Triple Torch Plasma Reactor

Enthalpy probe measurements were taken of the converging plasma plume in a triple torch plasma reactor and related to substrate heat flux measurements. Results show excellent entrainment of process gases injected into the converging plasma plume by way of the central injection probe. At lower pressures (40 kPa), the plasma volume is equivalent to at least a 3 cm diameter, 4 cm long cylinder, with relatively uniform temperature, velocity, and substrate heat flux profiles when compared to a typical dc arc jet. Converging plasma plume size, substrate heat flux, and enthalpy profiles are also shown to be a strong function of applied system power. Substrate heat flux measurements show smaller radial gradients than enthalpy probe measurements, because of the high radial velocity component of gases above the substrate boundary layer. Enthalpy probe measurements were also conducted for diamond deposition conditions and approximate temperature and velocity profiles obtained. Problems with the uniform gas mixture assumption prohibited more accurate measurements. Reproducibility of enthalpy measurement results was shown with an average standard deviation of 11.8% for the velocity and 7.6% for the temperature measurements.     

Synthesis, Structure and Biological Activities of Novel Triazole Compounds Containing N,N-Dialkyldithiocarbamate Moiety

Introduction As an important type of fungicides, triazole compounds are highly efficient, low poisonous and inward absorbent.1-3 At present, the studies on triazole derivatives are mainly concentrated on compounds with triazole as the only active group. The report of triazole compounds that contain both triazole group and other active group in a single molecule has rarely been found. Dialkyl-substituted dithiocarbamate salts have also shown interesting biological effects.4 N,N-Dialkyldithio-…     

The application of levulinic acid and 5-nitro-2-furylmethylene diacetate in the total synthesis of some novel biologically active (5-nitro-2-furyl)azomethines

Summary The syntheses andin vitro antibacterial and antifungal evaluation of certain (5-nitro-2-furyl)azomethines with different heterocyclic nuclei are described.

---

Die Anwendung von Lävulinsäure und 5-Nitro-2-furylmethylendiacetat in der Totalsynthese einiger neuer biologisch aktiver (5-Nitro-2-furyl)azomethine

Zusammenfassung Es wird die Synthese und diein-vitro-antibakterielle und antifungale Wirksamkeit für bestimmte (5-Nitro-2-furyl)azomethine mit verschiedenen heterocyclischen Kernen beschrieben.

     

Parametric analysis of kinetic models. XIV. Autocatalytic trigger and oscillator in a flow system

In a flow catalytic reactor with an autocatalytic trigger as a kinetic subsystem, the conditions have been found, in which oscillations appear. Some peculiarities of the kinetic model dynamics, where the kinetic subsystem is an autocatalytic oscillator, are investigated.     

Liquid fluidized bed starter culture ofTrichoderma reesei for cellulase production

A starter culture ofTrichoderma reesei (Rut-C30) prepared in a liquid fluidized bed reactor (LFBR) gave better growth and greater cellulase production in submerged fermentation than a conventional shake flask inoculum. The LFBR starter was prepared by first coatingT. reesei spores to 0.25 mm size corncob (1.0x10⁸g^-1) in a medium containing 1.0% corncob, 0.5 gL^-1 xylose and 0.1 gL^-1 lactose in a balanced salt solution, then fluidizing the particles in the LFBR for 36 h to allow germination of the spores, and covering the particles with an approx 30 μm thick biofilm. This biofilm that developed in constant adherence to the lignocellulosic carrier, apparently became well adapted to grow rapidly on insoluble cellulose substrates (Solca Floc), and had the enzymes of the cellulase complex induced for increased cellulase production. The LFBR starter used in a stirred tank reactor (STR) gave 15 gL^-1 biomass production and 6.5 IU mL^-1 overall cellulase activity with a volumetric productivity of 64 IU L^-1h^-1 in a 5 d fermentation, compared with a 7 d shake flask inoculum that gave 11 gL^-1 biomass and 3.2 IU mL^-1 cellulase activity, with a volumetric productivity of 31IU L^-1h^-1. The LFBR starter culture retained its viability in dry storage for 6–9 mo.