An efficient procedure for the synthesis of coumarin derivatives using TiCl4 as catalyst under solvent-free conditions

The ability of titanium(IV) chloride as a catalyst to promote the Pechmann condensation reaction with a range of phenols and β-keto esters is described.The reaction was carried out by addition of TiCl₄ to a mixture of the phenol and the β-keto ester with thorough stirring in the absence of a solvent and represents an improvement on the classical Pechmann conditions. The yields of coumarins obtained via this novel protocol were significantly higher than those using the conventional method and the reaction duration was reduced to a few minutes or even a few seconds.     

Frequent analytical/experimental problems in lipase-mediated synthesis in solvent-free systems and how to avoid them

Compared with chemical catalysis, enzymatic catalysis is a relatively new topic. Experimental work involving lipases deserves careful attention and accurate procedures still need to be implemented. A rapid but careful survey of published data immediately demonstrates that experiments performed under similar conditions with similar reagents have led to very different results. The aim of this work is to point out the importance of accurate and systematic procedures in order to ensure the reproducibility of experimental data. We strongly believe that different results found by different labs are due to problems detected in the procedures used. Quantification of the immobilisation efficiency of lipase on several supports through UV/visible methods and sampling methods used to obtain correct enzymatic activity values are specifically analysed. After a brief review which demonstrates the big discrepancies found in the literature, original data from Candida rugosa lipase adsorption on polypropylene powder and its use in the solvent-free synthesis of ethyl oleate are introduced in order to exemplify the difficulties found in these kinds of systems. Several procedures described in the literature are assayed and the accuracy of the results obtained is carefully analysed. The aim of the whole analysis performed is that it would be useful for any powdered solid to be used as a support for a lipase in a solvent-free system for any synthesis reaction, especially for those involving a volatile reagent. Throughout this contribution, special emphasis is placed on how catalytic reaction results using enzymes (free and immobilised) are reported so as to allow comparison between published data, something which is usually difficult since very different units are used and often complementary data are not included.     

Ferroelectric phase transitions in Pb2xSn2(1-x)P2Se6 system

Heat capacities of the Pb_2xSn_2(1-x)P₂Se₆ crystals (x=0, 0.098, 0.251, 0.402 and 1.0) were measured using an adiabatic calorimeter at temperatures between 10 and 350 K. In the crystal of x=0, two heat capacity anomalies corresponding to the ferroelectric commensurate - intermediate incommensurate(C-IC) phase transition temperature T _i, and the incommensurate - paraelectric (IC-N) phase transition temperature T _c, were observed at 193.24±0.10 and 220.07±0.15 K, respectively. The phase transition temperatures decreased with an increase in Pb²⁺ concentration. The anomaly at Ti disappeared at x=0.251 in the mixed systems of the Pb_2xSn_2(1-x)P₂Se₆. In the crystal of Pb₂P₂Se₆ (x=1.0), no phase transition was observed. The normal heat capacities for the mixed crystals were determined by least squares fitting of the Debye and Einstein functions to the experimental data. The anomalous heat capacities gave the phase transition entropies of 8.5 and 1.5 J mol^-1 K^-1 for x=0. The large transition entropies are consistent with an order-disorder mechanism in the ferroelectric-paraelectric phase transitions in x=0. This revised version was published online in August 2006 with corrections to the Cover Date.     

Diagramme de phases du systeme binaire LiNO3-NaNO3

Phase diagram of the binary system LiNO₃-NaNO₃ has been obtained by using direct and differential thermal analysis between 323 and 623 K. This system is characterized by an eutectic plateau at 467 K. The eutectic point is at 0.465 mole NaNO₃. A peritectic appears at 550 K. There is no miscibility in the solid state. These findings associated with some other thermodynamic results have been used to calculate the activities of the constituents along the liquids curve and the excess thermodynamic functions at 618 K. The constituents seem not to have a symmetrical influence on the thermodynamic quantities.

     

Synthesis of a new donor, BEDT-HBDST and crystal structures, electrical and magnetic properties of (BEDT-HBDST)2MX4 (M=Fe, Ga, X=Cl, Br), where BEDT-HBDST=2,5-bis(4,5-ethylenedithio-1,3-diselenol-2-ylidene)-2,3,4,5-tetrahydrothiophene

A novel conjugation-elongated bis(ethylenedithio)tetraselenafulvalene (BETS) type donor, 2,5-bis(4,5-ethylenedithio-1,3-diselenol-2-ylidene)-2,3,4,5-tetrahydrothiophene (BEDT-HBDST) and its magnetic and non-magnetic anion salts, (BEDT-HBDST)₂MX₄ (MX₄⁻=FeCl₄⁻, GaCl₄⁻, FeBr₄⁻ and GaBr₄⁻), were prepared. These four salts are isostructural and belong to the space group of P2/c. They showed semiconducting behavior with small activation energies (59-64 meV). The band structures of these salts are quasi one-dimensional and there is a midgap between the upper band and the lower band, since the degree of dimerization is significant in the stacking direction. The MX₄⁻ ions are located between the donor columns and near to the ethylenedithio moieties of the donor molecules. The magnetic susceptibilities of the FeCl₄⁻ and FeBr₄⁻ salts follow the Curie-Weiss law with Curie constants of 4.6 and 4.8 emu K mol⁻¹ (sum of the spins of S=5/2 and S=1/2) and negative Weiss temperatures of θ=−1.2 and −4.9 K, respectively, revealing a weak antiferromagnetic interaction of 3d spins of the FeCl₄⁻ and FeBr₄⁻ anions. The Fe?Fe (6.66-7.60 Å), Cl?Cl (4.81-4.82 Å) and Br?Br (4.74-4.77 Å) distances in the crystal structures of these salts are significantly long. Therefore, the direct magnetic interaction between the 3d spins of the nearest neighboring Fe³⁺ ions appears to be not readily accessible.     

模式识别—人工神经网络在化学中的若干新应用

本文通过我们应用模式识别－人工神经网络方法预报新化合物、熔盐相图以及复杂化学反应体系的研究，展示应用模式识别－人工神经网络方法与物理化学理论相结合，研究化学现象的可能性和应用价值。     

Two-dimensional separation system of coupling capillary liquid chromatography to capillary electrophoresis for analysis of Escherichia coli metabolites

A two-dimensional (2-D) separation system of coupling chromatography to electrophoresis was developed for profiling Escherichia coli metabolites. Capillary liquid chromatography (LC) with a monolithic silica-octadecyl silica column (500 x 0.2 mm ID) was used as the first dimension, from which the effluent fractions were further analyzed by capillary electrophoresis (CE) acting as the second dimension. Field-enhanced stacking was selectively employed as a concentration strategy to interface the two dimensions, which proved to be beneficial for the detection of metabolites. An artificial sample containing 118 standards, some of which lack chromophores or have weak UV absorbance, was used to optimize the 2-D separation system. Under the optimum conditions, 63 components in the artificial sample having absorbance at 254 nm could be well resolved and detected. The utility of the system was demonstrated by comprehensive analysis of E. coli metabolites. Comparing with the previous 2-D separation system we published in Anal. Chem. 2004, 76, 1419-1428, using a longer monolithic column in the first dimension improved the separation efficiency and offered the possibility of increasing the injection volume without compromising the separation efficiency. In the second dimension, field-enhanced stacking was used to improve the concentration sensitivity of the metabolites, and more metabolites in E. coli cell extract were detected and identified using the developed 2-D separation system. In addition, preliminary investigation for future CE-mass spectrometry coupling was also made in the study by using volatile buffers in the capillary LC and CE techniques.     

Fuzzy theory in analytical chemistry

The concept of fuzzy theory is described in order to provide the analyst with the means for dealing with vague statements, uncertain observations or the fuzziness of human perception and interpretation, in general. In a theoretical part, basic notions of fuzzy theory are given, such as types of membership functions, operations with fuzzy sets, definitions of fuzzy numbers, points, functions, and relations, and the use of linguistic variables. The difference between fuzziness and probability is outlined. The applications section demonstrates advantages of fuzzy theory methods compared to common mathematical methods with respect to data handling for calibration of analytical methods, to classification of Chromatographie and spectroscopic patterns, to component identification and multicomponent analysis, and to designing fuzzy expert systems for selection of analytical procedures.