Kinetics of the Formation of Goethite in the Presence of Sulfates and Chlorides of Monovalent Cations

The synthesis of goethite by oxidation of Fe²⁺in presence of metallic iron was undertaken in an aqueous medium containing indifferent salts such as Na₂SO₄, (NH₄)₂SO₄, NaCl, and NH₄Cl. Temperature and bubbling air rate were maintained, respectively, at 70°C and 1 L/min. The influence of anions and cations on the kinetics of each step of the process has been followed distinctly, the iron dissolution rate has been determined by the variation of the medium acidity, and the precipitation of goethite has been determined by gravimetric measurements. With respect to Cl⁻, the SO₄²⁻anion decreases the rate of the two reactions. NH₄⁺acts as an inhibitor when it is present at low concentrations and as an accelerator for higher concentrations; the limit corresponding to the change of NH₄⁺behavior depends on the nature of the counter ion. The reaction product is composed of pure goethite in the presence of sulfate salts, whereas a mixture of goethite and lepidocrocite, respectively, 60–70 and 40–30%, was observed in the presence of chloride salts.     

Solid Phase Extraction and Simultaneous Spectrophotometric Determination of Trace Amounts of Copper and Iron Using Mixture of Ligands

 A novel sensitive and simple method for rapid and selective extraction, preconcentration and determination of iron (as its bathophenanthroline complex) and copper (as its neocuproine complex) using octadecyl silica cartridges and dual wavelength spectrophotometry is presented. The dual wavelength method (533 nm for the iron-bathophenanthroline and 454 nm for the copper-neocuproine as the analytical wavelength) is used to eliminate spectral interferences. Extraction efficiency and the influence of flow rates of sample solution and eluent, pH, amount of neocuproine, bathophenanthroline and hydroxylamine hydrochloride, type and least amount of eluent for elution of iron and copper complexes from cartridge, break-through volume and limit of detection are evaluated. The effects of various cationic and anionic interferences on percent recovery of iron and copper are also studied. Extraction efficiencies >95% are obtained by elution of cartridges with minimal amount of organic solvent. Iron and copper were determined in the range of 3–100 ng mL⁻¹. The limits of detection are 0.98 and 1.13 ng mL⁻¹ for iron and copper, respectively. The proposed method is applied successfully to the determination of both analytes in river, tap and well water samples. Author for correspondence. E-mail: yyamini@modares.ac.ir Received September 18, 2002; accepted December 12, 2002 Published online May 5, 2003     

Selective Formation of Spinel Iron Oxide in Thin Films by Complexing Agent-Assisted Sol-Gel Processing

The structure of iron oxide was controlled by regulating the hydrolytic polymerization of aquo iron complexes with organic polydentate ligands such as diols. Iron oxides were prepared by calcining the precursor polymers obtained from iron nitrate nonahydrate and diols. When the diols were 1,2-pentanediol, 1,2-hexanediol and 1,2-octanediol, α-Fe₂O₃ with corundum structure appeared exclusively or as the main crystalline phase, in spite of the amount of diol used and the calcination temperature. In the case of 1,2-decanediol and 1,2-dodecanediol, when five moles of the diols were used to one mole of iron nitrate and the calcination temperatures were below 400°C, ψ-Fe₂O₃ with spinel structure appeared as the main phase and, when less than five moles of the diols were used, α-Fe₂O₃ appeared exclusively or as the main phase, irrespective of the calcination temperature. This tendency was also observed in thin films. Thus, a transparent magnetic film composed of γ-Fe₂O₃ could be prepared by applying a benzene solution of the iron polymer, obtained with 5 equivalents of 1,2-decanediol, on quartz and calcining the gel film at 350°C.     

Determination of boron in boron-alloyed steels by inductively coupled plasma atomic emission spectrometry

An inductively coupled plasma atomic emission spectrometry (ICP-AES) procedure has been developed and examined for the determination of boron content (0.01 up to about 2% B) in boron-alloyed steels such as POLDI ATA BOR (65% Fe, 19%Cr, 12% Ni, 1.5% Mn, 1% B), POLDI ATA BOR EXTRA (62% Fe, 18% Cr, 13% Ni, 2.5% Mo, 1.5% Mn, 1% B) and POLDI ATA BOR-R (75% Fe, 18% Cr, 3.5% Ti, 1.8% B). The steel sample is dissolved with a mixture of hydrochloric, nitric, sulfuric and phosphoric acids in a quartz vessel. Borides of alloyed metals, especially of iron and chromium, are quantitatively decomposed. The presence of phosphoric acid in a sample solution reduces the volatility of boric acid with water vapour.Presented in part at the 1989 European Winter Conference on Plasma Spectrochemistry, Reutte, Austria     

Application of thermomagnetometry to corrosion studies of archaeological iron

Summary Thermomagnetometry has been applied to mineralized archaeological iron samples and samples from accelerated corrosion tests. It has successfully quantified the degree of corrosion, measured by the loss of iron, as well as the amount of magnetite formed and water held in the corrosion and adhered soil layers. Thermomagnetometry, thermogravimetric analysis and differential scanning calorimetry have been applied to the reported corrosion products from archaeological iron. Fourier transform infra-red and Raman spectroscopies and X-ray diffraction analyses were undertaken on the residues and at intermediate heating stages, where the thermal analyses indicated, to identify the reaction products.     

Carbonylation of Benzyl Halides Over Two-Phase Catalyst of Iron Pentacarbonyl

Carbonylation of benzyl halides to phenylacetic acid was studied in a two-phase system with iron pentacarbonyl as the catalyst precursor. The solutions consisted of a benzyl halide and iron pentacarbonyl in benzene and tetrabutylammonium hydrogen sulfate in aqueous sodium hydroxide. Stirring under carbon monoxide readily produced phenylacetic salts in aqueous phase which were then acidified and extracted with ether. The yields of phenylacetic acid from benzyl iodide and from benzyl bromide were similar at a evel of about 50percnt;, that of the latter being higher by 1%. The yield from benzyl chloride was far less, at a level of only 21%. The rate as studied with gas chromatography was found to decrease in the order benzyl iodide>benzyl bromide>benzyl chloride.     

半化学法制备Pb(Fe2/3W1/3)O3陶瓷粉体的反应机理

铅系弛豫铁电陶瓷钨铁酸铅Pb(Fe2/3W1/3)O3(PFW)是一种重要的介电材料,具有较大的介电常数(8000)和较低的烧结温度(小于900℃),适用于制备低烧高介的多层陶瓷电容器犤1～4犦。在传统氧化物法合成PFW的过程中,易生成恶化介电性能的钨酸铅(PbWO4或Pb2WO5)或焦绿石相(Pb2FeWO6)等其他相犤3,4犦。尽管通过加入过量5%的Fe2O3可以消除这些其他相,但因含较多的变价铁离子(Fe3+和Fe2+)而产生介电老化的缺点犤5犦。虽然二次合成法被广泛用于制备铅系弛豫铁电陶瓷犤6犦,但对制备PFW陶瓷的效果并不明显,仍有少量的钨酸铅PbWO4存在,并且预烧…     

Thermal investigation of iron(III) and manganese(II,III) complexes of dianils derived from 6-formylkhellin

Manganese and iron complexes of Schiff bases derived from 6-formylkhellin were prepared and characterized. Complexes of o-phenylenediamine derivative (ligand (I)) are monomeric or dimeric whereas those of p-phenylenediamine derivative (ligand (II)) are polymeric. The complexes obtained are characterized by a lower magnetic moment values. The complexes also have different solvent of crystallization with different nature of interaction. The thermal behaviour of the ligands and their metal complexes was investigated by means of DTA, TG, IR and X-ray diffraction spectroscopy. Ligand (I) shows different thermal behaviour from that of ligands (II) and (III). The complexes of ligand (II) give abnormal oxides as a final product during their thermal decomposition. This revised version was published online in August 2006 with corrections to the Cover Date.     

The role of radicals in enzymatic processes

Research on the mechanism of action of coenzyme B12, adenosylcobalamin, as a graduate student introduced the author to the field of organic free radicals in enzymology. Twenty years later, related work on S-adenosylmethionine (SAM) as a "poor man's coenzyme B12" was initiated in a detailed analysis of the mechanism of action of lysine 2,3-aminomutase (LAM). The interconversion of L-lysine and L-beta-lysine is catalyzed by LAM, which requires SAM, pyridoxal-5'-phosphate (PLP), and a [4Fe-4S] cluster as coenzymes. The mechanism of this reaction has been delineated as a radical isomerization, in which radical formation is initiated by the [4Fe-4S]-dependent cleavage of the SAM into methionine and the 5'-deoxyadenosyl radical. The mechanism of this process is discussed, together with the role of this radical in hydrogen abstraction from lysine to initiate the substrate radical isomerization. The chemistry underlying the functions of SAM, PLP, and [4Fe-4S] in the action of LAM is novel in all respects, except for the formation of a lysine-PLP aldimine at the active site. Of the four free radicals in the mechanism, three have been characterized by EPR spectroscopy. In the suicide inactivation of adenosylcobalamin-dependent dioldehydrase (DDH) by glycolaldehyde, the formation of cob(II)alamin and 5'-deoxyadenosine is accompanied by the conversion of glycolaldehyde to cis-ethanesemidione radical at the active site. The cis-ethanesemidione radical has been characterized by EPR spectroscopy. Its exceptional stability at the active site is the basis for the inactivation of DDH by glycolaldehyde.     

Quantum chemical calculations of the isomer shift in iron(II) complexes of 1,2,4-triazoles with a 1 A 1 ⇔ 5 T 2 spin transition

DFT calculations have been performed to determine the isomer shift for a series of iron(II) clusters with nitrogen-containing ligands which serve as models of coordination units in Fe(II) complexes with 1,2,4-triazoles possessing a ¹ A ₁ ? ⁵ T ₂ spin transition. Good agreement has been found between the theoretical and experimental values of the isomer shift for both low-and high-spin phases. Our calculations confirmed the hypothesis about relationship between the experimentally observed differences in the isomer shift for the low-spin phases of the complexes and variations of the Fe-N mean bond length.