Proton conductivity of phosphoric acid derivative of fullerene

The proton conductive property of methano [60] fullerene diphosphoric acid has been investigated under various humidity conditions at the temperature range between 15 and 45 °C. It shows proton conductivity as high as 10⁻² S cm⁻¹ at 25 °C under relative humidity of 95%. Thermal analyses including TG–DTA and thermal desorption mass spectroscopy (TDS) confirm that the compound is thermally stable up to 200 °C. Proton conduction of the compound depends very much on humidity or water content. The logarithmic conductivity at 25 °C is increased linearly with increasing relative humidity. The activation energy (E_a) estimated from the slope of log(σT) vs. 1/T is decreased from 1.08 to 0.52 eV, as the relative humidity is increased from 40% to 75%. The humidity dependence of conductivity is discussed in the light of the observed hydration isotherm.     

光电转换体系太阳能聚集器

In standard P-V systems, the high cost and low quantum efficiency of silicon cells has held back widespread adoption of this technology for decades. To generate electrical power from solar energy in a cost effective way, most methods require the concentration of the sunlight in order to increase the efficiency of energy conversion. Most systems use parabolic mirrors to focus sunlight to either a line （trough systems） or a small volume （dishes）. One of the reasons solar power still remains little utilised, is the high cost of the collection systems. Light focussing devices using reflection usually take the form of a curved rein＇or. In contrast, this paper describes the new design of a device consisting of an array of small angled reflecting m/trot facets located in a planar form. The three dimensional angle of each facet in the array is a function of its position in the array, and is calculated to be such that for a parallel beam striking the array, each facet will reflect the light in such a way as to form a focal point region.     

Formation and hydrogenation of p(2 × 2)-N on Pt(1 1 1)

The formation of a well-ordered p(2 × 2) overlayer of atomic nitrogen on the Pt(1 1 1) surface and its reaction with hydrogen were characterized with reflection absorption infrared spectroscopy (RAIRS), temperature programmed desorption (TPD), low energy electron diffraction (LEED), Auger electron spectroscopy (AES), and X-ray photoelectron spectroscopy (XPS). The p(2 × 2)-N overlayer is formed by exposure of ammonia to a surface at 85 K that is covered with 0.44 monolayer (ML) of molecular oxygen and then heating to 400 K. The reaction between ammonia and oxygen produces water, which desorbs below 400 K. The only desorption product observed above 400 K is molecular nitrogen, which has a peak desorption temperature of 453 K. The absence of oxygen after the 400 K anneal is confirmed with AES. Although atomic nitrogen can also be produced on the surface through the reaction of ammonia with an atomic, rather than molecular, oxygen overlayer at a saturation coverage of 0.25 ML, the yield of surface nitrogen is significantly less, as indicated by the N₂ TPD peak area. Atomic nitrogen readily reacts with hydrogen to produce the NH species, which is characterized with RAIRS by an intense and narrow (FWHM ∼ 4 cm⁻¹) peak at 3322 cm⁻¹. The areas of the H₂ TPD peak associated with NH dissociation and the XPS N 1s peak associated with the NH species indicate that not all of the surface N atoms can be converted to NH by the methods used here.     

基于液晶光阀的全息照相控光仪

设计了通过液晶光阀自动调整全息照相物光和参考光辐照比至最佳状态,同时能实现曝光时间自动控制的控光仪.该仪器巧妙运用液晶光阀和硅光电池器件,使测量、调整、自控一体化,从而提高拍摄优质全息图的工作效率.     

差分吸收光谱法测量大气污染的测量误差分析

差分吸收光谱技术被广泛地应用于测量大气中微量元素的浓度，尽管该技术利用最小二乘法来反演待测气体的浓度，能够得到很高的测量精度。但是，由于仪器本身的噪声以及测量波段其它气体的干扰等，使得仪器的测量有一定的误差，而且上述因素还决定着仪器的测量下限。对差分吸收光谱方法的测量误差以及引起误差的原因作了详细的分析。     

离子交换富集-导数火焰原子吸收法测定自来水中Cu,Fe和Zn

本文研究了用 2 0 1× 7阳离子交换树脂对自来水中的微量元素进行交换富集 ,采用微量脉冲进样 导数火焰原子吸收法测定富集后溶液中的Cu ,Fe和Zn ,该方法灵敏度分别为 0 2 9,0 5 9和 0 0 6 μg·L- 1 ,精密度分别为 4 2 8% ,1 95 %和 2 2 8% ,检测限分别为 1 2 8,5 85和 0 6 8μg·L- 1 ,回收率分别为 91 13% ,10 1 34%和99 84 % ,本方法大大减少了需样量 ,简便快速 ,灵敏度高。     

U：CaF2晶体的分凝特性与光谱性质

应用TGT法生长了直径为75mm的U：CaF2晶体，宏观上透明完整.应用公式K0=Cs/Cl计算了U在CaF2晶体中的分凝系数等于0.53.应用溶质分布一般公式Cs=K0C0(1-g)K0-1，计算U的浓度分布与测量值，数值符合说明晶体生长过程接近平衡状态.分析不同条件下生长的U: CaF2晶体的晶胞参数和吸收光谱，结果表明生长气氛决定U的价态及电荷补偿机理：无PbF2存在的条件下，U为+4价，晶体呈绿色；PbF2的加入起到氟化去氧作用，U倾向于以离子半径最接近于Ca2+的U3+存在，晶体呈红色.从晶体生长开始到结束的部位，U3+:CaF2晶体吸收光谱的峰位不变，峰强呈现与U浓度相同的增加趋势.U3+:CaF2晶体外层厚约5mm处呈黄色，含有U3+和U2+的混合价态离子，其原理是石墨坩埚的还原作用通过单质铅，使部分的U3+进一步还原成了U2+. 关键词： 铀 氟化钙晶体 分凝系数 晶胞参数     

差分吸收光谱法测量大气痕量气体浓度误差分析及改善方法

差分吸收光谱技术(DOAS)中采用线性最小二乘拟合方法,用痕量气体标准差分吸收截面对测量得到的差分吸收光谱进行拟合,得出大气中痕量气体的浓度.计算结果的准确性不仅取决于光谱的测量精度,而且受标准差分吸收截面以及仪器函数和温度等诸多因素的影响.详细地分析了计算误差的产生原因,提出了用高浓度样品池得到标准吸收截面的方法,针对光谱固有结构,以及温度对标准吸收截面的影响,改进了浓度反演算法.大量的实验表明,综合运用上述方法,即便对低浓度的样气,相对测量误差也能降低到10%以下.     

一种微穿孔板消声器

本文根据马大猷教授提出的“微穿孔板吸声体精确理论”，在对微穿孔板消声器结构参数与吸声特性之间的相互影响进行了分析的基础上，设计了微穿孔板消声器并将其应用在新舟60飞机APU(辅助动力装置)降噪的实际工程中，并通过编写的噪音数据采集分析程序，对降噪效果进行了测试和分析，验证出微穿孔板消声器对消除飞机的APU的排气噪声具有良好的消声效果，平均降噪7．16dB。