Amphiphilic biodegradable poly(CL-b-PEG-b-CL) triblock copolymers prepared by novel rare earth complex: Synthesis and crystallization properties

Amphiphilic biodegradable poly(CL-b-PEG-b-CL) triblock copolymers have been successfully prepared by the ring-opening polymerization of ε-caprolactone (CL) employing yttrium tris(2,6-di-tert-butyl-4-methylphenolate) [Y(DBMP)₃] as catalyst and double-hydroxyl capped PEGs (DHPEG) as macro-initiator. The triblock architecture, molecular weight, thermal and crystallization properties of the copolymers were characterized by NMR spectra, SEC, DSC and WAXD analyses. The isothermal crystallization behavior of the copolymers was investigated by POM analysis in detail, which is greatly influenced by the length of PCL and PEG blocks. On the POM micrograph of PEG_10,000-(PCL₈₆₀₀)₂, a unique morphology of concentric spherulites was observed due to the sequent crystallization of the PCL and PEG blocks.     

Crystallization and melting behaviors of polystyrene-b-poly(ethylene-co-butene) block copolymers

Non-isothermal and isothermal crystallization behaviors of polystyrene-b-poly(ethylene-co-butene) (PSt-b-PEB) block copolymers with different compositions and chain lengths were investigated by differential scanning calorimetry (DSC). The results show that crystallization of PEB block is strongly dependent on the composition. Crystallization temperature (T_c), melting temperature (T_m) and fusion enthalpy (ΔH_f) increase rapidly with PEB volume fraction (V_E) for block copolymers with V_E below 50%, but there is little change when PEB block becomes the major component. Glass transition temperature (T_g) of the PSt block and order-disorder transition temperature (T_ODT) of block copolymers also have a weak effect. The isothermal crystallization kinetics results show that Avrami exponent (n) was strongly dependent on the composition and crystallization temperature. For the block copolymers with V_E below 38.7 vol%, the values of n vary between 0.9 and 1.3, indicating that crystallization is confined. For the PSt-b-PEB block copolymers with V_E higher than 50%, fractionated crystallization behavior is usually observed. A two-step isothermal crystallization procedure is applied to these block copolymers. It is found that breakout crystallization occurs at higher T_c, but confined at lower T_c. Two overlapped melting peaks are observed for the block copolymers with fractionated crystallization behavior after two-step crystallization, and only the higher melting peak corresponding to breakout crystallization can be used to derive equilibrium melting temperature.     

不同嵌段比的PEG-b-PDMAEMA共聚物在水溶液中的自聚集行为

采用氢核磁共振(¹H-NMR)、动态光散射(DLS)及透射电子显微镜(TEM)对聚乙二醇-嵌段-聚甲基丙烯酸N,N-二甲氨基乙酯(PEG-b-PDMAEMA)三种具有不同PEG/PDMAEMA嵌段比的PEG-b-PDMAEMA共聚物在水溶液中的自聚集行为进行了研究. 研究表明, 两嵌段比例是影响聚合物胶束化过程的关键因素: 只有当其中聚乙二醇含量较低(质量分数低于33%)时, 聚合物才具有其pH/温度敏感胶束化特性. 此外, 共聚物溶液随温度胶束化过程与共聚物嵌段比大小密切相关. PEG-b-PDMAEMA这种不同于传统双亲性嵌段共聚物(DHBCs)在选择性溶剂中独特的胶束化行为, 是由聚合物溶液体系中各种基团之间的氢键作用决定的.     

Surface patterns of block copolymers in thin layers after vapor treatment

A systematic study of formation of surface patterns in block copolymer thin layers after their exposure to solvent vapors was performed. The studied effect involves layers of thickness approximately equal to the ordering size of polymers - about 45 nm. Experiments were performed on three styrene - methacrylate derivative block copolymers, synthesized by living anionic polymerization: poly(4-octylstyrene)-block-poly(butyl methacrylate), poly(4-fluorostyrene)-block-poly(butyl methacrylate) and poly(p-octylstyrene)-block-poly(methyl methacrylate). The polymers were exposed to vapors of chloroform, 1,4-dioxane, hexane, acetone and tetrahydrofuran.     

Synthesis and properties of amphiphilic vinyl acetate triblock copolymers prepared by copper mediated living radical polymerisation

Polymerisation of vinyl acetate by conventional free radical polymerisation using a diazo initiator followed by copper mediated living radical polymerisation with a range of monomers was studied. This method led to the synthesis of triblock copolymers. We have thus successfully prepared several new ABA triblock copolymers where B is poly(vinyl acetate) and A is (dimethylamino)ethyl methacrylate (DMAEMA), (polyethylene glycol) methyl ether methacrylate (MeO(PEG)MA) or solketal methacrylate (SMA). The sequential conventional/living radical polymerisation approach provided an efficient route to synthesis of new block copolymers. The properties of these amphiphilic polymers have been subsequently investigated by ¹H NMR, fluorescence spectroscopy, tensiometry and dynamic light scattering to investigate their behaviour as potential surfactants.     

Synthesis and crystallization behaviors of poly(styrene-b-isoprene-b-ε-caprolactone) triblock copolymers

The triblock copolymers, poly(styrene-b-isoprene-b-ε-caprolactone)s (PS-b-PI-b-PCL) have been synthesized successfully by combination of anionic polymerization and ring-opening polymerization. Diblock copolymer capped with hydroxyl group, PS-b-PI-OH was synthesized by sequential anionic polymerization of styrene and isoprene and following end-capping reaction of EO, and then it was used as macro initiator in the ring-opening polymerization of CL. The results of DSC and WAXD show big effect of amorphous PS-b-PI on the thermal behaviors of PCL block in the triblock copolymers and the lower degree of crystalline in the triblock copolymer with higher molecular weight of PS-b-PI was observed. The real-time observation on the polarized optical microscopy shows the spherulite growth rates of PCL₂₇, PCL₃₂₈ and PS-b-PI-b-PCL₃₄₄ are 0.71, 0.46 and 0.07 μm s⁻¹, respectively. The atomic force microscopy (AFM) images of the PS₉₀-b-PI₆₆-b-PCL₂₈ show the columns morphology formed by it’s self-assembling.     

苯乙烯-丁二烯-苯乙烯/聚乙烯基甲基醚共混体系相容性的FT-IR及DSC研究

嵌段高聚物、均聚物共混体系相容性是近年来研究的热点。本工作以光学显微镜、DSC、FT-IR为手段,研究了三嵌段高聚物苯乙烯-丁二烯-苯乙烯(SBS);SBS-48、SBS-30,SBS-28与聚乙烯基甲基醚共混体系的相容性。DSC结果表明,随SBS中PS含量的升高,体系相容性变好,PS段分子量增大,也有助于体系相容。FT-IR结果表明PVME中COCH_3在1100cm~(-1)附近呈现的双峰的相对强度对体系的相容性十分敏感,而由于苯环C—H振动产生的698cm~(-1)峰位却不象PS/PVME体系那样随相容性的改变而有显著的改变。总而言之,嵌段高聚物SBS/均聚物PVME共混体系中,体系的相容性依赖于嵌段高聚物在体系中的组份含量及嵌段高聚物中PS的重量百分含量,PS段分子量的大小对体系相容性也有影响。     

Small-angle neutron scattering study on microstructure of poly(N-isopropylacrylamide)-block-poly(ethylene glycol) in water

By employing small-angle neutron scattering (SANS), we investigated the microstructures of, poly(N-isopropylacrylamide) (PNIPA)-block-poly(ethylene glycol) (PEG) (NE) in deuterated water D₂O, as related to macroscopic behaviors of fluidity, turbidity and synerisis. SANS revealed following results: (i) microphase separation occurs at around above 17 °C in a temperature range of transparent sol below 30 °C. In the microdomain appeared in the transparent sol state, both block chains of PNIPA and PEG are swollen by water; (ii) for the NE solution of polymer concentration W_p > 3.5% (w/v), corresponding to opaque gel above 30 °C, a percolated structure, i.e., network-like domain is formed by NE as a result of macrophase separation due to dehydration of the PNIPA chains. As the temperature increases toward 40 °C, the network domain is squeezed along a direction parallel to the NE interface, which leads to increase of the interfacial thickness given by swollen PEG chains and to the macroscopic synerisis behavior.     

Surface structure of thin asymmetric PS-b-PMMA diblock copolymers investigated by atomic force microscopy

Asymmetric poly(styrene-b-methyl methacrylate) (PS-b-PMMA) diblock copolymers of molecular weight M_n = 29,700 g mol⁻¹ (M_PS = 9300 g mol⁻¹M_PMMA = 20,100 g mol⁻¹, PD = 1.15, χ_PS = 0.323, χ_PMMA = 0.677) and M_n = 63,900 g mol⁻¹ (M_PS = 50,500 g mol⁻¹, M_PMMA = 13,400 g mol⁻¹, PD = 1.18, χ_PS = 0.790, χ_PMMA = 0.210) were prepared via reversible addition-fragmentation chain transfer (RAFT) polymerization. Atomic force microscopy (AFM) was used to investigate the surface structure of thin films, prepared by spin-coating the diblock copolymers on a silicon substrate. We show that the nanostructure of the diblock copolymer depends on the molecular weight and volume fraction of the diblock copolymers. We observed a perpendicular lamellar structure for the high molar mass sample and a hexagonal-packed cylindrical patterning for the lower molar mass one. Small-angle X-ray scattering investigation of these samples without annealing did not reveal any ordered structure. Annealing of PS-b-PMMA samples at 160 °C for 24 h led to a change in surface structure.     

Concentrated reverse micelles in a random graft block copolymer system: structure and in-situ synthesis of silver nanoparticles

The structure and rheological properties of a poly(dimethylsiloxane)-graft-poly(oxyethylene) copolymer at high concentrations in block-selective solvents were studied by small-angle X-ray scattering (SAXS) and rheometry. Analysis of SAXS data indicates that quasispherical, reverse micellar aggregates (with no ordered packing) are present in concentrated solutions of the copolymer in nonpolar solvents, and that upon addition of water, the size of such aggregates increases due to the solubilization inside the micellar cores. The viscosity of concentrated polymer solutions increases exponentially as water is added, and finally, viscoelastic, gel-like behavior is found in the vicinity of the phase separation limit. It was found that small silver nanoparticles with an average diameter of ≈3 nm can be synthesized inside the copolymer aggregates without the need of a reducing agent; namely, particles embedded in a viscoelastic matrix are obtained. The synthesis seems to follow first-order kinetics. Electronic supplementary material Supplementary material is available in the online version of this article at and is accessible for authorized users.