Drying agents for water-free introduction of desorption solvent into a GC after on-line SPE of aqueous samples

Summary A small cartridge containing a drying agent is inserted between a solid phase extraction (SPE) column and a gas chromatograph (GC) to enable the introduction of water-free desorption solvent into the GC in on-line liquid chromatography (LC)-type enrichment of trace-level analytes from water samples. Some characteristics of the drying agents, such as their capacity to retain water and their re-usability after heating, have been tested. Possible interactions of the drying agent with the analytes, e.g., irreversible adsorption or catalyzed degradation, have been checked for a wide range of alkanes, alkylbenzenes chlorobenzenes, chlorophenols and phthalate esters. Using the on-line SPE-GC system with flame ionization detection (FID) and spiked samples containing different levels of the test compounds, the repeatability was shown to be satisfactory (6–17%). For 10 mL samples, the detection limits were lower than 0.1 g/L. The on-line SPE-GC-FID system here presented can be used for the repeated analysis of water samples without exchange of the dyring cartridge. The technique is applied to the analysis of tap water.     

Analysis of primary aliphatic short-chain monoamines by LC in water samples

Several derivatization procedures with o-phthaldialdehyde-N-acetylcysteine (OPA-NAC) were compared for a rapid analysis of primary aliphatic short-chain monoamines in water samples by HPLC using a LiChorospher analytical separation column (100RP₁₈ mm i.d., 5 μm). Both the solution and the solid-support assisted off-line derivatization on C₁₈ SPE cartridges were inadequate options because of beginning degradation processes of the instable isoindol derivatives during their transfer to the analytical column. This problem was precluded with the on-column or solid-support assisted on-line derivatization. In the last mentioned procedure, the derivatization took place in a Hypersil C₁₈ precolumn ( mm i.d., 30 μm) connected with an additional preconcentration step resulting in better detection limits (0.002-0.040 μg ml⁻¹ requiring only 150 μl of water sample) than in the on-column procedure (0.08-0.16 μg ml⁻¹). The improved sample handling, the better control of parameters affecting reaction rates, the fully automation of this method with only 10 min analysis time for each sample are further advantageous. The potential of the solid-support assisted on-line derivatization was outlined and applied to water samples from several sources. Recovery values near 100% were obtained.     

Acetylation and molecular mass effects on barrier and mechanical properties of shortfin squid chitosan membranes

Chitosan samples with different N-deacetylation levels were obtained from β-chitin under heterogeneous alkali conditions. Oxidative depolymerisation was performed to attain low-acetylated chitosan samples with different molecular mass. Water vapour permeability, membrane swelling and tensile mechanical properties were analysed in plasticized self-supporting chitosan membranes. The main purpose was to describe unambigously the effect of the biopolymer molecular mass and acetylation degree on these properties. Commercially available chitosan samples derived from α-chitin were also studied for comparison. The equilibrium degree of swelling in water and the water vapour permeability increase by increasing the molecular mass or the degree of acetylation. Regarding the effect on the mechanical properties, generally harder and tougher membranes were obtained for chitosans with higher molecular mass or lower acetylation degree. These observations are tentatively explained based on the different structural characteristics of the polymer and can lead to a better understanding of the tools necessary to tailor a specific type of chitosan membrane.     

Structure formation and dynamics of water in strong external electric fields

We have performed molecular dynamics computer simulations of water in homogeneous external electric fields which were varied in a wide range of field strengths. The dielectric response is found to be linear up to fields E₀≈0.01 V/Å from where dielectric saturation effects become important. At fields of E₀≈3 V/Å a phase transition into an ordered, ice-like structure is observed, which is stabilized through hydrogen-bonds. With an increasing external electric field, the frequency spectrum of the water dynamics shows a remarkable red shift of the intramolecular modes and a blue shift of the librational motions, where the frequency varies quadratically with the field strength. A simple analytical model is discussed which reproduces the observed behavior.     

Simultaneous determination of sulfite, sulfate, and hydroxymethanesulfonate in atmospheric waters by ion-pair HPLC technique

A reversed-phase ion-pair HPLC with indirect photometric detection for the simultaneous determination of sulfite, sulfate, hydroxymethanesulfonate (HMS), and other inorganic anions in atmospheric water has been developed. Separations were accomplished in less than 10 min in a cetylpyridinium-coated C₁₈ column with 0.5 mM potassium hydrogen phthalate-0.015% triethanolamine-3% methanol at pH 7.9 as mobile phase. Quantitation was carried out by the peak area method, with detection limits in the pmol range. UV light absorption responses were linear over a wide concentration range from several hundred μmoles to the detection limits of each anion. The application of the method provides a rapid and efficient technique for the quantitative determination of sulfur and other inorganic species in atmospheric liquids.     

Direct Barbier-type allylation of aromatic acetals and dioxolanes in the presence of β-cyclodextrin in water

A new and convenient procedure for the synthesis of homoallylic alcohols directly from aromatic acetals and dioxolanes has been developed with very good yields under biomimetic conditions using a Zn-mediated Barbier-type allylation in the presence of β-cyclodextrin in water.     

Solid-phase extraction-liquid chromatography-fluorimetry for organotin speciation in natural waters

Summary A method is reported for the determination of dibutyltin (DBT), diphenyltin (DPhT), tributyltin (TBT), and triphenyltin (TPhT) species at the nanogram per litre concentration level in natural water samples. Analytes were isolated from samples by solid-phase extraction and analysed both off-line and on-line by reversed-phase high-performance liquid chromatography with post-column derivatization and fluorimetric detection. Several SPE cartridges and eluents were evaluated; C₁₈ enrichment and elution with a mixture of methanol, acetic acid, and water was found most suitable. Preconcentration factors up to 250 can be achieved when a 500-mL sample is processed. Detection limits, recovery rates, and the precision of the whole process have been determined. The method has been applied to the determination of organotin species in spiked natural water samples collected on the NW Mediterranean coast. Recovery rates range from 75 to 110% and detection limits are at the low ng L⁻¹ level (1–3 ng Sn L⁻¹ for DPhT, DBT, and PhT and 40 ng Sn L⁻¹ for TBT when 250 mL spiked sea water is processed.)     

Cu/TiO2-NiO上光促表面催化CO2和H2O合成CH3OH反应规律

采用溶胶-凝胶法制备了n(电子型)-p(空穴型) 复合半导体材料0.5％Cu/TiO2-2.0％NiO (w),利用X射线衍射(XRD)、透射电镜(TEM)、红外光谱(IR)、紫外-可见光漫反射(UV-Vis)、程序升温脱附(TPD)技术对材料结构、吸光性能、化学吸附性能进行了表征,研究了该材料对CO2和H2O合成CH3OH的光促表面催化反应(PSSR)规律.结果表明,所制备材料能够明显促进目的反应,室温条件下即有CH3OH生成.在200 ℃下,由于光-表面-热的协同效应,CO2转化率得以提高,且CH3OH的选择性达到87.5％ .根据实验结果,得出CO2在材料表面的卧式吸附态为CH3OH的前驱物,并对PSSR机理进行了讨论.     

Aqueous solutions—A new perspective. Amorphous carbohydrates: Science and application technology

At a recent meeting of the International Symposium on Solution Chemistry I presented a paper dealing with aqueous solutions in which water was present not in excess but as one component of a supersaturated solution with polyhydroxy compounds. In response to a request from the Editor of this Journal I have submitted this article in which I outline my general interest in the subject and its importance as a new direction for solution chemists.     

Adsorption of water molecules in slit pores

We report molecular dynamics (MD) simulations on the adsorption of water in attractive and repulsive slit pores, where the slit and a bulk region are in contact with each other. Water structure, surface force and adsorption behavior are investigated as a function of the overall density in the bulk region. The gas–liquid transition in both types of pores occurs at similar densities of the bulk region.