Dependence of Performance of Organic Light-emitting Devices on Sheet Resistance of Indium-tin-oxide Anodes

IntroductionIndium-tin-oxide(ITO) has been widely used asthe anode material in organic light-emitting devices(OLEDs) because of its high transmittance in the visi-ble region and low electrical resistivity. In the pastyears, many investigations focused on …     

溶胶-凝胶法制备高取向Bi4Ti3O12/SrTiO3(100)薄膜

Bi4Ti3O12具有良好的铁电、电光等性能山、特别是Bi4Ti3O12薄膜很适合作永久性存储材料，也可用于电光器件问．在微电子学、光电子学、集成光学、集成铁电学等领域均有广泛开发和应用前景，国外已用溅射法、激光沉积法制备出c轴取向Bi。Ti3Ol。薄膜【’，＼山东大学用MOCVD法制     

Preparation and Characterization of Nano-ZnFe2O4/TiO2 Films

The nano-ZnFe2O4/TiO2 films possess the functions of desulfurization and degradation for organic pollutants. The sols of ZnFe2O4/TiO2 were prepared by sol-gel method and coated on glass and porous ceramic by vertical coating and dipping-lift processes, respectively, and the samples were obtained after drying and sintering. The composition, appearance, absorption spectrum of the films, and the influence of the film on porous ceramic performances were analyzed using SEM, AFM, UV-Vis spectrometer, and mercury porosimeter, respectively, to determine the operation parameters of the multifunction porous ceramic elements for gas-purification.     

有序自组装聚合物纳米结构

采用水辅助方法(water-assisted fabrication method),分别以4-十二烷基苯磺酸掺杂的聚苯胺(PANI-DBSA)和聚2-甲氧基-5-(2′-乙烯基-己氧基)苯乙炔(MEH-PPV)两种功能高聚物为成膜材料,冷凝水滴为模板,利用水滴在聚合物溶液表面的自组装,制备出了两种纳米层次以上的蜂窝状有序多孔聚合物薄膜.通过原子力显微镜和共聚焦荧光显微镜对其形貌、电学性质和荧光图像进行了表征.     

p—Si上电沉积Ni—W—P薄膜的结构与热稳定性

研究了ｐ－Ｓｉ上恒电流沉积Ｎｉ－Ｗ－Ｐ合金薄膜组成与结构的关系，讨论了镀层的组成、结构随沉积时间的变化．测定了非晶合金的晶体结构随热处理温度的改变以及ＤＴＡ曲线，结果表明，非晶Ｎｉ－Ｗ－Ｐ合金在晶化过程中形成两个纳米超微晶相，非晶Ｎｉ－Ｗ－Ｐ薄膜的热稳定性远高于通常使用的非晶Ｎｉ－Ｐ薄膜．     

Chemical Liquid Phase Deposition of Thin Aluminum Oxide Films

Introduction Inorganic oxide films have attracted a lot of interest in the last several decades. Among them, silicon dioxide films are widely used in modern microelectronics, optics and mechanics. This material has been grown by various methods including thermal oxidation, chemical vapor phase deposition, plasma-enhanced chemical vapor phase deposition, and so on.1,2 Recently, Nagayama et al.3 have reported that SiO2 thin films could be produced by a new chemical method of liquid phase depos…     

(ClAlNH)n簇合物的结构与稳定性

用量子化学从头算方法（HF／6－31G）和密度泛函理论（DFT）的B3LYP方法，以6－31G标准基组加一个极化函数，对（ClAlNH)n(n=1-10)簇合物的几何构型，电子结构和红外光谱进行了优化，并讨论了聚合反应（ClAlNH)m→(ClAlNH)n的热力学效应，结果表明，（ClAlNH)n系列簇合物的基态稳定结构为Cs(n=1),D2h(n=2),D3h(n=3),Td(n=4),Cs(n=5),D3d(n=6),Cs(n=7),S4(n=8),D3h(n=9),C2h(n=10,n=2,4,6,8,10等偶数对应的（ClAlNH)n簇化合物的结构比n等于奇数量更稳定。     

聚4-重氮基苯乙烯与聚苯乙烯磺酸钠的自组装

1991年Ｄｅｃｈｅｒ等将带相反电荷的聚电解质 ,于水溶液中交替沉积在片基上 ,制备了多层超薄膜[1] ,这种制膜方法现称为静电自组装 .它操作简单 ,无需专用设备 ;一般在水体系进行 ,对环境友好 ;静电力比范德华力强 ,使它比ＬＢ膜稳定 ,所以近年来有很大发展[2 ] .现在自组装成膜驱动力已从静电力扩展到氢键力、电荷转移相互作用、疏水相互作用等 ,用于组装的组分也从聚电解质扩展到多官能团小分子、胶体粒子、无机纳米颗粒 ,ＤＮＡ、蛋白质等生物大分子等[3～ 11] .虽然自组装膜比ＬＢ膜稳定 ,但它也不耐极性溶剂、电解质水溶液等侵蚀 .如…     

薄膜荧光传感器研究进展

按薄膜荧光传感器的制备方法, 从物理薄膜、化学薄膜和自组装单层膜等三个方面综述了近年来薄膜荧光传感器的研究进展. 在此基础上, 展望了薄膜荧光传感器的研究前景.     

聚乙撑二氧噻吩膜在氧化态的充电过程及电容研究

In this paper, the chronoamperometry was used to study the charging processes of polyethylenedioxythiophene (PEDOT) modified electrodes in the potential range where PEDOT was in the oxidized state. The results show that the charging behaviors of the PEDOT films are well agreed with the exhausted finite diffusion model. The dependence of the capacitance values of the films on potential and concentration of solution was also studied in this potential range.