纳米结构TiO2／SiO2的逐层自组装

采用逐层自组装方法在二氧化硅球表面交替组装了十二烷基硫酸钠单分子膜和 二氧化钛纳米粒子膜，该复合多层膜经高温假烧后得到了核壳型纳米结构二氧化钛 ／二氧化硅复合颗粒．利用XRD，SEM，X射线能谱等对复合颗粒进行了表征．结果 表明：二氧化肽在复合颗粒表面排列紧密、均匀，粒径在50nm左右，为锐钛矿型结 构．复合颗粒中二氧化肽的含量随组装层数的增加而均匀增加．     

纳米TiO_2膜修饰电极异相电催化还原马来酸

通过电化学合成前驱体和溶胶-凝胶法在Ti表面修饰一层纳米TiO_2膜，SEM， XRD测试表明晶型为锐钛矿型，晶粒平均尺寸为25 nm。采用循环伏安法、循环方波 伏安法和电解合成法研究了纳米TiO_2膜电极在硫酸介质中的氧化还原行为以及对 马来酸（maleic acid）还原的电催化活性。结果表明，纳米TiO_2膜电极在阴极扫 描时有两对可逆氧化还原峰，可逆半波电位E_(1/2)~r分别为-0.53 V和-0.92 V（ sv. SCE，扫描速度0.05 V·s~(-1)），对应于TiO_2/Ti_2O_3和TiO_2/Ti(OH)_3两 个氧化还原电对的可逆电极过程。其中TiO_2/Ti_2O_3电对对马来酸具有异相电催 化还原活性，纳米TiO_2膜中的Ti~(IV)/Ti~(III)氧化还原电对作为媒质间接电还 原马来酸为丁二酸（butane diacid），反应机理为电化学偶联随后化学催化反应 （EC'）机理。     

水热处理氢氧化镁微晶性质研究

Shape apprearance and crystallite characterization of magnesium hydroxide at different hydrothermal tempera-tures have been investigated by SEM， XRD and DSC methods. The grain size， cell parameter and lattice distortion rate of powders under each condition were obtained. The results show that the grains had grown up， especially along the (001) surface as the hydrothermal temperature was raised， accompanying the shrinkage of lattice and the de-scending of distortion rate. These could be relate to the re-crystallization of Mg(OH)₂， as well as the thermal dif-fusion of OH^- with lower charges， resulting in good dispersion， high thermal decomposition temperature and en-thalpy of Mg(OH)₂. Moreover， it is helpful for the increase of the retardant behavior of Mg(OH)₂.     

颜料体积浓度对水在醇酸涂层中传输行为的影响

水、离子和氧气是导致涂层下金属发生腐蚀的三个重要因素,它们在涂层中的传输过程对其下面金属的腐蚀会产生较大的影响,研究它们在涂层中的传输过程对于弄清涂层下金属发生腐蚀的机制至关重要 .研究表明 [1－ 8], 水在涂层中的传输是一个扩散过程,分起始和饱和两个阶段;在起始阶段,随研究体系和实验条件的不同,水在涂层中的扩散过程遵循不同的规律,可能满足菲克第二扩散定律,也可能会发生较大的偏差 .　　颜料与基料界面间的孔隙是水在涂层中传输的主要通道,调整颜料体积浓度（ PVC）可以改变涂层中这种孔隙的数量和分布,从而…     

Thermal and spectroscopic analysis of florfenicol irradiated in the solid-state

The study has been undertaken to check the effect of ionising radiation on the physical and chemical properties of florfenicol, an antibiotic of a wide range of antibacterial activity. The solid-state samples were subjected to an electron beam generated by accelerator corresponding to the doses of 25, 100 and 400 kGy, and the effect of the exposure was analysed by the methods not requiring changes in the state (with no preliminary treatment), such as SEM, DSC, FTIR, XRD, EPR and HPLC. Florfenicol irradiated with a dose of 25 kGy has not changed the form or colour, however, a small increase in intensity of some absorption bands in the FTIR spectrum and of some peaks in the XRD pattern, a decrease in the melting point by 0.6°C, the appearance of free radicals and a loss in the FF content within the error of the method (0.91%) have been observed. After irradiation with greater doses (100 and 400 kGy) the changes have intensified, yellow discolouration appeared and the loss of FF content has increased to 6.39%. As follows from the results, the compound studied in solid-state undergoes radiolysis after e-beam irradiation in the doses ≥25 kGy, but lower doses (15–20 kGy) can be applied for its decontamination or sterilization with no adverse effect on its physico-chemical properties.     

Circular patterns of calcium oxalate crystals induced by defective Langmuir-Blodgett film

The injury of the renal epithelial cell membrane can promote the nucleation of nascent crystals, as well as adhesion of crystals on it. It thus accelerates the formation of renal calculi. In this paper, the defective Langmuir-Blodgett (LB) films were used as a model system to simulate the injured renal epithelial cell membrane. The microcosmic structure of the defective LB film and the molecular mechanism of the effect of this film on nucleation, growth, deposited patterns and adhesion of calcium oxalate monohydrate (COM) were investigated. The circular defective domains were formed in dipalmitoylphosphatidylcholine (DPPC) LB film after the film was treated by potassium oxalate. These domains could induce ring-shaped patterns of COM crystals. In comparison, the LB film without pretreatment by potassium oxalate only induced random growth of hexagonal COM crystals. As the crystallization time increased, the size of COM crystals in the patterns increased, the crystal patterns changed from empty circles to solid circles, and the number of the circular patterns with small size (5-20 μm) increased. The results would shed light on the molecular mechanism of urolithiasis induced by injury of the renal epithelial membrane at the molecular and supramolecular level.     

利用扫描电镜分析砍创性骨外伤的研究

在大型显微镜下,对锐器（单刃刀）和钝器（短柄斧）形成的骨外伤的微观形态进行了分析研究．结果表明：通过特征识别骨外伤的砍切痕迹,往往误差较大,某些肉眼看不见的三维特征通过微观分析可以清晰地识别．着重强调扫描电镜（SEM）在骨外伤鉴定中,具有重要的使用价值．     

Fatigue damage behavior of a surface-mount electronic package under different cyclic applied loads

This paper studies and compares the effects of pull-pull and 3-point bending cyclic loadings on the mechanical fa- tigue damage behaviors of a solder joint in a surface-mount electronic package. The comparisons are based on experimental investigations using scanning electron microscopy （SEM） in-situ technology and nonlinear finite element modeling, respec- tively. The compared results indicate that there are different threshold levels of plastic strain for the initial damage of solder joints under two cyclic applied loads; meanwhile, fatigue crack initiation occurs at different locations, and the accumulation of equivalent plastic strain determines the trend and direction of fatigue crack propagation. In addition, simulation results of the fatigue damage process of solder joints considering a constitutive model of damage initiation criteria for ductile materials and damage evolution based on accumulating inelastic hysteresis energy are identical to the experimental results. The actual fatigue life of the solder joint is almost the same and demonstrates that the FE modeling used in this study can provide an accurate prediction of solder joint fatigue failure.     

裂解温度对CVD法制备多壁碳纳米管的影响

用SEM、TEM、HRTEM及拉曼光谱方法研究了催化裂解乙炔制备多壁碳纳米管过程中裂解温度的影响,结果表明,在650℃～700℃裂解乙炔,可获得产量高、直径分布均匀、石墨程度高的多壁碳纳米管,并对裂解温度影响机制进行了分析和探讨。