多钼酸盐–柠檬酸复合膜的多色光致变色

制备了多钼酸盐–柠檬酸光致变色复合膜，紫外光照后发现不同摩尔比的复合膜呈现不同的颜色。当摩尔比为1.0，0.3和0.2时，变色后的薄膜分别显深蓝色，深黄褐色和淡海绿色。通过对薄膜的拉曼光谱分析证实呈现不同的颜色是由于在变色后的膜中生成了不同的物种。柠檬酸在光致变色过程中起着重要的作用, 在紫外光的照射下它作为空穴的捕获剂, 抑制了光生电子和空穴的复合, 使多钼酸盐呈现紫外光致变色现象。     

非弹性体增韧—聚合物增韧的新途径

本文是一篇关于非弹性增韧方法的综述。文章首先简要回顾了传统的橡胶增韧韧性聚合物材料的机理,然后着重介绍了最近在国外出现的刚性有机填料(ROF)增韧的基本概念、分析方法和增韧的冷拉机理,列举了脆性塑料粒子和韧性基体组成的合金体系的大量实验结果来说明以上内容,最后通过与传统橡胶增韧机理的对比指出非弹性体增韧是不同于后者的一种新增韧方法,并有可能成为制备高强度、高韧性工程塑料的一种新途径。     

LaB6-ZrB2共晶复合材料的组织特征及控制

用电弧炉和电子束悬浮区熔炉法制备了ＬａＢ６ＺｒＢ２共晶复合材料，并用ＳＥＭ和ＴＥＭ方法对其显微组织进行了研究。结果表明，ＬａＢ６ＺｒＢ２形成纤维状共晶组织，控制凝固条件可得到定向排列的组织，ＬａＢ６基体上均匀分布着直径为０２～１２μｍ的ＺｒＢ２纤维，纤维长度可达１００μｍ以上。对于固液界面为平面生长的试样，其结晶学取向关系为［００１］ＬａＢ６∥［００１］ＺｒＢ２，（１１０）ＬａＢ６∥（０１０）ＺｒＢ２。     

酯交换法合成碳酸二苯酯用氧化铅－氧化锌催化剂的研究

 制备了一种用于苯酚与碳酸二甲酯酯交换合成碳酸二苯酯的新型氧化铅－氧化锌多相催化剂．研究了制备方法、焙烧温度、不同母体和母体配比对催化剂催化性能的影响．应用XRD，TPR和原子吸收光谱对催化剂结构进行了表征，发现Pb3O4是主活性物相，ZnO为助催化剂，并以非晶态或微晶态存在于催化剂体系中．当焙烧温度为500℃，n（Pb）／n（Zn）≈2时，催化剂的活性最高，碳酸二苯酯产率可达45．6％．考察了催化剂的重复使用效果，并对失活原因进行了探讨．     

Low Dimension Semiconducting Composite Nanomaterials

Recently, low dimension nanostructures have gained considerable attention due to their technological potential as unique types of nanoscale building blocks for future optoelectronic devices and systems. Semiconducting composite nanomaterials, which can combine the advantages of two or more components, have been the focus in the area of nanomaterials synthesis and device application.In this paper, we report our work on the preparation of composite nanomaterials based on CNTs.CNTs were coated by organic or inorganic species via novel and facile methods (Fig. 1 and Fig.2).These functional CNTs based composites show eminent prospects and opportunities for new applications in a wide variation of areas.     

Tribological properties of ormosil coatings

Transparent plastics are not scratch resistant. The damage leads to a loss of optical properties. Coatings prepared using either tetraethoxysilane or colloidal silica particles embedded in glymo is a way to avoid these disadvantages. Tribological experiments are carried out to better understand the surface modification due to a sliding friction. It is shown that the wear track is not directly related to usual mechanical properties such as Young's modulus and the hardness of the coating. The different stages leading to material loss are discussed in term of particle removal and debris circulation (accumulation or elimination) through the friction track. The mechanical properties of the film combined with the film to substrate adhesion are expected to play an important role as it can be deduced from results obtained as a function of the coating composition.     

A scratch-resistant single-layer antireflective coating by a low temperature sol-gel route

A novel quarterwave-thick narrow-bandwidth antireflective coating has been developed for both plastic and vitreous substrates by a sol-gel route. This coating has revealed pronounced scratch- and climatic-resistance under adverse conditions. The single-layer coating consists basically of a composite material made of silica as the discontinuous phase and of a polytetrafluoroethylene-derived (Teflon¹) organic polymer as the continuous phase. This leads to fluorine-containing colloidal silica product, or a so-called Flucosil coating. The coating is applied by spinning or dipping from specific solutions at room temperature followed by a mild and short heat treatment. In addition to remarkable abrasion and environmental resistance properties, such coatings have displayed excellent laser-induced damage threshold levels, surpassing uncoated substrates.We hope such a product might open new perspectives concerning household articles, architectural optical thin-films, ophthalmic uses, and so on.     

球形SiO2-Al2O3的制备、结构和性能

将Na2SiO3·9H2O 溶液通过强酸性阳离子树脂进行离子交换得到酸性硅溶胶,再将硅溶胶与铝溶胶及六次甲基四胺混合后采用油柱成型法制备了球形SiO2-Al2O3复合氧化物. 通过XRD、BET 及TPD等手段对样品进行测试和表征, 结果表明, 600 ℃焙烧得到的SiO2-Al2O3中SiO2以无定型形式存在, 其比表面、孔容与表面酸性随SiO2含量的增加而提高, 孔径、堆密度随SiO2含量的提高而减小, 压碎强度基本保持不变.     

复合Fe2O3纳米粒子的高分子微球的结构表征

近年来，复合有机、无机粒子的高分子微球及其特殊性质越来越引起人们的兴趣与关注［1］．获得有机、无机复合微球的方法很多，如在无机粒子存在下的乳液或无皂乳液聚会[2，3]，通过可聚合的表面活性剂在粒子表面形成胶囊化层[4]以及共沉淀法等[5]．这些无机粒子包括氧化钛、氧化铁、氧化铝及氧化硅等．Haga等[6]增发现包覆在聚合物粒子中的CdS与其本体的光电性质不同；单分散的聚合物微球可以在基片上被组装成二维乃至三维有序的结构[7]．这为信息存储、立体印刷等领域提供了新途径．因此，将无机粒子与聚合物复合成为功能化粒子是一项有…