Study of oxygen vacancy ordering in mullite at high temperatures

High temperature X-ray diffraction and quenching experiments of mullite single crystals with Al₂O₃:SiO₂ ratio 2:1 have been performed to investigate the stability of the oxygen vacancy ordering close to the melting point of mullite. The experiments show that the structure of mullite exhibits an extremely stable, temperature-independent incommensurate modulation. Inspection of satellite reflections at different temperatures leads to the conclusion that the ordering scheme of oxygen vacancies after the crystallization of mullite persists to the melting point and does not show any disordering effects. The experimental results are in agreement with former theoretical calculations using a statistical mechanics approach which yield the critical temperature T_c > 3000°C.     

Parallelism across the steps in iterated Runge-Kutta methods for stiff initial value problems

For the parallel integration of stiff initial value problems (IVPs) three main approaches can be distinguished: approaches based on parallelism across the problem, on parallelism across the method and on parallelism across the steps. The first type of parallelism does not require special integration methods can be exploited within any available IVP solver. The methodparallel approach received some attention in the case of Runge-Kutta based methods. For these methods, the required number of processors is roughly half the order of the generating Runge-Kutta method and the speed-up with respect to a good sequential IVP solver is about a factor 2. The third type of parallelism (step-parallelism) can be achieved in any IVP solver based on predictor-corrector iteration. Most step-parallel methods proposed so far employ a large number of processors, but lack the property of robustness, due to a poor convergence behaviour in the iteration process. Hence, the effective speed-up is rather poor. The step-parallel iteraction process proposed in the present paper is less massively parallel, but turns out to be sufficiently robust to solve the four-stage Radau IIA corrector used in our experiments within a few effective iterations per step and to achieve speed-up factors up to 10 with respect to the best sequential codes.The research reported in this paper was partly supported by the Technology Foundation (STW) in the Netherlands.     

Effect of defects on the electronic structure of a PbI2/MoS2 van der Waals heterostructure: A first-principles study

PbI2/MoS2,as a typical van der Waals(vdW)heterostructure,has attracted intensive attention owing to its remarkable electronic and optoelectronic properties.In this work,the effect of defects on the electronic structures of a PbI2/MoS2 heterointerface has been systematically investigated.The manner in which the defects modulate the band structure of PbI2/MoS2,including the band gap,band edge,band alignment,and defect energy-level density within the band gap is discussed herein.It is shown that sulfur defects tune the band gaps,iodine defects shift the positions of the band edge and Fermi level,and lead defects realize the conversions between the straddling-gap band alignment and valence-band-aligned gap,thus enhancing the light-absorption ability of the material.     

基于NICE-OHMS技术进行大气压气样直接检测的理论分析

噪声免疫腔增强光外差分子光谱技术(NICE-OHMS)是目前世界上最灵敏的激光吸收光谱技术,其在低压环境中具有极高的探测灵敏度。然而当测量样品处于大气压时,NICE-OHMS系统的探测灵敏度会大幅下降。主要原因之一是大气压下获取最大NICE-OHMS信号幅度的条件与低气压下不同。通过对大气压NICE-OHMS理论进行分析,分析了影响信号幅度的参数,并通过数值模拟来寻找最佳的实验条件。本文着重讨论影响信号的主要参数包括光学腔腔长L,调制系数β,探测相位θ。其中,由于在NICE-OHMS中使用DeVoe-Brewer技术将调制频率ν_m锁定到Fabry-Parot(FP)腔的自由光谱区(FSR)。因此FP腔的腔长决定了ν_m,同时还作用于信号幅度S■。模拟结果显示,当腔长增大时,由于ν_m随之减小,载波和边带的光谱成分相互重叠部分增大,因此线型函数的幅度逐渐减小。而吸收信号幅度随着腔长的增加而逐渐增加,色散信号幅度先增大后减小,并且在腔长等于8 cm时达到最大值。调制系数β会影响频率调制后激光载波和边带的幅度大小,并且影响信号线型。随着腔长的增加,最大信号幅度对应的β值也随之增加。在相同腔长下,色散信号的最佳β值小于吸收信号,更容易使用电光调制器实现。最后分析了参数的可实现性,分析了不同种类激光器的频率调谐能力,压电陶瓷的扫描宽度等。以乙炔气体为例,大气压下NICE-OHMS的谱线半宽达到~3 GHz,而光谱覆盖范围大于10 GHz。分布反馈式半导体激光器(DFB)与外腔二极管激光器(ECDL)的频率调谐范围可以达到30 GHz以上,但是由于激光线宽宽,得到的PDH锁定性能欠佳。回音壁模式激光器(WGM)和掺饵光纤激光器(EDFL)线宽为百Hz量级,是目前高灵敏NICE-OHMS系统中常用的光源。但是WGM目前可以实现了5 GHz的激光频率调谐范围,而EDFL的外部电压可控制的调谐范围仅为3 GHz。使用精细度为55000的腔进行模拟,调制系数β=1,腔长大于8 cm时,可使用WGM激光器实现,腔长大于25 cm时,可以使用EDFL激光器实现。而对于在设计光学腔中常用的伸缩长度为25μm的PZT,随着腔长的增加,对应的腔模频移范围逐渐减小,在腔长为典型的40 cm时,扫描范围大于12 GHz。     

Development of low concentrated solar photovoltaic system with lead acid battery as storage device

Energy storage system powered by renewable energies is a viable option to meet energy requirement without addition of carbon footprints to the environment. This study involves development of theoretical and computational models for a solar photovoltaic (PV) system coupled with a lead acid battery. The study commenced with selection of most appropriate lead acid battery and PV system for installation in a representative location in Riyadh, Kingdom of Saudi Arabia. Various technical and economic parameters were assessed and calculated by computational approach. The optimized lead acid battery was integrated with low concentration solar PV panels (CPV) followed by a feasibility study. Theoretical model was developed for the integrated system to calculate various parameters of the CPV and lead acid battery. Technical and economic assessment of this coupled unit was calculated using a theoretical approach. The developed model was then subjected to computational approach for verification and validation analysis of the integrated system. The detailed assessment of batteries and integrated system show the applicability of this system in Riyadh region. The research will be extended to develop energy storage systems for remote areas using lead acid batteries.     

基于敏感性制图和数值模拟的泥石流综合评价——以九绵高速公路沙尕沟为例

泥石流等地质灾害的评估对于公路选线和安全运营有着重要的意义.随着科技的发展,越来越准确的泥石流评价和预测体系亟待研究.通过现场勘测和无人机解译,利用自适应神经模糊推理系统(ANFIS)和基于学习优化算法的自适应神经模糊推理系统(TLOA-ANFIS)对泥石流沟进行敏感性评价,并对沙尕沟进行区域划分,结果显示沙尕沟沟口3...     

土壤内水分流动及温度分布计算——耦合型模型

本文目的在于发展一个计算土壤内水分输送及能量交換的物理模型——耦合型模型,驱动该模型的大气条件是由实测而得的,引用对蒸发的土壤表面阻抗关联了在大气中水汽通量与从地表的蒸发,由于这种阻抗引入,计算模拟的结果与实测值达到了较好的吻合。     

催化剂活性位本质和构效关系的模型催化研究

明确催化剂的活性位本质和构建多相催化的结构和反应性能之间的准确关系是催化基础研究的重点,表面科学研究基于丰富的表征测试手段能够较好地在分子原子水平测定表面结构以明确催化剂活性位本质,并通过高压原位反应池测定相关催化反应性能,获得较可靠的催化剂构效关系。本文简要总结了近年来本人参与的几个模型催化研究例子,包括贵金属表面上CO和烷烃催化氧化的活性表面、纳米Au膜的制备和CO氧化的催化活性位、VO_x/Pt(111)上丙烷氧化的协同作用、Au Pd合金上醋酸乙烯酯合成Au的助催化作用、模型氧化物上纳米Pt的庚烷脱氢环化制甲苯的粒径关系等,以及相关模型催化研究技术的进展。     

次贷危机下我国资本市场与银行体系跨市场风险传染实证研究

跨市场风险传染是在金融工具创新和金融业务融合的过程中,金融风险跨越原有金融分业经营界限由某一金融机构、金融市场向其他金融机构和市场传导的机制.本文通过构造资本市场三大价格指数,利用格兰杰(Granger)因果关系检验、向量自回归模型(VAR模型)、方差分解和脉冲响应函数对次贷危机给我国资本市场带来的金融风险向银行体系传导进行实证分析,并得出股票市场风险的跨市场传染是资本市场金融风险向银行体系传导的主要形式,股票市场对信贷市场的影响时间更长,而股票市场对票据市场的冲击强度更大.     

纯毛精纺针织绒的工艺研究

简要介绍了全毛精纺针织绒生产工艺方面的探索和实践。主要讨论了全毛针织绒的生产流程,原料的选择、毛油合理的油水比例,纺纱设备的工艺调试对产品生产和成品质量的影响,以及在生产中采用的主要技术措施。