导电复合材料葡萄糖氧化酶传感器的研究

报导了用乙基纤维素和乙炔黑获得的导电复合材料构成的葡萄糖氧化酶生物传感器的制备方法.讨论了多种因素对该生物传感器响应电流的影响.测得此电极酶催化反应的活化能为40.3 kJ•mol－1. AFM实验表明，用环己烷洗去石蜡的导电复合材料 葡萄糖氧化酶生物传感器具有粒状结构，这有利于酶催化反应的进行.     

铜中杂质成分标准物质的研制

介绍铜中9种杂质成分标准物质的研制方法。以1号纯铜为基体，配入硫、铁、铅、锌、镍、铋、锑、磷、砷及锡共10种杂质成分，采用雾化喷粉加工工艺，保证了样品的均匀性。对样品表面作了抗氧化保护处理。采取多家实验室协作定值的方式对除砷外的9种杂质成分进行定值。5年的跟踪检验结果表明，该标准物质稳定性良好。     

Synthesis and Luminescence Property of 4,4＇-Bis（2,2-di（4-fluorophenyl）vinyl）biphenyl for Organic Blue-Light-Emitting Diodes

The novel fluorinated distyrylarylene, 4,4＇-bis（2,2-di（4-fluorophenyl）vinyl）biphenyl （DFPVBi）, was synthesized and fully characterized. The structure was confirmed with IR, 1↑H NMR, 13↑C NMR, 19↑F NMR and MS analyses. Its electronic and photoluminescence properties were investigated by UV-Vis absorption, cyclic voltammetry and fluorescence spectroscopy. The energy levels of the highest occupied molecular orbital （HOMO） and the lowest unoccupied molecular orbital （LUMO） are --5.77 and --2.75 eV, respectively. The electroluminescence proper- ties of the organic light-emitting diode fabricated by DFPVBi were also studied. The device exhibits a pure blue emission peaked at 454 nm, which indicates a maximum luminance of 5872 cd/m ^2 at 14.2 V and a maximum current efficiency of 2.82 cd/A at 10V, respectively.     

Solid-state synthesis and properties of SmCoO3

In this paper, perovskite oxide SmCoO₃ was prepared by the solid-state reaction method using Co₂O₃ and Sm₂O₃ as raw materials. The structure and properties of the samples were investigated by XRD, Raman spectral techniques, and DC measurements and so on. The results of XRD and Raman spectra showed that the mixtures of Co₂O₃ and Sm₂O₃ can react to produce a single phase perovskite oxide SmCoO₃ around 1353 K. The single-phase SmCoO₃ changes from an insulator to a semi-conductor and transition occurs around 470 K. The thermal expansion coefficient (2.17 × 10⁻⁵ K⁻¹) of the single-phase SmCoO₃ is approximately equal to that of doped LaGaO₃, but much bigger than that of SDC(Ce_0.85Sm_0.15O₂) above 873 K.     

主链含膦酸酯的聚酸酐药物控制释放材料研究

通过二氯膦甲（乙）酸乙酯与对羟乙氧基苯甲酸反应，制备了二羧苯氧乙氧基膦甲（乙）酸乙酯，并其转化成混合醋酐并通过熔融缩聚，合成了主链含膦甲（乙）酸乙酯的聚酸酐，以二羧苯氧乙氧基膦甲（乙）酸乙酯，分别与１，３－双（４－羧基苯氧基）丙烷（ＣＰＰ）及癸二酸（ＳＡ）共聚，得到相应的共聚酸酐，对所合成的单体和聚合物的结构进行了表征，研究了它们的体外降解，酶促降解及其对抗肿瘤药物５－氟尿嘧啶和氨甲喋蛉的释放性能     

化学计量及其进展

扼要介绍了化学计量主要研究内容和量传方法。并从化学计量技术机构,基准、标准装置,标准物质,检定规程和化学计量学等方面,叙述了化学计量的进展概况。     

四苯基卟啉铂电致发光性能的研究

四苯基卟啉铂(PtTPP)可以作为红光掺杂材料制备有机电致发光器件，采用的器件结构为[ITO／CuPc／NPB／BePP2：PtTPP／LiF／Al]，其中BePP2：PtTPP的共沉积膜作为发射层．实验结果表明在发射层中存在着从BePP2到PtTPP的能量传递．通过改变掺杂层中PtTPP的浓度来考察器件的性能，当PtTPP的掺杂浓度在8％(物质的量比)时，器件呈现纯正的红光发射，发射峰位于668nm，器件的效率为0．004lm／W．     

Photoelectrochemical behavior of coupled SnO2|CdSe nanocrystalline semiconductor films

A photoelectrochemical cell with a coupled SnO₂|CdSe nanocrystalline semiconductor electrode has been prepared by sequential deposition of SnO₂ and CdSe films onto an optically transparent electrode (OTE), and its photoelectrochemical behavior has been studied. The results show that the coupling of CdSe with SnO₂ leads to an improvement in the performance of OTE|SnO₂|CdSe over OTE|CdSe cells in terms of increased incident photon-to-current conversion efficiency, increased stability and smaller reversal of current. The favorable positioning of the energy bands of SnO₂ and CdSe is responsible for the above observations. Various photoelectrochemical parameters of the OTE|SnO₂|CdSe cell obtained for an incident light power of 0.31 mW cm⁻² at 470nm, are as follows: I_sc ≈ 25–30 μA cm⁻², V_oc ≈ 0.5–0.6 V, ƒƒ = 0.47 and a power conversion efficiency of about 2.25%.     

Investigation on spontaneous ignition of two kinds of organic material with water

A systematic investigation was performed to elucidate the cause of spontaneous ignition of Refuse Derived Fuel (RDF) and Meat Bone Meal (MBM). Heat generation in both RDF and MBM with addition of water liquid and vapor at room temperature was determined by isothermal calorimetry. Compared with water liquid, the heat of wetting by sorption of water vapor at 80% relative humidity and 25 °C was larger, which can raise the temperature of RDF and MBM more than 30 and 56 °C, respectively. Heat generation due to fermentation occurred and the temperature of RDF and MBM reached or exceeded 80 °C after 5 days for RDF and 4 days for MBM at 100% RH. The spontaneous ignition for RDF and MBM results from heat of wetting and fermentation at room temperature and a further exothermic reaction at higher temperature.     

Synthesis and electrochemical properties of Zn3V3O8 as novel anode material

Zn₃V₃O₈ two-dimensional micro sheets are successfully synthesized by combination of solvothermal method and heat treatment. The Zn₃V₃O₈ has better electrochemical performances after calcinations.