Sm3+掺杂Ba0.85Ca0.15Ti0.90Zr0.10O3无铅多功能铁电陶瓷的储能和光致发光性能

通过高温固相反应法制备了Ba_0.85Ca_0.15Ti_0.90Zr_0.10O₃∶xSm³⁺(BCTZ∶xSm³⁺,x=0.0%、0.2%、0.4%、0.6%、0.8%、1.0%,物质的量分数)陶瓷,系统研究了其微观形貌、铁电性能、储能性能和光致发光性能。研究表明,Sm³⁺掺入后,陶瓷平均晶粒大小明显下降,致密度显著提高。所有陶瓷均表现出典型的铁电性。BCTZ∶xSm³⁺陶瓷放电储能密度得到了极大的提高,BCTZ∶1.0% Sm³⁺陶瓷放电储能密度较纯BCTZ陶瓷可提高约49.0%。此外,在408 nm光的激发下,BCTZ∶xSm³⁺陶瓷在596 nm左右表现出强烈的橙红色发光,且发光强度相对可调性可达449%。     

巢湖、龙感湖水体中稀土元素的无机形态研究

运用MINTEQ化学平衡软件对巢湖、龙感湖中溶解态稀土的形态进行模拟。模拟结果表明，在巢湖和龙感湖中Ln（CO3）^2-，LnCO3^＋是溶解态稀土的最主要的存在形式，当8pH〉7．19时，REE主要以LnCO3^＋形式存在，当pH〉8时，REE主要以Ln（CO3）2^-形式存在，并且∑Ln（CO3）n^3-2n（n=1和2）形态的稀土基本上占溶解态稀土总含量的93％以上。Ln^3＋在巢湖和龙感湖水体中平均丰度为5．03％，Ln^3＋的丰度和pH值成反相关关系。LnPO4在湖水中平均丰度为1．61％，但这种形式的稀土在巢湖和龙感湖中非常重要。巢湖和龙感湖中LREE的LnPO4均处于过饱和状态，甚至巢湖西半湖区丰水期HREE的LnPO4的也都处于过饱和状态，PO4^3＋对稀土的存在有很强的限制作用。InSO4，LnF^2＋，LnOH^2＋，LnCl^3＋等形态的各元素平均丰度均小于1％，在富营养化的淡水中通常可以忽略不计。     

高光效高热稳定性蓝色荧光粉Ca2-ySrySiO4:Ce3+,Li+的组成筛选和发光机理

采用高温固相法合成了一系列Ca_(2-x-y)Sr_(y-x)SiO_4∶x Ce~(3+),x Li~+蓝色固溶体荧光粉。XRD结果表明,所合成的固溶体荧光粉均为单一物相。随着Sr~(2+)成分的增加,Ca_(2-y)Sr_y SiO_4物相从单斜晶系β-Ca_2SiO_4向正交晶系α′-Ca_2SiO_4转变,发射光谱逐渐红移。组成为Ca_(1.75)Sr_(0.25)SiO_4时,荧光粉的发射波长最长(454 nm),Stokes位移最大。基质为Ca_(1.1)Sr_(0.9)SiO_4的晶体结构可诱导掺杂离子Ce~(3+)取代SrO_(10)格位、Li~+取代CaO8格位。优化的荧光粉Ca_(1.05)Sr_(0.85)SiO_4∶0.05Ce~(3+),0.05Li~+(CS_(0.85)SO∶CeLi)在375 nm紫外光激发下,发射445 nm的蓝光,内量子效率(IQE)达到91.18%,200℃时发射强度保持室温发光强度的98.70%。根据晶体结构、晶体场分裂和掺杂离子质心位移等理论,讨论了CS_(0.85)SO∶CeLi综合发光效应最佳的内在原因。     

Er~(3+)-Yb~(3+)掺杂SiO_2-SrO-NaF玻璃陶瓷的制备及表征

采用熔融晶化法制备了主晶相为SrF_2的Er~(3+)-Yb~(3+)共掺透明氟氧化物玻璃陶瓷,利用DSC、XRD、SEM、UV-Vis-NIR和荧光光谱对样品的结构、形貌、发光性能进行了测试与表征。研究表明:该体系玻璃最佳热处理温度为620℃,最佳热处理时间为2h,并讨论了Yb~(3+)不同掺杂浓度对Er~(3+)-Yb~(3+)共掺玻璃陶瓷样品上转换发光性能的影响,确定Er~(3+)-Yb~(3+)最佳掺杂浓度比为1∶7,同时观察到了明亮的绿光(522,540 nm)和较弱的红光(656 nm),对Er~(3+)和Yb~(3+)之间的能量传递过程进行了讨论。     

橙红色荧光粉Ca_(1-x-y)Sm_xBi_ySiO_3的制备及其发光性能

以Sm3+作为激活剂,Bi3+作为辅助激活剂,采用水热法合成Ca1-x-ySmxBiySi O3前驱体,然后在1 100℃焙烧得到系列橙红色荧光粉。用X-射线衍射仪、扫描电镜和荧光分光光度计和傅里叶变换红外光谱等手段对样品的组成、结构和形貌及其发光性质进行分析和表征。分析结果表明:产物都为三斜晶系结构的Ca1-x-ySmxBiySi O3和四方结构的方石英Si O2共熔体。在405 nm近紫外光激发下,产物的发射光谱由3个峰组成,发射峰值位于566、606和650 nm处,分别归属于Sm3+的4G5/2→6HJ/2(J=5,7,9)跃迁。产物的激发光谱在405 nm有很强的发射带,与近紫外LED芯片匹配。随着Sm3+掺量的增加,样品发光强度先增强后减弱,当Sm3+的物质的量分数为3%时发光强度达到最大,浓度猝灭机理为电偶极-电偶极相互作用。当Bi3+的物质的量分数在0.3%~1.5%时,对产物Ca0.97Sm0.03Si O3的荧光强度起敏化作用。Sm3+和Bi3+的最佳物质的量分数分别为3%和0.5%。     

Ce3+掺杂La2O3的17O固体核磁共振研究

本文用水热共沉淀法制备Ce³⁺掺杂La₂O₃的前驱体,随后在H₂/N₂气氛下用高温煅烧法合成了不同Ce³⁺浓度的掺杂La₂O₃。由于Ce³⁺的掺杂,¹⁷O固体核磁共振谱图中在698、650和558处出现了新的共振峰;随着Ce³⁺掺杂浓度的增加,这些峰的强度也随之增强。根据谱峰位置和强度,对谱图进行了归属：698、650处的共振峰应源自与Ce³⁺相连的四配位O(OCeLa₃),558处的信号则来自于与Ce³⁺相连的六配位O(OCeLa₅)。通过¹⁷O固体核磁共振能够直接观测与Ce³⁺直接相连的O显示该方法将可能用于研究稀土掺杂氧化物功能材料。     

A combination of leaf rust resistance gene Lr34 and lesion mimic gene lm significantly enhances adult plant resistance to Puccinia triticina in wheat

Leaf rust caused by Puccinia triticina is an economically-important disease in wheat worldwide.A combination of different types of resistance genes may significantly enhance rust resistance under rust-favorable conditions.To investigate the interactions between the rust resistance gene Lr34 and the lesion mimic gene lm on 1BL in Ning 7840,a segregating F8-10 population of 180 recombinant inbred lines was developed from Ning 7840/Chokwang and evaluated for both lesion mimic expression and leaf rust response at the adult plant stage in a greenhouse.A major quantitative trait locus(QTL),derived from Sumai 3,was co-localized with Lr34 on chromosome 7D and explained 41.5% of phenotypic variations for rust severity and 22.1% for leaf tip necrosis(LTN).The presence of Lr34 was confirmed by Lr34-specific markers cssfr1 and cssfr2 in Ning 7840 and Sumai 3.Unlike Lr34,lm conditioned a spontaneous lesion mimic phenotype and had a significant effect on reducing uredinial size,and a smaller effect on severity.Additive effects were observed between lm and Lr34 for severity and LTN,and an epistatic effect was observed for infection type.Single marker analysis also identified several other QTL with minor effects on severity,infection type,or LTN.     

Phase transition , structure and shape memory effect of Ni47Ti43Hf10 alloy

A Ni₄₇Ti₄₃Hf₁₀ high temperature shape memory alloy is fabricated. The martensitic transformation temperature (TT) is obtained by differential scanning calorimetry and four-probe electrical resistivity measurements. The effect of thermal cycling is investigated and it is found that the TT tends to be stable quickly, which is of benefit to practical applications. The martensite structure is determined to be B19' monoclinic by X-ray diffraction and transmission electron microscopy. One-way and two-way (which is seldom reported before) shape memory properties are studied by tensile and bending tests. The cycling number of two-way shape memory effect is tested for more than 20000 times.     

Characterization of Type p Banach Spaces by the Weak Law of Large Numbers

For weighted sums of the form ∑j＝1anjXnj where {anj, 1≤j≤kn ↑∞,n≥1 } is a real constantarray and {Xnj, 1≤j≤kn ,n≥1 } is a rowwise independent, zero mean, random element array in a real sep-arable Banach space of type p, we establish Lr convergence theorem and.a general weak law of large num-bers respectively, conversely, we characterize Banach spaces of type p in terms of convergence in r-thmean and probability for such weighted sums.