Li2CO3添加剂对石墨电极性能的影响

运用电化学阻抗谱(EIS)和循环伏安法(CV)研究了在1mol/LLiPF6-EC(碳酸乙烯酯):DMC(碳酸二甲酯)电解液中添加Li2CO3对石墨电极性能的影响及机制.CV研究结果表明,在1mol/LLiPF6-EC:DMC电解液中添加Li2CO3能够有效抑制石墨电极首次充放电过程中碳酸乙烯酯(EC)的单电子还原过程,即还原分解产生乙烯和碳酸锂的过程,进而改善石墨电极的电化学循环性能.EIS研究结果表明,在添加Li2CO3的1mol/LLiPF6-EC:DMC电解液中,石墨电极表面的固体电解质相界面膜(SEI膜)具有较强的黏弹性,可以更好地适应锂离子嵌入过程中石墨颗粒体积的微小变化,从而使锂离子的嵌入过程更容易进行.     

Li4 Ti5 O12纳米片的合成及储锂性能研究

以无定形的水合二氧化钛为前驱物,水热法合成了200～400nm大小的Li4Ti5O12纳米片作为锂离子电池负极材料.XRD(X射线衍射)、SEM(扫描电子显微镜)和TEM(透射电镜)分析表征样品的物相结构、表观形貌;循环伏安、充放电循环和电化学交流阻抗技术分别测定该纳米Li4Ti5O12在有机电解液和室温离子液体S114TFSI电解液中的电化学性能.结果表明,该材料具有较高的放电容量和良好的循环性能,有望成为锂二次电池新型负极材料.     

Li_3V_2(PO_4)_3制备及其电化学性能

应用碳包覆固相法合成锂离子电池Li3V2(PO4)3正极材料.X射线衍射、扫描电子显微镜表征材料的结构和观察表面形貌.材料的电阻和电化学性能测试表明,碳包覆Li3V2(PO4)3材料可避免颗粒团聚,减小颗粒尺寸,提高材料电导率,改善其电极的电化学性能.     

新型锂离子电池正极材料Li0.86V0.8O2的水热合成及性质

采用两步反应制备了新型锂离子电池正极材料Li0.86V0.8O2. 该材料具有六方层状结构, 空间群为R3m. 研究了在水热条件下溶液的碱度对于钒酸锂盐形成的影响, 在低碱度的条件下, 前驱体V2O3和LiOH·H2O并未发生反应, 只有在碱度达到2.5 mol/L时, 才能形成单相的Li0.86V0.8O2材料. X射线光电子能谱分析发现, V2p的结合能位于516.4 和523.1 eV, 分别对应于四价钒离子的V2p3/2 和V2p1/2, 这说明在Li0.86V0.8O2中V离子主要价位为+4价. 在电流密度为7.4 mA/g的充放电中, Li0.86V0.8O2初始充电容量达到163 mA·h/g, 首次放电容量也能达到113 mA·h/g, 20次循环后放电容量仍然可以达到80 mA·h/g, 表现出较好的循环性能.     

反应物分散条件对Li1+xV3O8电化学性能的影响

以Li₂CO₃和NH₄VO₃为原料,在不同条件下合成了锂离子电池正极材料用Li_1+xV₃O₈。研究了反应物的分散条件和煅烧温度对产物晶型结构、形貌及电化学性能的影响。 XRD、IR和SEM结果表明,用超声波在无水乙醇中分散反应物得到的前驱体于550 ℃下煅烧,所得产物Li_1+xV₃O₈结晶度低、粒径小、形貌均匀。 充放电、循环伏安等结果表明,该材料在充放电过程中极化低、嵌脱锂位置多、循环稳定性好。 在0.5 C放电条件下,第2次循环放电容量达到268 mA·h/g,100次循环后容量仍保持210 mA·h/g以上。     

Li3PO4包覆LiMn2O4正极材料的结构表征和电化学性能

采用共沉淀法在尖晶石LiMn2O4颗粒表面包覆Li3PO4.XRD、SEM研究结果表明,包覆后的材料仍为尖晶石结构,粒径均匀.电化学性能测试表明,Li3PO4包覆层的存在,减少了正极材料与电解液的直接接触,抑制了高温下电解液对LiMn2O4材料的侵蚀,从而有效改善了高温下材料的循环性能.在40℃时,包覆样品的比容量衰减率都低于未包覆样品,其中包覆1%Li3PO4的样品的初始比容量为110.4mAh/g,50次循环后比容量为84.1mAh/g.     

Fabrication of solid thin film electrolyte and LiCoO2 by aerosol flame pyrolysis deposition

Aerosol flame pyrolysis deposition method was applied to deposit the oxide glass electrolyte film and LiCoO₂ cathode for thin film type Li-ion secondary battery. The thicknesses of as-deposited porous LiCoO₂ and Li₂O–B₂O₃–P₂O₅ electrolyte film were about 6 μm and 15 μm, respectively. The deposited LiCoO₂ was sintered for 2 min at 700 °C to make partially densified cathode layer, and the deposited Li₂O–P₂O₅–B₂O₃ glass film completely densified by the sintering at 700 °C for 1 h. After solid state sintering process the thicknesses were reduced to approximately 4 μm and 6 μm, respectively. The cathode and electrolyte layers were deposited by continuous deposition process and integrated into a layer by co-sintering. It was demonstrated that Aerosol flame deposition is one of the good candidates for the fabrication of thin film battery.     

室温熔盐二(三氟甲基磺酸酰)亚胺锂-尿素体系的分子动力学模拟

应用分子动力学模拟了25 ℃和50 ℃时新型室温熔盐二(三氟甲基磺酸酰)亚胺锂[LiN(SO2CF3)2, LiTFSI]与尿素(摩尔比为1:3.6)体系的结构与动力学性质. 在两个温度下体系的微观结构基本相同, Li+的配位数约为5, 且都是与溶剂和阴离子中的氧原子发生配位. 对TFSI-的研究表明, 每个TFSI-只提供四个氧中的一个与Li+配位; 而且在Li+的配位层中, TFSI-具有顺、反和gauche 等不同的构象, 并且不同构象出现的几率会随着温度的改变而改变.     

Monoclinic β-Li2TiO3: Neutron diffraction study and estimation of Li diffusion pathways

A neutron powder diffraction study on lithium titanate Li₂TiO₃ was performed at low temperatures. The monoclinic β-phase has been found to be stable over the whole investigated range of temperatures (4 K–300 K). A smooth and nonlinear increase of the lattice parameters has been observed upon heating and correlated to the behavior of interatomic distances. Lithium diffusion pathways in Li₂TiO₃ were estimated theoretically on the basis of the obtained structural data using bond-valence modeling. Experimentally diffusion pathways were evaluated by analysis of the negative nuclear scattering densities at 1073 K, which were reconstructed using a maximum entropy method. Although the bond-valence mismatch map indicated a possible Li diffusion either in ab plane or along c direction, analysis of the experimental data revealed that Li migration is thermodynamically less feasible in latter case.     

Protection of Li metal anode by surface-coating of PVDF thin film to enhance the cycling performance of Li batteries

The PVDF thin film on the surface of the lithium metal can highly suppress the lithium dendrites.