An XPS,ISS and ESR Comparative Study of Eight-Coordination of Copper (II) Ions in the CuTho Compounds

In this study, we attempted to clarify the coordination state and the distribution of copper (II) ions in the CuThO compounds prepared by coprecipitation, by using several physico-chemical techniques in particular, X-Ray Photoelectron Spectroscopy (XPS).

For atomic ratios Cu/Th ≤ 0.25, the copper (II) species are mainly located near the thoria surface. The Cu2p_3/2 level shows a chemical shift towards the lower binding energy compared to Cu²⁺ ions in CuO and also a net decrease in the intensity of the satellite peak, characteristic of copper (11). A relation between these observations and the covalent character o f Cuzt- 02- bond i s esta- blished. Eightfold coordination of copper (11) i n the thoria lattice i s evident. These conclusions are in good agreement with Electron Spin Resonance (ESR) results.

For a higher atomic ratio (Cu/Th > 0.25), a formation o f copper oxide crystallites i s observed on the thoria surface.     

ISS加固土的微观结构及强度特征

通过化学分析、SEM电镜扫描分析、无侧限抗压强度等实验，研究了ISS加固粉土质砂和砂质低液限粉土的微观结构及其强度特征，结果表明：ISS的掺入，使土体易土压实，孔隙体积减小，密实度提高，从而提高土的强度。ISS加固土中适量掺入水泥，可以明显提高加固土的早期强度，且能生长出纤维状矿物，充填在土颗粒之间的孔隙中，使加固土强度和抗变形能力得到显著提高。     

Energy spectra of HZE-particles inside the International Space Station

To measure the energy spectra of low energy ions inside the International Space Station (ISS) we will expose three stacks of CR-39 plastic nuclear track detectors aligned to the three coordinate axes of the space station. The energies of cosmic ray nuclei at the stack surfaces can be determined by reconstructing the trajectories of ions stopping inside the detector material and by measuring their ranges. To measure only HZE (high charge Z and energy E) ions with charges of Z6 stopping in our experiment a special batch of CR-39 detectors with low sensitivity will be used. This detector material has been already tested by an exposure to carbon ions at the GSI accelerator in Darmstadt, Germany.     

环氧氯丙烷修饰的对位和间位芳纶涂覆剂研究

制备了具有环氧丙基侧链的对位芳纶(PPTA-ECH)和间位芳纶(PMIA-ECH),并将其用做对位芳纶(PPTA)织物/环氧树脂复合材料中PPTA织物的涂覆剂。采用场发射扫描电子显微镜(FE-SEM)及XPS等方法对PPTA织物表面的PPTA-ECH涂层结构进行了表征。考察了PPTA-ECH和PMIA-ECH涂覆的PPTA织物/环氧树脂复合材料的层间剪切强度和面内剪切强度,并与未经涂覆的PPTA织物复合材料的性能作比较。结果表明,PPTA-ECH和PMIA-ECH可显著改善PPTA织物和环氧树脂之间的界面性能。涂覆了PPTA-ECH及PMIA-ECH的PPTA织物/环氧树脂复合材料的层间剪切强度(ILSS)比未经涂覆的复合材料分别提高了26.20%和14.76%,面内剪切强度(ISS)分别提高了26.98%和11.86%。由于PPTA-ECH对PPTA纤维具有更强的亲和能力,因此PPTA-ECH在层间剪切强度和面内剪切强度方面的增强效果均优于PMIA-ECH。对PPTA-ECH在PPTA纤维表面铺展与吸附及对复合材料的增强机理也进行了初步探讨。作为新型涂覆剂,PPTA-ECH在对位芳纶复合材料的开发应用方面具有潜在的应用前景。     

Ion scattering and X-ray photoelectron spectroscopy of copper overlayers vacuum deposited onto mercaptohexadecanoic acid self-assembled monolayers

Metal overlayers deposited in vacuum onto self-assembled monolayer (SAM) systems serve as models for more complex metalized polymers. Metals (M) deposited onto SAMs with different organic functional end groups exhibit a wide range of behavior, ranging from strong chemical interactions with the end group to complete penetration of the metal through the SAM. In this work, we have characterized the interactions of Cu with the ---COOH of mercaptohexadecanoic acid (MHA, HOOC(CH₂)₁₅SH) SAMs self assembled on gold films by using X-ray photoelectron spectroscopy (XPS) to examine the chemical interactions, and a combination of XPS and ion scattering spectroscopy (ISS) to deduce the growth mode and penetration rate of the deposited Cu. We found that submonolayer amounts of Cu react with HOOC, whereas the rest of the Cu remains metallic and penetrates beneath the SAM surface to the SAM  Au interface. Considerable amounts of Cu (5 nm or more) will penetrate beneath the SAM layer, which is ca. 2.5 nm thick, despite the submonolayer presence of Cu at the SAM surface. The penetration rate depends strongly on the Cu deposition rate. Depositing copper onto MHA at 220 K or less, or using faster Cu deposition rates, results in slower or even completely suppressed penetration of the Cu through the SAM layer, whereas exposure to X-rays greatly enhances the penetration rate of large amounts of Cu through the SAM layer. The reacted copper is, based on the XPS 2p and LMM peaks, in the +2 oxidation state, but cannot be identified with a simple, stoichiometric oxide such as Cu₂O, CuO, or Cu (OH)₂.     

Crystallographic study of interaction between adspecies on metal surfaces

The interaction among adsorbed atoms and molecules (adspecies) on metal surfaces plays a decisive role in catalytic reactions. Such interaction may cause structural changes of the local adsorption geometry which, together with spectroscopic and energetic data, may afford useful physical and chemical insights into the basic mechanisms of surface processes. When the adsorption geometry of a single adspecies is considered as a function of coverage, a deeper understanding of the nature of the adsorbate-substrate bonding can be obtained. Depending on the adsorbate coverage, the magnitude of adsorbate-induced relaxations and reconstructions vary widely. Occasionally, chemisorption systems transform gradually into adsorbate-substrate compounds, such as oxides, nitrides, hydrides, and sulfides. For the case of adsorption of different adspecies, coadsorption, structural data can make a vital contribution to our understanding of reaction intermediates, the promotion effect in heterogeneously catalyzed reactions, and the formation of ultra-thin compound films.     

Methodical aspects in the surface analysis of supported molybdena catalysts

Supported molybdena catalysts, with TiO₂, CeO₂ and Al₂O₃ supports, were studied by XPS and ISS. It was found that reliable results are obtained only when samples are calcined and transferred into the ultrahigh vacuum system without further contact with the ambient atmosphere (‘in situ calcination’). This applies also to catalysts that were previously calcined but had been stored in the ambient atmosphere. Supported Mo oxide becomes reduced under x‐ray irradiation during extended XPS data acquisition. A slight decrease of the Mo/support cation intensity ratio as a consequence of this reduction was detected by ISS in MoO₃/TiO₂ and MoO₃/CeO₂, therefore ISS analysis should be performed on freshly calcined samples without prior extended exposure to x‐rays. Because ISS spectra change rapidly due to sputtering, a correct analysis of the surface properties of the supported Mo catalyst requires extrapolation of the trend to the start of the experiment. It was established by this methodology that the surface of a 7% MoO₃/TiO₂ catalyst (5.3 Mo nm^?2) is completely covered by a monolayer of Mo oxide species, and no Ti cation is exposed. In a submonolayer MoO₃/CeO₂ catalyst the exposed support could be detected, as expected, whereas in an MoO₃/Al₂O₃ catalyst with an Mo oxide loading equal to the monolayer coverage a slight exposure of the Al support cation also was noted probably because of the high curvature of the smaller Al₂O₃ particles. Copyright © 2004 John Wiley & Sons, Ltd.     

一类串联非线性系统的鲁棒控制

基于Lyapunov方法，讨论了一类带有不确定参数的不匹配非线性系统的鲁棒H∞问题，所讨论的这类系统由两个串联子系统组成，在讨率鲁棒H∞问题时，不确定参数属于巳知紧集且可非线性进入系统，不需解H-J-I偏微分方程，设计出一个非线静态反馈控制律，使闭环系统的L2增益对所有的容许不确定参数低于预先给定的值；进而，在一定条件下，闭环系统是ISS的。     

Influence of fibre extraction method,alkali and silane treatment on the interface of Agave americana waste HDPE composites as possible roof ceilings in Lesotho

Surface treatment is often necessary for strong composites. But the challenge for developing countries is to find chemicals and treatment procedures that are cheap and simple but maintain good composite properties. Mercerization followed by silane treatment of natural fibres is among the simplest and cheapest methods used to improve composite interfaces. This study investigates the effectiveness of this method to improve the bond between Agave americana fibres and post consumer HDPE. The influence of fibre extraction method, mercerization and mercerization followed by silane treatment on interfacial shear strength (ISS) and fibre properties is determined. The results indicate that ISS values are generally low but mercerization doubles the ISS values between Agave americana fibres extracted by traditional boiling of leaves and post consumer HDPE. Mercerization also improves fibre tensile and thermal properties. While triethoxyvinylsilane treatment of fibres after mercerization does not improve the ISS, it does not reduce it either, nor does it reduce tensile and thermal strengths of mercerized fibres. Fibres from non-boiled leaves resulted in poor fibre tensile strengths but improved ISS. There is a potential to use mercerization as cheap, simple technique to make Agave americana HDPE composites to provide cheap roof ceilings in Lesotho.     

Ionic conductivity of sodium beta″-alumina

Measurements of the electrical conductivity of Na ß″-alumina show that the low-temperature activation energies are 0.3337 ± 0.0055 eV for MgO stabilized crystals grown at 1700°C, 0.275 ± 0.015 eV for crystals with the same starting composition position grown at 1650°C, and 0.1716 ± 0.0093 eV for crystals stabilized with ZnO and grown at 1700°C. The conductivities of almost all crystals at 500°C were found to be 1.3 ± 0.6 Ω^?1 cm^?1. In addition to the growth conditions, the presence of a dc electric field, the type of electrode material, the type of conducting ion, and the concentration of stabilizing ion are important in determining the electrical conductivity. These factors are believed to affect the nature of the ordering of vacancies in the ß″-aluminas, leading to variations in the activation energy.