等离子体修饰磁载TiO2光催化剂性能研究

以化学共沉法制备的CoFe₂O₄纳米粒子为磁核,采用TiCl₄水解包覆技术制备磁载二氧化钛纳米复合粒子CoFe₂O₄ /TiO_x(TCF),利用低温等离子体技术修饰TCF制备了CoFe₂O₄/TiO₂(PTCF)纳米复合光催化剂。运用VSM(振动样品磁强计)技术对样品磁性能进行研究,结果表明：等离子体修饰后的复合材料仍具有较高的饱和磁化强度,可在外加磁场作用下实现催化剂在水中的分离与回收;样品的XRD、TEM和UV-Vis分析测试结果表明：等离子体修饰后的复合材料有锐钛矿型TiO₂存在;TEM谱图显示磁核CoFe₂O₄的平均粒径约为20 nm,TCF复合粒子的粒径约为30~40 nm,TiO₂包覆层的厚度为10~20 nm。与纯TiO₂相比PTCF样品对光的吸收拓展到整个紫外-可见区,扩大了光谱响应范围;对甲基橙溶液降解的光催化活性评价研究表明：TCF复合粒子等离子体修饰后的PTCF纳米复合光催剂的光催化活性明显提高。     

球磨法制备异质结型光催化剂ZnO/Bi_4Ti_3O_(12)及催化性能

本文用水作为分散介质,掺杂一定量的ZnO于Bi_4Ti_3O_(12)中,采用高能球磨法制备了异质结型光催化剂ZnO/Bi_4Ti_3O_(12).利用UV-Vis、XRD、SEM和PL等仪器对样品进行了分析与表征.以375 W中压汞灯为光源,通过对亚甲基蓝的氧化来研究其光催化活性.结果表明,对于光氧化亚甲基蓝(MB),异质结型光催化剂ZnO/Bi_4Ti_3O_(12)光催化活性高于钛酸铋的光催化活性.当ZnO的掺杂量分别是0.0和0.5wt.%,异质结型光催化剂ZnO/Bi_4Ti_3O_(12)对亚甲基蓝光氧化率分别达到50.2和80.3 %.     

Photo-electrochemical water splitting system with three-layer n-type organic semiconductor film as photoanode under visible irradiation

A three-layer structure of n-type organic semiconductors(PTCDA/PTCDA:PCBM/PCBM) is successfully identified as photoanode for photoelectrochemical water oxidation during the overall splitting of water into hydrogen/oxygen in a nearly stoichiometric ratio(H2:O2=2:1) under visible irradiation(λ > 420 nm).A possible charge separation mechanism under visible light illumination was also proposed.     

CuAlO2的合成及其复合催化剂的光催化性能

以硝酸铜和硝酸铝为原料,草酸为铜离子的沉淀剂,半湿法制得前驱体,再于氮气气氛下热处理形成了铜铁矿结构的CuAlO2。对样品进行热失重(TG),X射线衍射(XRD),紫外-可见漫反射(UV-Vis-DR)及透射电镜(TEM)表征分析,探讨了CuAlO2的形成过程。结果显示,随着热处理温度的升高,含铜物质经历了由CuO、Cu2O到CuAl2O4,再到CuAlO2的变化历程;制得的CuAlO2晶体结晶完整性较好,直接禁带宽度为3.1 eV左右。用沉淀复合的方法制备出了n-p异质复合型光催化剂WO3-CuAlO2、TiO2-CuAlO2和ZnO-CuAlO2,对复合催化剂进行了XRD和TEM表征分析,并测试了复合催化剂的光催化活性。结果表明,上述催化剂均由两种物相复合而成,且在紫外光的照射下均可分解纯水放出氢气。     

磁性可见光催化剂BiVO4/Fe3O4的制备及催化活性

采用超声法将磁基体Fe3O4和BiVO4复合,制备了易于固液分离的磁性可见光催化剂BiVO4/Fe3O4。采用X射线衍射(XRD)、傅立叶转换红外光谱(FTIR)、紫外-可见漫反射光谱(DRS)、透射电子显微镜(TEM)和磁学性质测量系统(MPMS)对产物进行了表征,并以亚甲基蓝为目标降解物,考察了BiVO4/Fe3O4的可见光催化活性。当BiVO4与Fe3O4质量比为5:1时,BiVO4/Fe3O4的催化活性最高,反应经过5 h,对亚甲基蓝的降解率达到92.0%,而单独使用BiVO4为催化剂,降解率仅为72.5%。这表明Fe3O4不仅起到磁基体的作用,还起到助催化剂的作用。BiVO4/Fe3O4在外加磁场的作用下很容易被分离,撤消外加磁场后,通过搅拌又可重新分散。BiVO4/Fe3O4 3次回收后的降解率仍高于80%。     

Heterogeneous continuous flow synthetic system using cyclohexane-based multiphase electrolyte solutions

The discovery that supporting electrolytes can be effectively confined in typical organic solvents in a c-Hex-based multiphase electrolyte solution has led to the development of a novel heterogeneous continuous flow synthetic system. PTFE fiber functions as a separation filter that can efficiently isolate the c-Hex phase from multiphase electrolyte solutions. This system has demonstrated both electrochemical solvating and carbon-carbon bond forming reactions. Hydrophobic substrates can be introduced into the reactor as c-Hex solutions, which are then electrochemically transformed into the target hydrophobic products that pass through the PTFE fiber as c-Hex solutions.     

Facile Fabrication of Platinum Nanoparticles Supported on Nitrogen-doped Carbon Nanotubes and Their Catalytic Activity

A facile impregnation method under mild condition is designed for synthesis of highly dispersed Pt nanoparticles with a narrow size of 4-7 nm on nitrogen-doped carbon nanotubes （CNx）. CNx do not need any pre-surface modification due to the inherent chemical activity. The structure and nature of Pt/CNx were characterized by X-ray diffraction, scanning electron microscopy, transmission electron microscopy and energy dispersive spectroscopy spectrum. All the experimental results revealed that the large amount of doped nitrogen atoms in CNx was virtually effective for capturing the Pt（IV） ions. The improved surface nitrogen functionalities and hydrophilicity contributed to the good dispersion and immobi- lization of Pt nanoparticles on the CNx surface. The Pt/CNx served as active and reusable catalysts in the hydrogenation of allyl alcohol. This could be attributed to high dispersion of Pt nanoparticles and stronger interaction between Pt and the supports, which prevented the Pt nanoparticles from aggregating into less active Pt black and from leaching as well.     

Active Pd/Fe(OH)x catalyst preparation for nitrobenzene hydrogenation by tracing aqueous phase chlorine concentrations in the washing step of catalyst precursors

By tracing the chlorine concentrations in the aqueous solutions containing the catalyst precursors, Pd/Fe(OH)_x catalysts with different activities can be controllably prepared. For the hydrogenation of nitrobenzene, the active Pd/Fe(OH)_x catalysts were obtained from aqueous solutions with chlorine concentrations below 18 ppm and above 8 ppm.     

氧化亚铜微/纳米结构的形貌可控制备及光催化和防污性能

利用简便易行的液相法,采用葡萄糖为还原剂,通过调整加料方式、反应温度、NaOH用量等条件,实现具有{110}截面八面体、八面体和短足形等形貌的Cu₂O微/纳米结构的可控制备,运用透射电子显微镜、扫描电子显微镜、紫外可见分光光度计等对产物进行组成、结构、形貌和光响应的表征,对Cu₂O的形貌结构和生长机理进行研究。对比和优化了具有不同形貌的Cu₂O微/纳米结构对甲基橙染料的光催化性能。将不同形貌的微/纳米Cu₂O作为防污剂复配的自抛光防污涂料,涂层磨蚀率、接触角与实海挂板实验证明该涂料具有良好的防污性能。     

Ru/CeO2催化剂催化苯乙烯氢甲氧基羰基化反应高选择性制备直链酯类化合物

酯类化合物在工业上具有广泛应用,例如可用于合成香水、调味剂(味精)、洗涤剂和表面活性剂等.其中,烯烃的氢烷氧基羰基化反应是一种合成酯类化合物的重要方法,其低消耗、100%的原子经济性和原料的易获得等优势使其在制备酯类化合物中成为一个有效且实际可行的方法.对于该反应,文献多采用Pd或Rh的络合均相催化剂,其中控制反应过程中直链酯类化合物(L)和支链酯类化合物(B)的选择性是一项颇具挑战性的课题.虽然目前可通过配体的设计和修饰来调节,但多集中在均相催化体系,因此在选择性调变方面的研究仍很欠缺.相对于均相催化,多相催化由于产物易分离和提纯、催化剂可循环使用等优势而逐渐引起了研究者的广泛关注.在多相催化体系中, Pd负载在强酸性树脂作为催化剂已被应用于苯乙烯氢甲氧基羰基化反应,但在该反应中支链酯类化合物为主要产物.因此,寻找一个可有效改善多相反应体系中选择性问题的方法是非常有意义的.在本研究工作中,我们分别以CeO2纳米颗粒(NP)、CeO2纳米棒(Rod)和CeO2纳米立方体为载体,利用浸渍法制备了Ru/CeO2、Ru/CeO2-rod和Ru/CeO2-cube三种催化剂,并进一步用于苯乙烯氢甲氧基羰基化反应.探究了CO压力、反应温度和反应时间对三种催化剂催化苯乙烯氢甲氧基羰基化反应的影响.结果表明, Ru/CeO2作为多相催化剂催化苯乙烯氢甲氧基羰基化反应时,苯乙烯选择性高于99%,直链酯选择性为83%,支链酯选择性为12%.机理研究表明,该反应为自由基机理.动力学分析表明,该反应的反应活化能为48.50 k Jmol^–1.结合三种催化剂的反应活性以及HRTEM结构表征结果可知,该反应中L/B比值与Ru的尺寸有较大关系.进一步的拉曼表征和NH3-TPD表征结果证明, Ru的尺寸与金属-载体之间的相互作用以及催化剂表面的氧空位浓度有直接关系.