Deactivation of silica surfaces with a silanol-terminated polysiloxane; structural sharacterization by inverse gas chromatography and solid-state NMR

Retention gape deactivated with Silicone OV-1701-OH show good chromatographic performance and remarkable stability against water induced stationary phase degradrdation. In an attempt to better understand the findamentals off the deactivation process using silanol terminated polysiloxanes, a fumed silica was deactivated with Silicon OV-1701-OH. In contrast to fused silic capillaries, fumed silica (Aerosil A-200) can be studied by ²⁹Si cross-polarization magic-angle-spinning (CPMAS) NMR, thus serving as a model substrate for fused silica. Retention data from inverse gas chromatography at infinite dilurion and ²⁹Si CP MAS NMR data of five Aerosil phases, differing in residual silanol surface concentration, are correlated with the aim of validating this approach for stationary phase characterization. A comparatively detailed model of the deactivating polymer layer that explains the observed absorption activities is deduced. Surface silanols are shown to play a key role in the polymer layer, the structure of which is of primary importance for the absorption behavior after deactivation. Contrary to common belief, the absolute silanol surface concentration after deativation is only of secondary importance for the overall absorption activity. High silanol surface concentrations enhance degradation of the polysiloxane chains into small cyclic fragments as well as subsequent absorption and immobolization to the silica substrate surface. The mobility of linear polysiloxane chains in the kHz regime (as determined bby NMR cross-polarization dynamics) appears to determine the extent which the residual silanols are accessible for analytes. It is therefore anticipated that there is an optimum silanol surface concentration of fused silica surfaces to be deactivated with silanol terminated polysiloxanes; it should be lazrge enough to adsord polymer fragments, but not large to avoid excessive residual silanol activity.     

All-glass open-split interface for capillary GC/MS

This paper describes a design for an all-glass GC/MS interface. The design has advantages due to low dead volume, lack of column effluent adsorption and degradation, simple interface production and installation, and ease of column mounting/dismounting.     

Chemical Constituents of the Essential Oil of <Emphasis Type="Italic">Nepeta oxyodonta</Emphasis>

Water-distilled essential oil from the aerial parts of Nepeta oxyodonta Boiss. was analyzed by GC/MS for the first time. Fifty-eight components were identified. The major components were (E)-caryophyllene (12.6%), spathulenol (8.5%), β-bourbonene (8.1%), germacrene-D (7.4%), α-cadinol (7.3%), germacrene-D-4-ol (6.8%), T-cadinol (5.6%), and caryophyllene oxide (5.3%).__________Published in Khimiya Prirodnykh Soedinenii, No. 2, pp. 141–142, March–April, 2005.     

On the statistical independence of various column contributions to band broadening. Part 1: Second moment contributions from statistically independent,longitudinal diffusion in both phases

The total length-based second moment contribution from longitudinal sample diffusion in both phases on a column, σD , is derived by adding individual partial differential contributions to a partial differential equation accounting for the longitudinal diffusion processes only. Although each diffusion-dispersed sample part is equilibrated between two phases, the resulting σ,D (= 2D _mt _m + 2D _st _s) can be interpreted as the sum of two independent contributions in accordance with the variance addition rule. (D _m and D _s are the mean diffusion coefficients and t _mand t _s the mean residence times of the sample in the mobile and stationary phases, respectively.) The same σD expression is derived from the random walk model of Giddings by treating the diffusional process in each phase as statistically independent of the other processes. Under these conditions the broadening contribution from longitudinal diffusion in the mobile phase is shown to be independent of the velocity profile.     

Fatty Acid Compositions of Seed Oils of Three Turkish <Emphasis Type="Italic">Salvia</Emphasis> Species and Biological Activities

The fatty acid composition of seed extracts of Salvia bracteata, S. aethiopis, and S. candidissima ssp. candidissima were analyzed by GC/MS. The main compound of S. bracteata, S. aethiopis, and S. candidissima ssp. candissima was found to be 9,12-octadecenoic acid at 64.3%, 73.4%, and 20.8%, respectively. The seed extracts of S. bracteata showed activity against S. aureus E. coli, M. smegmatis, and C. albicans with MIC values of 1.1, 0.5, 1.1, and 1.1 mg/mL, respectively, while the seeds extract of S. aethiopis showed activity against the same microorganisms with MIC values of 2.2, 2.2, 1.1, and 1.1 mg/mL, respectively. However, the seed extract of S. candidissima ssp. candidissima showed activity only against M. smegmatis with a MIC value of 0.25 mg/mL.__________Published in Khimiya Prirodnykh Soedinenii, No. 3, pp. 223–225, No. 3, May–June 2005.     

Determination of the sulfur components of gasoline streams by capillary column gas chromatography with sulfur chemiluminescence detection

A method using a sulfur chemiluminescence detector (SCD) has been developed for the qualitative and quantitative determination of sulfur components in stabilized gasoline-range process streams, including blended gasolines containing between 1 and > 4000 ppm total sulfur. The detection limit per sulfur component was approximately 50 ppb. On-column injection was employed for optimum precision and accuracy. A new probe material was found which did not soften under FID operating conditions. A new method, using a hydrogen sulfide permeation tube, was developed for rapid alignment of the probe in the FID.     

Ozone-based sulfur chemiluminescence detection: Its applicability to gas,supercritical fluid,and high performance liquid chromatography

The sensitive detection of sulfur-containing analytes is of interest in many industrial applications; selective detection is also desirable since these compounds are usually present at trace levels in difficult matrixes. The purpose of this article is to review the use of the Sievers® ozone-based sulfur chemiluminescence detector, and its coupling with gas chromatography, supercritical fluid chromatography, and high performance liquid chromatography. Detection limits, linearity, response factors, and selectivity are discussed for each of these techniques. Critical operational parameters for the SCD are also described. The use of other sulfur selective detectors for SFC and HPLC is also briefly summarized.     

Rapid analysis of free medium-chain fatty acids and related ethyl esters in beer using SPE and HRGC

A modification of a procedure by Hage [1] is proposed for the gas chromatographic evaluation of the content of free medium-chain fatty acids and related ethyl esters in beer. The method involves extraction of free fatty acids and ethyl esters by SPE using C₁₈ bonded phase columns, derivatization of free fatty acids and related ethyl esters with diazomethane, and GC analysis using an SP-2340 capillary column. The results obtained have shown the method to be rapid and highly reproducible. The technique has been compared with other methods used for determination of free fatty acids.     

Chemical Composition of the Essential Oil of Rosmarinus officinalis Cultivated in the Algerian Sahara

The volatile compounds obtained by hydrodistillation of the aerial parts of Rosmarinus officinalis cultivated at the Algerian Sahara were analyzed by GC/MS. Thirty compounds were characterized representing 98.2% of the essential oil with 1,8-cineole (29.5%), 2-ethyl-4,5-dimethylphenol (12.0%) and camphor (11.5%) as the major components.     

Dicholorbenzyl alkyl ether homologs as retention index markers and internal standards for the analysis of environmental samples using capillary gas chromatography

A homologous series of 2,4-dichlorobenzyl alkyl ethers (DCBEs) have been synthesized and purified for use as retention index calibrants and internal standards. They are stable, sensitive to ECD and FID and ideal for GC-MS, with base peaks at m/z 159/161. The retention index calibration against the n-alkanes for a linear temperature program (LTP) series is given and recommendations made for the most suitable members of the DCBE series for use as internal standards in organochlorine (OC) residue analysis.