Frequent analytical/experimental problems in lipase-mediated synthesis in solvent-free systems and how to avoid them

Compared with chemical catalysis, enzymatic catalysis is a relatively new topic. Experimental work involving lipases deserves careful attention and accurate procedures still need to be implemented. A rapid but careful survey of published data immediately demonstrates that experiments performed under similar conditions with similar reagents have led to very different results. The aim of this work is to point out the importance of accurate and systematic procedures in order to ensure the reproducibility of experimental data. We strongly believe that different results found by different labs are due to problems detected in the procedures used. Quantification of the immobilisation efficiency of lipase on several supports through UV/visible methods and sampling methods used to obtain correct enzymatic activity values are specifically analysed. After a brief review which demonstrates the big discrepancies found in the literature, original data from Candida rugosa lipase adsorption on polypropylene powder and its use in the solvent-free synthesis of ethyl oleate are introduced in order to exemplify the difficulties found in these kinds of systems. Several procedures described in the literature are assayed and the accuracy of the results obtained is carefully analysed. The aim of the whole analysis performed is that it would be useful for any powdered solid to be used as a support for a lipase in a solvent-free system for any synthesis reaction, especially for those involving a volatile reagent. Throughout this contribution, special emphasis is placed on how catalytic reaction results using enzymes (free and immobilised) are reported so as to allow comparison between published data, something which is usually difficult since very different units are used and often complementary data are not included.     

Preparation of apolar glass capillary columns by the barium carbonate procedure

As an extension of previous reports, the barium carbonate procedure has been optimized in detail for the preparation of apolar columns. The aim was to produce optimum overall column characteristics, and to maintain them unchanged under the prolonged influence of the highest possible temperature. The main parameters under optimization were glass variety, leaching of glass surface with aqueous HCl, and amount of barium carbonate deposited, while deactivation and coating were kept constant. The basic column characteristics were adsorption properties and thermostability of deactivation, acid/base behaviour and separation efficiency. They were determined by a new, quantitative testing procedure. Intense leaching was able to eliminate almost totally the differences between glass varieties and to create a well-defined glass surface. While untreated glass, leached glass, and barium carbonate treated glass showed specific weak points in the respective column quality, the combination of leaching and barium carbonate treatment yielded the highest and most stable quality. Some technical modifications of the preparation procedure are described, including deactivation in the gas phase, and use of pentane as a solvent for static coating.     

Capillary gas chromatography of pesticide residues in foods: Application of a split/splitless inlet system

Residue mixtures of pesticides in foods which were difficult to separate by packed-column gas chromatography were determined by capillary gas chromatography and electron capture detection. Manual injections of sample and reference standard were made with a 10 μL syringe on a septum-enclosed, split/ splitless inlet system. Optimal peak height repeatability (± 3%( was achieved with three-μL injections which were made within time periods of four hours or less. The average linearity coefficient (slope( obtained for detector response as a function of solution concentration was 1.1.     

Electron kinetics of collision dominated r.f. bulk plasma in CO: The role of second-kind collisions

Electron energy distribution functions (EEDF) and related properties in the bulk region of the rf CO plasma at the reduced rf field frequency /p₀=×10⁷ sec^–1 torr^–1 have been calculated by solving the time-dependent spatially homogeneous Boltzmann equation in the presence of second-kind collisions and have been interpreted on a microphysical basis. The results show that second-kind collisions (vibrational and electronic) strongly affect the temporal evolution of EEDF, of the mean energy, and of the mean collision frequencies for vibrational and electronic excitation processes, as well as for ionization. In particular, second-kind collisions in the CO rf bulk plasma strongly decrease the modulation of the mean ionization frequency during its periodical alteration in the rf field. Furthermore, the effect of second-kind collisions on an approximate determination of the time-averaged EEDF in the rf bulk plasma using the so-called effective-field appriximation has been estimated.     

皮革中六价铬含量的IUC-18测定法

Ｃｒ(ＩＩＩ)是制革业最重要的鞣剂 ,制革业所用的Ｃｒ(ＩＩＩ)鞣剂由Ｃｒ(ＶＩ)还原而得到。皮革中除Ｃｒ(ＩＩＩ)外 ,还可能含有微量的Ｃｒ(ＶＩ) ,目前欧盟等国要求Ｃｒ(ＶＩ)的含量小于 5ｍｇ/ｋｇ[1 ] ;国内则还没有分析测定皮革中六价铬的国家标准 ,本文介绍六价铬的ＩＵＣ - 1 8国际标准分析方法 (ＩＵＣ ,Ｉｎｔｅｒ ｎａｔｉｏｎａｌＵｎｉｏｎｏｆＣｈｅｍｉｓｔｒｙ) ,并分析了该方法的不足及改进途径。1　实验部分ｐＨ7 5～ 8 0、惰性气体保护下用磷酸盐缓冲溶液浸取皮革的六价铬 ,六价铬将 1 ,5 二苯卡巴肼氧化为 1 ,5 二苯…     

The preparation of thick-film glass capillary columns

A detailed method for the routine preparation of glass capillary columns is presented. The method consists of coating a glass tube with quartz powder prior to pulling the tube into a capillary. The inner surface of the capillary consists of an even distribution of quartz particles fused to the walls. This surface has been found readily deactivated by standard procedures and ideal for the preparation of thick-film glass capillary columns. The method has been thoroughly tested in two independent laboratories to ensure that the procedures described are reproducible.     

技能映射通过析取模型诱导的多分知识结构

基于程序性知识的评估,提出由项目自身的状态结构诱导多分知识结构的方法,以建立适用于问题解答的多分评估体系.首先,根据各项目的解答或操作步骤设定响应值集,通过项目状态转移函数定义项目状态空间;然后,用操作程序表示技能,由过程函数导出析取的技能映射;最后,讨论技能映射通过析取模型诱导的多分知识结构.结果表明：技能映射通过析取模型诱导的多分知识结构是多分知识空间.     

The Newton modified barrier method for QP problems

The Modified Barrier Functions (MBF) have elements of both Classical Lagrangians (CL) and Classical Barrier Functions (CBF). The MBF methods find an unconstrained minimizer of some smooth barrier function in primal space and then update the Lagrange multipliers, while the barrier parameter either remains fixed or can be updated at each step. The numerical realization of the MBF method leads to the Newton MBF method, where the primal minimizer is found by using Newton's method. This minimizer is then used to update the Lagrange multipliers. In this paper, we examine the Newton MBF method for the Quadratic Programming (QP) problem. It will be shown that under standard second-order optimality conditions, there is a ball around the primal solution and a cut cone in the dual space such that for a set of Lagrange multipliers in this cut cone, the method converges quadratically to the primal minimizer from any point in the aforementioned ball, and continues, to do so after each Lagrange multiplier update. The Lagrange multipliers remain within the cut cone and converge linearly to their optimal values. Any point in this ball will be called a hot start. Starting at such a hot start, at mostO(In In ^-1) Newton steps are sufficient to perform the primal minimization which is necessary for the Lagrange multiplier update. Here, >0 is the desired accuracy. Because of the linear convergence of the Lagrange multipliers, this means that onlyO(In ^-1)O(In In ^-1) Newton steps are required to reach an -approximation to the solution from any hot start. In order to reach the hot start, one has to perform Newton steps, wherem characterizes the size of the problem andC>0 is the condition number of the QP problem. This condition number will be characterized explicitly in terms of key parameters of the QP problem, which in turn depend on the input data and the size of the problem.Partially supported by NASA Grant NAG3-1397 and National Science Foundation Grant DMS-9403218.     

ORACLE SQL* FORMS主从块设计

介绍在ＯＲＡＣＬＥＳＱＬ＊ＦＯＲＭＳ中快捷且灵活地建立主从关系的一种方法．     

藏产红景天混合提取物对BALB／c小鼠免疫功能的影响

选择淋巴器官脏器系数,迟发型变态反应,脾脏抗体生成细胞数,巨噬细胞蚕噬指数等免疫免疫学指标观察藏产多种红景天对ＢＡＬＢ／ｃ小鼠免疫功能的影响。结果表明,在５００－２０００ｍｇ／ｋｇ剂量范围内能增加ＢＡＬＢ／ｃ小鼠胸腺的相对重量,足跖厚度及脾脏抗体生成细胞的数量。