Photophysics of 9-aminoacridinium hydrochloride

The steady state and time domain spectroscopy of 9-aminoacridinium hydrochloride have been studied. 9-aminoacridine (I), 9-aminoacridinium (II) and the double protonated ion (III) follow Waterman’s principle with respect to their spectra and lifetimes. It is established that the excimer formation in (II) is from the ground state dimers which undergo either thermally-activated radiationless excimer conversion or a geometrical rearrangement in the excited state at room temperature. The quenching of monomer emission by dimers or foreign quenchers (KI) is found to be of transient nature as suggested by the continuum model. The authors felicitate Prof. D S Kothari on his eightieth birthday and dedicate this paper to him on this occasion.     

On the response of LR-115 plastic track detector to 10 20 Ne-ion

The track etch rates of ₁₀ ²⁰ Ne-ion in cellulose nitrate (LR-115) have been measured for different temperatures and the activation energy is determined. The experimental results show that both the track etch rate and the normalized track etch rate depend on the energy loss as well as on etching temperature. The maximum etched track length of ₁₀ ²⁰ Ne-ion agrees with the theoretically computed range. The experimental results show that there is no sharp threshold, at least in CN(LR-115).     

稀土对小麦（Triticum aestivum）体内光合和呼吸速率及磷酸化功能的影响

以适当浓度稀土溶液处理小麦后，其光合和氧化磷酸化的磷氧比（Ｐ／Ｏ）、光合控制（Ｐｃ）、呼吸控制（ＲＣ）、状态３．４光合和呼吸速率（Ｓ３．Ｓ４）与对照样比均无显著性差异。状态２（Ｓ２）光合和呼吸速率提高，差异极显著。说明小麦用最适浓度稀土处理后，对其光合和呼吸的磷酸化机构和功能膜影响不大，但显著促进了光合和呼吸速率（Ｓ２），从而促进了电子传递链的活性，使ＡＴＰ形成量增加。     

α—萘酚胁迫对普通小球藻生长及抗氧化酶活性的影响

研究了α－萘酚对普通小球藻的生长、光合色素的MDA含量及抗氧化酶9SOD、CAT、POD）活性的影响,结果表明,随着α－萘酚浓度的升高,藻的生长速率、叶绿素a与类胡萝卡素的含量,SOD、CAT、POD活性均先升高后下降,除POD活性在5．00mg.L^－1时达到最大值外,其余均在2．00mg.L^-1达到最大,而在α－萘酚浓度低于2．00mg.L^-1时,MDA含量变化不大,只有当3种抗氧化酶活性呈不同的下降后,MDA含量才急剧上升,膜脂过氧化加剧,说明α－萘酚导致普通小球藻膜脂过氧化是其致毒机制之一,而抗氧化酶在一定污染物浓度范围内具有防御保护作用。     

离子注入剂量与酒精酵母存活率关系研究

研究了以低能离子注入为手段,来选育斯托尔酒精酵母。在此过程中,如何确定最佳的出发菌株注入时间和限定干燥时间,对所获得的离子注入剂量与酒精酵母存活率关系曲线进行了讨论。     

对卫星近日点旋进现象的分析——"地球的扁率对卫星运动的影响"一文的疏忽

指出了一篇相关文献中的疏漏,讨论了卫星近日点的旋进现象,得出了在一般情况下卫星近日点旋进的快慢程度与近日点本身所处的位置有关的结论.     

Equivalent cross-relaxation rate imaging positively correlates with pathological grade and cell density of adipocytic tumors

Objective

Equivalent cross-relaxation rate imaging (ECRI) is an MRI technique used to evaluate qualitative changes in protein-water interactions. We aimed to prospectively evaluate the utility of ECRI for classification of adipocytic tumors.

Materials and Methods

Institutional Review Board approval was obtained and all patients provided informed consent. Study participants included 40 patients with adipocytic tumors who were diagnosed with lipomas (n = 22), atypical lipomatous tissue/well-differentiated liposarcoma (ALT/WDL; n = 9), myxoid/round cell liposarcoma (MyL; n = 6), and dedifferentiated liposarcoma (DDL; n = 3), and 20 control patients for whom subcutaneous fat in the buttock or thigh was analyzed.

Results

Mean ECR values of lipomas, ALT/WDL, and subcutaneous fat were low, and those of MyL and DDL were high. Mean ECR values of MyL and DDL were significantly higher than those of ALT/WDL. The cut-off value was 5.1%. There was a positive correlation between ECR value, pathological grade, and cell density in adipocytic tumors.

Conclusion

The ECR value positively correlates with pathological grade and cell density of adipocytic tumors. Our findings suggest that ECRI is a useful method for preoperative evaluation of adipocytic tumors.     

A robust adaptive hybrid feedback cancellation scheme for hearing aids in the presence of outliers

It has been demonstrated that the Filtered-x Wilcoxon LMS (FxWLMS) based adaptive filter mitigates the effect of the outliers acquired by the microphone signal of hearing aids by minimizing the Wilcoxon norm and hence shows better cancellation performance than the existing Filtered-x LMS (FxLMS) algorithm. The prediction error method based adaptive feedback canceller (PEMAFC) reduces the bias present in the estimate of the feedback path due to the continuous adaptive filtering (CAF). However, the impulse response of the measured feedback path is close to zero for the first many samples due to the delay introduced by ADC converters and then contains few significant values, which results in slow convergence rate when an adaptive filter is used to model the same. To overcome this limitation, we propose a proportionate normalized WLMS (PNWLMS) algorithm based PEMAFC (P-PNWLMS) for feedback cancellation in hearing aid in the presence of outliers. Further, with an objective to improve the convergence rate and performance accuracy simultaneously, this paper proposes a novel convex PNWLMS (CPNWLMS) algorithm which incorporates convex combination of PNWLMS and WLMS algorithms. The weight update equations are derived for PEMAFC trained by PNWLMS (P-PNWLMS) and CPNWLMS (P-CPNWLMS) algorithms respectively. The results of the simulation study show improved performance of the proposed CPNWLMS based adaptive filter over its component filters.     

Strain rate effects on compressive behavior of covalently bonded CNT networks

In this study, strain rate effects on the compressive mechanical properties of randomly structured carbon nanotube (CNT) networks were examined. For this purpose, three-dimensional atomistic models of CNT networks with covalently-bonded junctions were generated. After that, molecular dynamics (MD) simulations of compressive loading were performed at five different strain rates to investigate the basic deformation characteristic mechanisms of CNT networks and determine the effect of strain rate on stress–strain curves. The simulation results showed that the strain rate of compressive loading increases, so that a higher resistance of specimens to deformation is observed. Furthermore, the local deformation characteristics of CNT segments, which are mainly driven by bending and buckling modes, and their prevalence are strongly affected by the deformation rate. It was also observed that CNT networks have superior features to metal foams such as metal matrix syntactic foams (MMSFs) and porous sintered fiber metals (PSFMs) in terms of energy absorbing capabilities.