集成有源负载放大器的研究

本文重点介绍了集成有源负载放大器的分析方法,并以镜像电流源为例详细介绍、对比了两种方法(图解分析法和微变等效电路分析法)。此外,介绍了用厄雷电压计算 Av 的简便方法。     

一种漂移室定位子性能反常现象的研究

研究了一种漂移室定位子性能的反常现象,它关系到定位子的使用寿命．着重测量了暗电流和随机噪声与时间、高压及温度的关系.     

Electrochemistry of capillary systems with narrow pores. IV. Dialysis potentials

The dialysis potentials of different collodion membranes with graded pore sizes and electrochemical activities have been measured in dilute aqueous KCl solutions as functions of concentration. It is possible to predict the value of the diffusion potential within a few millivolts on the basis of electrical conductivity data obtained with the same membranes. In general, the measured values are lower than those calculated. It is assumed that this difference is caused by the membranes having a distribution of pore sizes.     

Simple power supply for power load controlled isoelectric focusing

The power supply for IEF based on features of the Cockcroft‐Walton voltage multiplier (CW VM) is described in this work. The article describes a design of the IEF power supply, its electric characteristics, and testing by IEF analysis. A circuit diagram of the power supply included two opposite charged branches (each consisting of four voltage doublers). The designed CW VM was powered by 230 V/50 Hz alternate current and it generated up to 5 kV and 90 mW at the output. Voltage and current characteristics of the power supply were measured by known load resistances in the range from 10 kΩ to 1 GΩ, which is a common resistance range for IEF strip geometry. Further, the power supply was tested by a separation of a model mixture of colored pI markers using a 175 × 3 × 0.5 mm focusing bed. Automatically limited power load enabled analysis of samples without previous optimization of the focusing voltage or electric current time courses according to sample composition. Moreover, the developed power supply did not produce any intrinsic heat and was easy to set up with cheap and commonly available parts.     

聚3-己基噻吩：非富勒烯太阳能电池中的量子效率损失和电压损失

聚3-己基噻吩(P3HT)以其合成工艺简单、成本低廉的优势,成为有机光伏领域中最具吸引力的电子给体材料之一。然而,目前P3HT: 非富勒烯太阳能电池的光伏性能仍然较差。在本工作中,我们证明了与P3HT: 富勒烯太阳能电池相比,较快的电荷转移态的非辐射衰减速率(K_nr)是导致P3HT: 非富勒烯太阳能电池中较低的量子效率和较高的电压损失的原因。然后,我们研究了基于非富勒烯受体ZY-4Cl的太阳能电池的工作机理。研究结果表明与P3HT: 非富勒烯体系相比,P3HT: ZY-4Cl中K_nr的降低改善了器件的量子效率,同时降低了电压损失。K_nr降低的原因可以部分归因于电荷转移态能量的增加。此外,给体分子和受体分子之间的距离(DA间距)的增大也是K_nr减少的重要原因。因此,我们得出结论：为了提高P3HT太阳能电池的性能,需进一步降低器件的K_nr,这可通过增加活性层中的DA间距来实现。     

Toward low-voltage dielectrophoresis-based microfluidic systems: A review

Dielectrophoretically driven microfluidic devices have demonstrated great applicability in biomedical engineering, diagnostic medicine, and biological research. One of the potential fields of application for this technology is in point-of-care (POC) devices, ideally allowing for portable, fully integrated, easy to use, low-cost diagnostic platforms. Two main approaches exist to induce dielectrophoresis (DEP) on suspended particles, that is, electrode-based DEP and insulator-based DEP, each featuring different advantages and disadvantages. However, a shared concern lies in the input voltage used to generate the electric field necessary for DEP to take place. Therefore, input voltage can determine portability of a microfluidic device. This review outlines the recent advances in reducing stimulation voltage requirements in DEP-driven microfluidics.     

A study of threshold switching of NbO2 using atom probe tomography and transmission electron microscopy

Threshold switching is a phenomenon where the resistivity of an insulating material changes and the insulator exhibits metallic behavior. This could be explained by phase transformation in oxide materials; however, this behavior is also seen in amorphous insulators. In this study, through an ex-situ experiment using transmission electron microscopy (TEM), we proved that threshold switching of amorphous NbO₂ accompanies local crystallization. The change in I–V characteristics after electroforming was examined by evaluating the concentration profile. Atom probe tomography (APT) combined with in-situ TEM probing technique was performed to understand the threshold switching in amorphous NbO₂. The local crystallization in amorphous NbO₂ was validated by the observed difference in time-of-flight (ToF) between amorphous and crystalline NbO₂. We concluded that the slower ToF of amorphous NbO₂ (a-NbO₂) compared with crystalline NbO₂ (c-NbO₂) is due to the resistivity difference and trap-assisted recombination.     

Investigation of the performance of bipolar transverse plate ESP in the sintering flue control

In order to improve the particle collection efficiency of the electrostatic precipitator (ESP), a transverse plate ESP with bipolar discharge electrodes is proposed. The simulations of the velocity distribution have shown that when the inlet velocity is 1 m/s, within the range of 40 mm from electrode plate, the average velocities of windward side and leeward side are less than 0.7 m/s and 0.3 m/s respectively. It is clear that the velocity near the collection electrode plate of this bipolar ESP is much lower than that of the ordinary ESP at the same inlet velocity. This low velocity can lead to higher efficiency for fine dust collection due to the less dust re-entrainment in ESP. It is also found that the average velocities are getting lower when the distance between plates electrodes are greater than 150 mm in accordance with the simulations. The voltage current characteristics of the bipolar ESP are superior to the ordinary ESP. The pressure drop of the bipolar ESP is about 30% higher than that of the ordinary one. The dust penetration of the bipolar ESP is about 54% less than that of the ordinary ESP when the sintering dust with 25.405 μm mass median diameter is used as the test particulate under the condition of the electric field from 2.1 kV/cm to 3.2 kV/cm and the velocity from 1.0 m/s to 1.5 m/s.     

基于电源电流和输出电压的模拟电路故障模型研究

基于模拟电路电源电流和输出电压的协同分析,研究了复数域的故障建模方法,提出了一种2D故障模型的数学表达式,该模型为复平面上的一簇圆轨迹。为了扩大故障轨迹之间的距离,在相同测量精度和元件容差条件下提高故障检测率和隔离率,进一步提出了3D复数空间的优化故障模型。两种故障模型都极大简化了测点选择算法和模拟故障状态仿真的复杂度,理论上对模拟电路单故障的覆盖率为100%。基于滤波器电路的实验仿真结果验证了两种故障模型的有效性。     

天气雷达天线伺服控制系统中PWM保护电路的设计

介绍了天气雷达天线伺服控制系统中直流PWM泵升电压电路限制技术,泵升电压形成的原理以及泵升电压限制电路的原理,并结合工程设计中具体的直流PWM天线伺服控制系统对泵升电压限制电路的参数进行了详细的计算.较好的解决了供电电源的"泵升电压"对直流PWM伺服系统影响.实际应用表明,该天线伺服控制系统PWM保护电路设计是合理、成...