Cl/HN3/I2全气相化学激光体系的化学动力学模拟计算

 对Cl/HN₃/I₂产生NCl(a)/I激光的过程进行了化学动力学计算，主要考察了Cl,HN₃和I₂的初始粒子数密度及其配比对小信号增益系数的影响。结果发现,当温度为400K, 初始Cl粒子数密度为1×10¹⁵，1×10¹⁶和1×10¹⁷cm^-3时,小信号增益系数分别达到1.6×10^-4,1.1×10^-3和1.1×10^-2cm^-1，获得最佳小信号增益系数的HN₃和I₂的初始粒子数密度分别为初始Cl粒子数密度的1～2倍和2%～4%。同时，对Cl，HN₃和I₂配比对小信号增益系数和增益持续时间的影响进行了讨论。     

采用空心阴极放电等离子体化学气相沉积方法制备a-CH薄膜

 研究了不同衬底-阴极距离、直流电压和H₂流量对a-CH薄膜沉积速率的影响。结果表明：衬底-阴极距离必须大于0.5cm，随着该距离的增加，薄膜的沉积速率减少；直流电压达550V时沉积速率最大；随着H2含量的增加，CH₄含量相对减少，沉积速率随之降低。用AFM观察了以该方法制得的448.4nm CH薄膜的表面形貌，表面粗糙度约为10nm。最后测出了不同条件下CH薄膜的UV-VIS谱，由此可以计算得到薄膜的禁带宽度及折射率。     

Determination of residual monomers in acrylate dispersions by gas chromatography

The content of residual monomers is one of the most important characteristics of polymer dispersions. As a result of the similar physicochemical parameters of ethyl acrylate and methyl methacrylate, it is very difficult to determine the residual monomers in acrylate dispersions obtained by emulsion polymerization of both monomers. Gas chromatography with capillary columns, however, permits separation of these monomers and their quantitative determination in acrylate dispersions.     

Rapid and reproducible capillary electrophoretic separation of double-stranded DNA fragments in a simple methyl cellulosic sieving system

Summary A rapid, robust and reproducible method providing excellent separation performance and simplicity using a 0.5% MC-4000 methyl cellulosic sieving medium in DB-1 coated capillaries has been developed. The method is suitable for qualitative comparison of DNA restriction profiles for fragments in the size range 100–1000 base pairs (bp). Efficiencies up to 8.5 million plates/m (1057 bp fragment) were recorded. Peak resolution of 6 bp (291/297 bp, 335/341 bp) and 4 bp (238/242 bp, 341/345 bp) was achieved. In addition, 1 bp partial resolution of 123/124 bp and 298/297 bp was obtained. Run-to-run (n=15), day-to-day (n=4), and capillary-to-capillary (n=3) variations of 0.1–0.2% RSD, 0.3–0.5% RSD, and 0.1–0.3% RSD, respectively, were observed. The MC-4000 sieving matrix was found to be better than hydroxypropyl methyl cellulose and hydroxypropyl cellulose, in terms of both performance and stability in the DB-1 coated capillaries. The efficiency and resolution in DB-WAX capillaries were inferior to those obtained in DB-1 capillaries. The commercially available DB-1 capillaries were stable for months in the sieving medium at pH 8.3 and could be regenerated to provide high efficiency after accidental current breaks.     

保健酒中淫羊霍苷成分的分析研究

采用高效液相色谱法对某保健酒中淫羊藿苷成分进行分析研究,结果表明,保健酒中淫羊藿苷的平均含量为0.627％,平均回收率为98.1％,相对标准差（RSD）为2.1％.本分析方法也适用于其他保健酒、药材和药品中淫羊藿苷成分的分析测定.     

射流式单重态氧发生器研究

单重态氧O2 (a1Δg)是迄今唯一能用纯化学反应高效产生的具有长寿命的亚稳激发态分子 .为了考察提出的用两个O2 (1Δ)能量汇集反应生成氧第二单重激发态O2 (b1Σ+ g)以实现近可见短波长化学激光方案的现实性 ,设计和实验了一个氯流量为 3～ 10mmol/s的射流式单重态氧发生器 (JSOG) .考察了三种具有不同孔径和孔数目的喷头、氯气流量和脱水冷阱温度等对JSOG出口的O2 (1Δ)浓度、O2 (1Δ)分压、氯利用率及水蒸气含量的影响 .发现用聚氯乙烯管作冷阱时 ,最佳冷阱介质温度为 - 140～ - 15 0℃ ,对此提出了O2 (1Δ)表面脱活与脱水互相竞争的解释 .在最佳条件下 ,可将O2 (1Δ)气中水分压降低至 4Pa ,这一结果是首次报导     

On practical metrology and chemical analysis: etalons and traceability systems

 National measurement systems are infrastructures to ensure, for each nation, a consistent and internationally recognised basis for measurement. Such complex systems have historical, technical, legal, organisational and institutional aspects to connect scientific metrology with practical measurements. Underlying any valid measurement is a chain of comparisons linking the measurement to an accepted standard. The ways the links are forged and the etalons (measurement standards) to which they connect are defining characteristics of all measurement systems. This is often referred to as traceability which aims at basing measurements in common measurement units – a key issue for the integration of quantitative chemical analysis with the evolving physical and engineering measurement systems. Adequate traceability and metrological control make possible new technical capabilities and new levels of quality assurance and confidence by users in the accuracy and integrity of quantitative analytical results. Traceability for chemical measurements is difficult to achieve and harder to demonstrate. The supply of appropriate etalons is critical to the development of metrology systems for chemical analysis. An approach is suggested that involves the development of networks of specialised reference laboratories able to make matrix-independent reference measurements on submitted samples, which may then be used as reference materials by an originating laboratory using its practical measurement procedures. Received: 31 July 1995 Accepted: 19 August 1995     

地方性氟中毒流行病及在我国的流行特征

地方性氟中毒是一种在全球流行的地方病。本文介绍了其概念、研究史和研究现状,探讨了地氟病的病理学特征及病区的成因,并初步分析了地氟病在人群中的分布规律及在我国的地理流行特征。     

裂解气相色谱质谱法研究增塑剂邻苯二甲酸二甲酯的热降解机理

用裂解气相色谱-质谱联用方法研究了橡胶产品中使用的增塑剂邻苯二甲酸二甲酯(DMP)在不同温度条件下的热裂解行为.对不同温度条件下裂解产物的分析表明,在初始阶段DMP的裂解产物主要为二氧化碳、苯、甲苯和苯甲酸甲酯.随着温度的升高苯甲酸甲酯进一步裂解成为分子质量更小的自由基,并发生稠环化反应形成更稳定的菲、蒽、间-联三苯、三亚苯等芳香族多环化合物.根据分析实验提供的裂解产物信息和有机物热裂解化学反应的原理对DMP的热裂解反应机理作了探讨,表明在废旧合成橡胶热裂解回收过程中,增塑剂DMP的高温裂解会产生多环芳烃污染物.应选择合适裂解工艺和裂解温度,以减少对环境的污染.