Feasibility of using solid sampling graphite furnace atomic absorption spectrometry for speciation analysis of volatile and non-volatile compounds of nickel and vanadium in crude oil

A method for the direct determination of volatile and non-volatile nickel and vanadium compounds in crude oil without previous treatment using direct solid sampling graphite furnace atomic absorption spectrometry is proposed. The crude oil samples were weighed directly onto solid sampling platforms using a microbalance and introduced into a transversely heated solid sampling graphite tube. In previous work of our group losses of volatile nickel and vanadium compounds have been detected, whereas other nickel and vanadium compounds were thermally stable up to 1300 and 1600 °C, respectively. In order to avoid this problem different chemical modifiers (conventional and permanent) have been investigated. With 400 μg of iridium as permanent modifier, the signal started to drop already after two atomization cycles, possibly because of an interaction of nickel (which is a catalyst poison) with iridium. Twenty micrograms of palladium applied in each determination was found to be optimum for both elements. The palladium was deposited on the platform and submitted to a drying step at 150 °C for 75 s. After that the sample was added onto the platform and submitted to the furnace program. The influence of sample mass on the linearity of the response and on potential measurement errors was also investigated using four samples with different nickel content. For the sample with the lowest nickel concentration the relationship between mass and integrated absorbance was found to be non-linear when a high sample mass was introduced. It was suspected that the modifier had not covered the entire platform surface, which resulted in analyte losses. This problem could be avoided by using 40 μL of 0.5 g L⁻¹ Pd with 0.05% Triton X-100. Calibration curves were established with and without modifier, with aqueous standards, oil-in-water emulsions and the certified reference material NIST SRM 1634c (trace metals in residual fuel oil). The sensitivity for aqueous standards and emulsions was close to that for SRM 1634c, making possible the use of aqueous standards for calibration. The limits of detection and quantification obtained for nickel and vanadium under this condition were found to be 0.02 and 0.06 μg g⁻¹, respectively, for both elements, based on 10 mg of sample. Nickel and vanadium were determined in the samples with (total Ni and V) and without the use of Pd (thermally stable compounds), and the concentration of volatile compounds was calculated by difference. The results were compared with those obtained by high-resolution continuum source graphite furnace atomic absorption spectrometry by emulsion technique; no significant differences were found for total Ni and V at the 95% confidence level according to a Student's t-test.     

Essential Oil of Arischrada korolkowii from the Chatkal Mountains of Uzbekistan

The herbal parts of Arischrada korolkowii (Regel et Schmalh.) Pobed. (Lamiaceae) growing in Uzbekistan were hydrodistillated to yield 1.1% of essential oil. The essential oil was analyzed by GC/MS. Eighty eight compounds were characterized representing 98% of the essential oil with 1,8-cineole (29.3%), camphor (9.8%), -caryophyllene (8.5%), bornyl acetate (7.7%), caryophyllene oxide (7.2%), and borneol (5.6%) as the main constituents.     

Identification of a chemical indicator of the rupture of 1,4-β-glycosidic bonds of cellulose in an oil-impregnated insulating paper system

In this study, headspace gas chromatography/mass spectrometry has been used to assess the volatile by-products generated by the ageing of oil-impregnated paper insulation of power transformers. Sealed-glass ampoules were used to age under oxidative conditions 0.5-g specimens of insulating paper in 9 mL of inhibited mineral oil in a temperature range of 60–120 °C and moisture of 0.5, 1 and 2% (w/w). A linear relationship between one of the oil-soluble degradation by-products, i.e. methanol, and the number of ruptured 1,4-β-glycosidic bonds of cellulose, regardless of the type of paper (ordinary Kraft or thermally-upgraded (TU) Kraft paper), was established for the first time in this field. Ageing at 130 °C of model compounds of the Kraft paper constituents (α-cellulose, hemicellulose and lignin) and two cellulosic breakdown by-products (D-(+)-glucose and 1,6-anhydro-β-d-glucopyranose) confirmed that the α-cellulose degradation was mostly responsible for the presence of this molecule in the system. Furthermore, additional 130 °C-tests with six different papers and pressboard samples under a tight control of initial moisture indicated that at least one molecule of methanol is formed for each rupture of 1,4-β-glucosidic bond of the molecular chains. Stability tests showed that the ageing indicator is stable under the oxygen and temperature conditions of open-breathing transformers. The presence of methanol was detected in 94% of oil samples collected from over than 900 in-service pieces of equipment, confirming the potential for this application. Lastly, the tests have shown that oil-oxidation by-products and TU-nitrogenous agents modify the methanol partitioning coefficients in the paper/oil/air system, which makes their study essential over a range of field conditions encountered by power transformers. Results are presented and discussed in comparison with 2-furfuraldehyde, which is the current reference in the domain.     

从蓖麻油制取10-羟基癸酸的研究

本文报道了从蓖麻油制取10-羟基癸酸的研究,发现了从蓖麻油制取10-羟基癸酸的新的工艺路线和最佳的工艺条件,用氢氧化钠用量、2-辛醇量、反应时间和反应温度四因子三水平L_9(3~4)进行了正交试验,发现最佳工艺条件是:氢氧化钠(g)/蓖麻油(g):1.25:2-辛醇量(g)/蓖麻油(g):2:反应时间:6h;反应温度:180℃。在这一新的工艺路线和最佳工艺条件下,10-羟基癸酸产率可达75％。     

Decomposition of Transformer Oil Under Ultrasonic Irradiation During Degassing Process

In the degassing process of transformer oil with ultrasonic waves ,decompostition of the oil was observed.Light hydrocarbons,including methane,ethane,ethylene ,aceylene,propane etc,were found to be released continuously from the oil into headspace within a closed vial placed in an ultrasonic field ,The gases came from decomposition of hydrocarbon molecules under cavitation effect.     

Free and Glycosidically Bound Volatiles of Mentha longifolia Growing in Croatia

The glycosides of volatile compounds and the essential oil were isolated from wild Mentha longifolia. After the enzymatic hydrolysis of glycosides, fourteen volatile aglycones were identified by GC/MS. The main aglycones were eugenol, 2-phenylethanol, benzyl alcohol, lavandulol, trans- and cis-carveol, 3-octanol, and 3-hexen-1-ol. The content of aglycones was 40.85 mg kg^-1 of dried plant material. The main components of the essential oil (yield 0.93 w/w) were carvone, piperitenone oxide, limonene, and -caryophyllene. Eugenol, carveol, 3-octanol, and -terpineol were identified in the aglycones and in the essential oil.     

Enzymatic synthesis of optically active α-chloro-δ-hydroxy-β-ketoalkanephosphonates and reactions thereof

A novel and enzymatic approach to α-chloro-δ-hydroxy-β-ketoalkanephosphonates was developed via enantioselective CALB-catalyzed acetylation and CRL-catalyzed hydrolysis. The resultant optically active compounds provide, via Horner-Wadsworth-Emmons (HWE) reaction, chiral α,β-unsaturated ketones that are building block with potential application in organic synthesis.     

Classification of cultivation area of ginseng by near infrared spectroscopy and ICP-AES

A rapid and nondestructive near infrared (NIR) method using soft independent modeling of class analogy (SIMCA) for the classification of cultivation area (Korea and China) was evaluated and confirmed. Raw, first, and second derivative NIR spectra were compared to develop a robust classification rule. The chemical properties of ginseng samples were also investigated to find out the differences between Korean samples and Chinese samples. These differences make NIR spectroscopic method viable. The average value of each Korean and Chinese ginseng sample for crude fiber, crude protein, starch, and 10 inorganic constituents were measured and compared with F-test and t-test. The inorganic constituents were also measured by induced coupled plasma-atomic emission spectroscopy (ICP-AES). It could be found that the amount of starch and ten inorganic elements for example Na, Mg, P, K, Ca, Mn, Fe, Ni, Cu and Zn in ginseng samples are considerably different based on cultivation area. SIMCA has been applied to the inorganic data to investigate the possibility of ICP-AES as classification tool. However, it was observed that the result was not equal to than NIR spectra data. The overall results showed the availability of NIR method using SIMCA would be adequate for classification of cultivation of ginseng, since NIR spectra includes useful and various information on chemical properties in spite of broad and overlapped bands.     

原油三维荧光分析中猝灭现象辨析

研究了原油的三维荧光猝灭现象，指出浓度过高是原油产生荧光猝灭的主要原因，将会造成三维荧光等值线图畸变，致使定量分析数据失真，谱图特征变异，难以获取原油特征三维指纹图。提出了避免荧光猝灭的预试方法，并列出了不同类型原油的最佳测试浓度。     

Oxidation kinetics of timahdit and tarfaya moroccan oil shales

Organic matter evolution and kinetics of combustion of Tarfaya and Timahdit oil shales have been examined by thermogravimetry (TG) and by differential thermal analysis (DTA). An agreement is observed between both techniques where it was found that combustion of organic matter occurs in two steps. Kissinger's method applied on experimental results gives an activation energy of the same magnitude for the first step of both oil shales (103 kJ mol^–1) whereas the second is 148 kJ mol^–1 for Timahdit and 118 kJ mol^–1 for Tarfaya.The changes in specific surface area during thermal combustion of Timahdit and Tarfaya oil shales have been studied by thermogravimetric gas sorption balance and correlated with experimental results obtained on TG/DTA in air. For Timahdit oil shale oxidation products, specific surface areas calculated from nitrogen adsorption data shows a slight increase during the temperature domain of 280 to 430°C and after this temperature, they increase sharply. However, data obtained with Tarfaya oil shales shows a significant increase at the temperature of maximum oxidation of the first stage of combustion of organic matter.This revised version was published online in November 2005 with corrections to the Cover Date.