Use of cetyltrimethylammonium bromide as surfactant for the determination of copper and chromium in gasoline emulsions by electrothermal atomic absorption spectrometry

In this work, the use of cetyltrimethylammonium bromide as surfactant for the preparation of oil-in-water emulsions for the determination of Cu and Cr in gasoline by electrothermal atomic absorption spectrometry (ET AAS) was evaluated. The surfactant amount was tested in the range of 25 to 300 mg, added to 2 ml of gasoline, and completed to 10 mL with 0.1% (v/v) nitric acid solution. 150 mg of surfactant was found optimum, and a sonication time of 10 min sufficient to form an oil-in-water emulsion that was stable for several hours. The ET AAS temperature program was established based on pyrolysis and atomization curves. The pyrolysis temperatures were set at 700 and 1300 °C for Cu and Cr, respectively and the selected atomization temperatures were 2400 and 2500 °C. The time and temperature of the drying stage and the atomization time were experimentally tested to provide optimum conditions. The limits of detection were found to be 5 μg L^− 1 and 1.5 μg L^− 1 for Cu and Cr, respectively in the original gasoline samples. The relative standard deviation (RSD) ranged from 4 to 9% in oil-in-water emulsions spiked with 5 μg L^− 1 and 15 μg L^− 1 of each metal, respectively. Recoveries varied from 90 to 98%. The accuracy of the proposed method was tested by an alternate procedure using complete evaporation of the gasoline sample. The method was adequate for the determination of Cu and Cr in gasoline samples collected from different gas stations in Salvador, BA, Brazil.     

Optical spectroscopy of chromium doped (CH3)2NH2X(SO4)2·6H2O (X=Al, Ga) single crystals

Chromium doped (CH₃)₂NH₂Al(SO₄)₂·6H₂O (DMAAlS) and (CH₃)₂NH₂Ga(SO₄)₂·6H₂O (DMAGaS) single crystals were grown and investigated using the methods of optical spectroscopy. It was found that the Cr³⁺ ions in the two crystals are situated in a strong crystal field in which the ²E state is the lowest. The single narrow R-line associated with the ²E–⁴A₂ phosphorescence of Cr³⁺ in DMAAlS in a ferroelectric phase indicates an undistorted octahedral site, whereas important distortion of O_h symmetry and structural disorder was inferred from spectral data obtained with DMAGaS:Cr³⁺ in a low temperature phase. Results of optical investigation are discussed taking into account the structural data.     

116例冠心病患者血清中铜铬锰钴镍钒含量的探讨

测定了１１６例冠心病患者血清中铜、铬、锰、钴、镍、钒的含量并与正常值比较，显示含量升高才是有铬和镍，降低者有钴和钒、无差异者有铜和锰。     

Chromium speciation in natural waters using serially connected supported liquid membranes

A supported liquid membrane (SLM) method for the speciation of chromium has been developed. The method is based on selective extraction and enrichment of anionic Cr(VI) and cationic Cr(III) species in two serially connected SLM units. Methyltricaprylammonium chloride (Aliquat) and di-(2-ethylhexyl) phosphoric acid (DEHPA), respectively were used as the selective extractants in the membrane liquid. Graphite furnace atomic absorption spectrometry (GFAAS) was utilised for final determination. Optimised conditions for the DEHPA membrane were, sample solution at pH 3, acceptor solution 0.1 M HNO₃ and 10% w/w carrier in kerosene. The corresponding values for the Aliquat membrane were pH 7, 0.75 M HNO₃ and 6% w/w carrier in di-n-hexylether. This gave extraction efficiencies for Cr(III) and Cr(VI) of 90 and 40%, respectively. The method was used to measure the concentration of Cr III and Cr VI in surface water from an abandoned tannery site. Storage experiments at different pH showed that preservation at neutral pH gave almost constant values over a period of one month. At acidic pH (pH=3.0) the concentration of Cr(VI) decreased rapidly while the concentration of Cr(III) increased. The detection limit, expressed as three times the standard deviation of enriched blank samples was 0.01 μg l⁻¹.     

用催化动力学法由一次实验同时测定铬（Ⅲ）和铬（Ⅵ）

用H2O2氧化邻-联（二）茴香胺的反应作为指示反应可用催化动力学法经一次实验同时测定Cr（Ⅲ）和Cr（Ⅵ），但多元线性回归法不能用于此体系，因为其表现反应级数不是常数.用“速率谱”的概念可用主成分分析处理数据.实验证明对Cr（Ⅲ）和Cr（Ⅵ）的同时测定H2O2和邻-联（二）茴香胺的最佳浓度分别为0.6和6×10-3molL-1，pH为4.0.可测（1～6）×10-5molL-1的Cr（Ⅲ）和2×10-6～1×10-5mol·L-1的Cr（Ⅵ）.误差不超过10％.     

铬天青S—溴代十四烷基吡啶光度法测定微量铬(Ⅲ)的研究

在ｐＨ３．６的ＨＡｃ—ＮａＡｃ的缓冲溶液中，在加热的条件下，铬（Ⅲ）与铬天青Ｓ（ＣＡＳ）和溴代十四烷基吡啶（ＴＰＢ）形成蓝色三元络合物，其λｍａｘ在６１５ｎｍ处，摩尔吸光系数ε＝１．２６×１０５，铬的浓度在０～８．５μｇ／ｍｌ范围内符合比耳定律．用此显色反应应用于天然水、自来水、电镀排放液及合金钢中微量铬的测定，可获得了满意的效果．     

Chromium Trioxide Supported onto Wet Silica Gel: Rapid Oxidation of Alcohols to Carbonyl Compounds Under Microwave Irradiation in Solventless System

In an environmentally benign system, alcohols are rapidly oxidized to carbonyl compounds using CrO 3 supported onto wet silica gel as an oxidant under microwave irradiation.     

Microwave Thermolysis: A Rapid and Selective Method for the Cleavage of THP Ethers Using CrO 3 Supported onto Zeolite in Solventless System

Oxidative deprotection of tetrahydropyranyl ethers (THP ethers) using chromium trioxide supported onto zeolite under microwave irradiation in solvent free condition is described.     

Cathodoluminescence from deformed doped MgO crystals

The cathodoluminescence (CL) from indented Fe doped MgO single crystals has been studied with the scanning electron microscope and the results have been compared with the CL from undoped crystals. As in the undoped crystals, the iron doped crystals show in the deformed regions an enhanced luminescence emission but it has been found that iron acts as a quencher of luminescence. The results indicate that in the blue emission of the deformed crystals there is not a noticeable contribution of iron. From the evolution of CL with the irradiation time in the electron microscope it is concluded that the total Fe content influences the CL emission more than the Fe³⁺ content.     

Thermoluminescence of Chromium Doped Cd2Nb2O7 Crystals

The exposure of the Cd₂Nb₂O₇:Cr crystal to monochromatic light with wavelength shorter than 600 nm at 12 K decreases the Cr^3? photoluminescence emission and allows us to observe thermoluminescence within 60–200 K during subsequent heating of the crystal at a rate of 0.077 K/s. The glow curve of thermoluminescence revealed a rather complex structure with two pronounced intensive glow peaks at 91 and 180 K and four rather weak peaks at 99, 117, 132, and 155K. An analysis of the glow peaks by “an initial rise” gave evidence of many various charge carrier traps with activation energies from 150 to 470 meV. Since a comparison of the thermoluminescence and photoluminescence emission spectra showed that these spectra are identical, it was concluded that the thermoluminescence glow peaks are associated with thermal release of charge carriers from shallow traps followed by Cr^4?→Cr^3?(²E) and/or Cr^2?→Cr^3?(²E) charge capture and ²E→⁴A₂ radiative decay of Cr^3?(²E) ions.